Question about 1994 Jeep Grand Cherokee

Open Question

Can I use Bosch KTS on Jeep Grand Cherokee 1994 5,2 if I do not have OBD?

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 6982 Answers

SOURCE: 1995 jeep grand cherokee wont start

Code 11 is related to the crankshaft sensor. This is a common failure.
Sensor is located on bellhousing on drivers side, even with the flywheel. Your symptom can also be related to a fuel problem which usually will set no codes or incorrect codes related to emissions etc.
I would go with the CPS at this point though. Fuel filter should be serviced at least once a year. Regardless of the outcome I would change it as a maintenence item.
good luck

Posted on Jan 13, 2009

Ad
tepfy
  • 319 Answers

SOURCE: No horn in '94 Jeep Grand Cherokee

go to the horn under your hood, check it for any thing wrong, then follow the power wire and follow it back to your steering wheal. this is where your problem is you just have to find out where the short is. and fix it.

tepfy

Posted on May 01, 2009

  • 1 Answer

SOURCE: 1994 Grand Cherokee Jeep wont start

It is likely one of your battery cables loose. Same thing just happened to me today. What you need to do is first lock the doors, and close them. Then you need to disconnect, and reconnect the battery cable, then if the security lights still blink you must use your key to unlock the door, then it should stop blinking, and start just fine.

Posted on Jun 02, 2009

kd6rhd56
  • 400 Answers

SOURCE: Where's the OBD hookup on a 1995 Jeep grand

I have a 1998 jeep grand Cherokee too and the OBD connector is located on the left side under the dash rt above the Brake pedal and just to the left of the floor light.

Posted on Jul 11, 2009

rtjohnson55
  • 75 Answers

SOURCE: P0456 OBD code just appeared on a 2004 Jeep Grand

That code definition is (evaporative system small leak detected). One of the most common reasons for this code is a faulty gas cap. The evap system is strictly designed to trap fuel vapors in the tank and not allow them to scape into the atmosphere. The vehicle keeps a constant vacume on the tank and when it is unable to hold that pressure it will set the code you have. Try buying a new gas cap-thats a cheap start-clear the code and see what happens. If the light comes back on you will have to bring it to a repair shop where they will tap into the Evap system and force smoke into it. They will then observe the Evap hoses and wherever it leaks smoke will be your problem.

Posted on Dec 03, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Radiator change 1994 cherokee


    images for Radiator change 1994 cherokee


    More images for Radiator change 1994 cherokee

    Radiator. Replacement - Jeep Cherokee Forum

    www.cherokeeforum.com > Technical Discussion > OEM Cherokee Tech
    Nov 2, 2010 - Jeep Cherokee XJ 1984 to 1996 How to Replace Radiator .... 1994 JeepCherokee 4x4 5 speed 4.0 H.O. flex headers, Flowmaster cat back, ... Changing out lower radiator hose...
    Jul 6, 2011
    Replacing Radiator
    Apr 8, 2011
    RAdiator removal question
    Feb 19, 2011
    Replacing radiator on 1996 Cherokee
    May 19, 2010
    More results from www.cherokeeforum.com

    93 jeep grand cherokee(4.0) radiator needs to be replaced ...

    www.jeepforum.com > ... > ZJ Grand Cherokee Forum

    Sep 23, 2007 - 12 posts - ‎9 authors
    Remove the top radiator bracket and the whole thing will slide out. IF you have .... What I Have: 1994 Grand Cherokee Limited 2.25" 4 Wheel ...

Jan 23, 2016 | 1994 Jeep Grand Cherokee

1 Answer

Obd codes for 1998 jeep grand cherokee


Just put the question into google


1998 jeep cherokee OBD2 Codes

Feb 01, 2013 | 1998 Jeep Grand Cherokee

1 Answer

What are the OBD codes for 1994 Jeep Grand Cherokee 4.0


OBD Codes can be read turn therre times ON/OFF ignition key (without start engine)... read light sequence and note... Read the Check Engine Codes

Hope this helps; also keep in mind that your feedback is important and I'll appreciate your time and consideration if you leave some testimonial comment about this answer.

Thank you for using Fixya, and have a nice day.

Nov 19, 2011 | 1994 Jeep Grand Cherokee

1 Answer

Where do u locate codes for 1994 jeep grand cherokee limited


OBD Codes can be read turn therre times ON/OFF ignition key (without start engine)... read light sequence and note... Read the Check Engine Codes

Hope this helps (remember to rate this free answer).

Oct 01, 2011 | 1994 Jeep Grand Cherokee

1 Answer

I cant find the obd plug in on my 94 jeep grand cherokee laredo and my jeep will turn over but is hard to start what would cause this?


It does not have an obd11 connector, it's too old. The extended crank time could be a couple of things though. I've seen problems with fuel pumps, fuel pump relays and crankshaft sensors. How many miles on it? Has the fuel pump or filter been changed before?

Apr 03, 2011 | 1994 Jeep Grand Cherokee

1 Answer

Can i put the motor from a 97 or 98 grand cherokee into a 94


No, 1995 and earlier. 1994 has OBD 1 and the 1997-98 has OBD II.

Jun 10, 2010 | 1997 Jeep Grand Cherokee

1 Answer

I need the firing order for a 1994 Jeep Grand Cherokee Straight 6 engine


For 1994 Jeep Grand Cherokee:
2WD and 4WD have the same
4.0L In-Line 6-Cylinder:
Firing Order:

1-5-3-6-2-4
Cylinders:
(back)
...6
...5
...4
...3
...2
...1
(front)

Distributor:
....(back)
.....5....3..(+)-screw
1.............6
(+).4....2

Let me know if this helped, or if you have additional information or questions. Feel Free to contact me at FixYa.com!

May 20, 2010 | 1994 Jeep Grand Cherokee

1 Answer

1994 Grand Cherokee: I have a code 11,12 and 25 on my 1994 jeep grand c...


http://allpar.com/fix/80s-codes.html has the trouble codes.

May 18, 2010 | 1994 Jeep Grand Cherokee

1 Answer

I am putting a 1994 transmission into my 1996 jeep cherokee and I have 1 plug that is posed to be like a 10 prong plug but on the 94 it is a 3 prong plug. Do they make adpters for that or what should I do?


I hate to be the bearer of bad news, but that transmission from the 94 won't work in a 96. Probably because the 94 was for a Jeep with OBD I and your 96 has OBD II. I checked my used parts site and all that will fit is a transmission from a 96, maybe a 97.

Mar 13, 2010 | 1996 Jeep Grand Cherokee

Not finding what you are looking for?
1994 Jeep Grand Cherokee Logo

Related Topics:

37 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...