Question about 1987 Honda Accord

1 Answer

How much should it cost to have a stater installed

I have power to thee whole car it turns on but doest even try to turn over

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Expert
  • 192 Answers

If you have full power to the car and lights dont dim, etc. then you have a charged battery and alternator. Honda's are high compression engines and take a strong starter to turn the motor over. If you are putting key in and turnign to CRANK and you get no response, the power doesnt dim, and the lights dont dim when doing this then your power system is fine its a bad starter. The starter for your motor (assuming auto trans) can be found at http://www.partsgeek.com/gbproducts/WC/5969-01024291.html?utm_source=google&utm_medium=ff&utm_term=1986-1989+Honda+Accord+Starter+Bosch+86-89+Honda+Starter&utm_content=YN&utm_campaign=PartsGeek+Google+Base

If you are a handy DIY person you can do this change yourself. The starter is On the transmission. You should be able to see it if you open the hood and look at the transmission. It's held on by two or three bolts, has a couple wires going to it, and looks about the size of a large can of soda.

  • unhook the battery cables, starting with the negative first. and remove the air pipe
  • unhook the two wires coming off the starter
  • remove the two nuts holding the old starter in, and pull the starter
  • insert and bolt in the new starter
  • connect the two wires to the new starter, reinstall the air pipe, and hook the battery back up positive first and negative last. Make sure everything is torqued down good on battery and alternator and you dont see any corrosion, bad wires, etc. This shoudl do the trick
  • Posted on Jun 07, 2010

    Ad

    1 Suggested Answer

    6ya6ya
    • 2 Answers

    SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

    Hi,
    a 6ya expert can help you resolve that issue over the phone in a minute or two.
    Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
    New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
    click here to download the app (for users in the US for now) and get all the help you need.
    Goodluck!

    Posted on Jan 02, 2017

    Ad

    Add Your Answer

    Uploading: 0%

    my-video-file.mp4

    Complete. Click "Add" to insert your video. Add

    ×

    Loading...
    Loading...

    Related Questions:

    2 Answers

    Starter will not turn on 94 buick centruy 3.1 but got new batt new starter new pos and neg wire ran and still nothing. I can start the car by crossing the started cylinoid but the key has no effect other...


    I checked the small wire and have power ???? What small wire ? The wire on the starter solenoid has B+ voltage when turning the key to start position ? If so and your engine isn't spinning over ,your engine is seized up. Try put a socket an breaker bar on the crankshaft bolt an try turning it by hand .

    Aug 05, 2017 | Cars & Trucks

    1 Answer

    Battery fully charged but car wont even begin to turn over


    Have you checked the stater to see if you have power from the neutral safety switch ?
    Is the security warning light on ?

    Aug 29, 2013 | 2003 Saturn L-Series

    1 Answer

    My 1992 chevy caprice wont start i put the key in and its doest turn i tried to turn the stearing wheel while i tried to turn the key and it still wont move


    Try this-remove the battery and plug, then push and hold the power button for 30 seconds. This should reset the power.


    ----------------Multi-Di@g Access J2534

    Nov 27, 2012 | Cars & Trucks

    1 Answer

    New stater, stater still makes clicking sound


    First you should check to make sure the engine is not locked up by turning it over manually. If you can turn the engine manually, then check your battery terminal ends to make sure you have good, clean and tight connections. Typically, a faulty electrical connection is the main culprit that will cause your situation. If you still suspect a faulty connection, try having someone turn the ignition key while you wiggle the battery cables to see if it will try to start. This should help you narrow down the problem area.

    Sep 02, 2012 | 2003 Mitsubishi Galant

    1 Answer

    The car has a new fully charged battery ,yet it will not start even though the starter has power and the electronics work, and there isn't even any noise comming from the starter


    If the starter has voltage at the solenoid on the starter when turning the key to start,then it is the stater,if it is 12 volts.If this was helpful,please rate,thank you.

    Jun 30, 2010 | 1988 Jaguar XJ6

    1 Answer

    Battery is dead in 2000 clk430 mer.b. trunk will not open. batte


    hello,try to look your stater motor,big cable connected to battery,you can install your cable to have power, only for opening your trunk,charge your bsattery outside,ty

    Apr 20, 2009 | 2000 Mercedes-Benz S-Class

    1 Answer

    Full power won't jump nothing happens when I turn the key


    Sounds like the starter has failed. Have someone turn the ignition while you tap on the starter with a hammer. If it starts, that confirms starter. If it still doesn;t start, remove the stater and have it bench tested at a parts store.

    Apr 08, 2009 | 1998 Dodge Stratus

    1 Answer

    The Radio don't work and speedometer needles stater


    Unfortunately my instrument panel did the same then the tach stopped working and gas needle became stuck...I had to get a new instrument cluster which set me back $700.00 including labor(Miami, FL)...NOTE...the odometer's computer is on the cluster and the odometer's reading has to be downloaded to the new instrument cluster.

    Apr 03, 2009 | 2004 Scion xB

    1 Answer

    Toyota starter problrm


    NEED TO REPLACE STARTER.

    Mar 03, 2009 | 1996 Toyota T100

    1 Answer

    Snowmobile cuts out one cylinder sometimes


    I would suspect the igniter is defective or possibly the coil.

    May 17, 2017 | 1991 Mazda Protege

    Not finding what you are looking for?
    Cars & Trucks Logo

    130 people viewed this question

    Ask a Question

    Usually answered in minutes!

    Top Honda Experts

    yadayada
    yadayada

    Level 3 Expert

    76630 Answers

    Colin Stickland
    Colin Stickland

    Level 3 Expert

    22219 Answers

    Kevin Daniels

    Level 3 Expert

    1455 Answers

    Are you a Honda Expert? Answer questions, earn points and help others

    Answer questions

    Manuals & User Guides

    Loading...