Question about 2000 Nissan Xterra

2 Answers

Doors lock and unlock when not even around car

Doors lock and unlock when not even around car with keys without provocation horn honks when i use remote and keys and sometimes unable to disarm has locked me out alot of times

Posted by on

2 Answers

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 3 Answers

Try not carrying your remote in your pocket. To turn off the honk, hold the lock and unlock buttons simultaneously for at least 2 seconds.

Posted on Aug 04, 2010

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 4,793 Answers

Try changing the batteries in the remote.....

Posted on Jun 07, 2010

4 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 383 Answers

SOURCE: Several months ago I began experiencing a

jimmy: it sounds like the drivers door unlock tamper switch or the other switch may have failed. One side can affect the other under certain circumstances. Your trunk lock also has a switch which arms and disarms the antitheft system. Try locking all the doors, make sure the hood and trunk lid are closed and then open the trunk. Leave it open open the drivers door and try to start the car.
If it's a no start. Disconnect the ground battery cable then put the ignition key in the run position in you ignition switch. Reconnect the battery and try to start the car. It should start. This usually will override the anti theft system. One issue with this will be, whether the antitheft system will remain disarmed.
Although I have never tried this before, I know that the system will not arm unless all the doors, trunk and the hood are closed.
I could suggest this to try if the car starts as I had told you pertaining to disconnecting the battery cable, I would take the switch and unbolt it from the passenger's side of the engine compartment just forward of the shock tower. Just let it sit somewhere so it doesn't get caught up in anything moving. If there is a light under the hood of your car, remove the bulb.
Let me know how you make out.

Posted on May 03, 2009

  • 1 Answer

SOURCE: horn wont honk when doors locked using remote.

If you have a factory remote and the owners manuel there is a solution in the manuel. It tells you how long to hold down the lock button on the remote to reset it so the horn toots when you lock the doors. I do believe it to be 2 seconds or more. So you would lock the doors using the remote and don't let go of the button for at least 2 seconds. Hope this helped.

Posted on Feb 23, 2011

hayder_jalal
  • 2 Answers

SOURCE: Keyless remote locks the doors but the horn doesn't honk.

Your lock settings were most probably changed from your remote unit. By pressing both lock and unlock keys together for around two to three seconds you can switch between silent mode and horn mode. Hooe that helps...

Posted on Aug 12, 2012

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Reset key fob


Unlock all doors, foot on brake, all doors closed. Cycle key quickly but carefully on-off appr 10 times until the car honks one time.

Do not turn the key far enough to start the car, just to the 'on' position so the dashboard lights up.

When the horn honks, open and close the driver's door, press any remote button and that's it.

Program another remote? Quickly open and close the driver's door again and push a button on the 2nd remote. That's it.

When you're done, remove the key and the horn should honk 3 times. You're all set.
Sometime it takes more than 10 on-offs to set program mode. Open/close the door, lock/unlock etc, wait 10 minutes, then try again

Jul 22, 2014 | Subaru Outback Cars & Trucks

1 Answer

Horn honks when unlocking doors.


If your vehicle is equipped with a factory keyless entry system and you have the owner's manual, there should be a section in the manual describing how to change your options with your system. But if you have an aftermarket system, which I am thinking this the case, you will have to manually go into your dash under your steering wheel and cut the wire going to your horn from the security system. Once you have accessed your wiring underneath your steering wheel, there is a main harness with a bunch of wires going to the steering wheel. In this harness you will find a DARK GREEN/VIOLET small gauge wire and you should see another wire tapping into it probably coming from the security module. Just cut it off but leave the DARK GREEN/VIOLET untouched and this will eliminate the horn honks.

Jun 26, 2012 | 2008 Chrysler Pt Cruiser

1 Answer

Horn randomly honks(very annoying while your trying to sleep) HELP!


its possible that the relay is the problem as most relays have a second power feed wire,if it shorts to the horn side of the relay it can blow the horn.doesn`t happen very often but it does happen.this could explain the horn blowing without the fuse in.you can get a door key made at a lock smith to solve that problem.

Nov 17, 2011 | 1994 Buick LeSabre

1 Answer

I bought a new Keyless remote for a 2007 Forester from a Subaru Dealer to replace an original one that went bad after 2 years. I have followed the directions in the owner's manual to program it, but can't...


IMPREZA: 2005, 2006, 2007 and
FORESTER: 2005, 2006, 2007, 2008
Check for Immobilizer key on Forester XT models only.
information is always subject to change and correction imp05keylessremote1.jpg
new remote for 2005 Imprezas.
This is not the same remote as the 05 Legacy/Outback remote which also has truck/gate release on the front and a red panic button on the back.
Lock: press Lock button for 2 seconds or so to lock car, and arm optional security system. The car with chirp once and turn signals flash for locked, 5 short chirps and signal flashes if any door is not fully closed. The dome light goes on for 15 seconds and ignition key ring (if present) will light for 30 seconds when unlocked.
Unlock: press unlock one time for driver's door, press again within 5 seconds to unlock all doors inkling rear gate (wagon). The system does not open the trunk.
Panic mode: press and hold lock button for approx. 3-4 seconds to activate Panic mode. I panic model the horn honks and turn signals flash until either the lock or unlock button is pushed again.
Finder mode: Press lock button 3 times within 5 seconds to activate Vehicle Finder mode. The horn will honk once and the turn signals will flash 3 times
Distance: works within approx. 30 feet depending on battery strength, nearby concrete walls and etc.
Audible Chirp On-Off: the system will chirp when locked or unlocked. To turn OFF the chirps, unlock the door and then push both lock and unlock buttons at the exact same time for 2+ seconds. There will be 2 chirps indicating the the audible is off. To turn the chirp back on, repeat the process and the system will chirp one time when it is back on.
Battery: as the battery ages it will only work as you get closer to the car. When a battery is replaced, the transmitter must be re-synchronized with the Keyless control unit. To synchronize, press the lock or unlock button 6 times.
Programming: 4 codes may be programmed.
Sit in driver's seat and unlock all doors. Open and close the driver's door
Turn the ignition key from LOCK to ON position 10 times within 15 seconds. Be sure to stop at both lock and on. The horn will HONK once to indicate transmitter programming mode is activated. Leave key in LOCK position and don't remove it from ignition.
You now have 45 seconds to complete the programming as below.
Open and close driver's door again.
Push either lock or unlock button on the remote you want to program. The horn will honk 2 times when successful.
To continue and program other remotes at the same time: open and close the driver's door and push lock or unlock on the remote. The driver's door must be opened and closed between each remote you want to program.
Done programming? remove the key from the ignition and the horn will honk 3 times.
DELETE old codes? Reprogram 4 times, it will overwrite old codes.
Alarm Security System: optional on all models. When locked there is one chirp (can be turned off, see above), the turn signals will flash and the red 'security' light will start to flash once every 2 seconds except for STi which flashes twice every 2 seconds.
There will be 5 chirps if a door, hood, and trunk or gate is not fully closed
You can also arm the system by using the power lock button on the driver or passenger door as you get out of the car and then closing the door behind you.
Disarm the system: push unlock for 2 seconds
Lost remote, alarm activated? When you can't use a remote to turn off the system: open the door with a key or try to start the car and the horn will start to honk. Turn the key on-off 3 times within 5 seconds and the alarm will go off and you can start the car. It's simple!
VALET mode: To set valet mode or just to disable the security alarm system: 1. unlock all doors 2. physically open the driver's door 3. hold the UNLOCK button on remote for 2+ seconds. The red 'security' light will then flash 2 times a second until the car is turned on.
System has been Tripped (except for STi): if you unlock the door with the remote and it chirps the signal light flash 4 times, the system has been triggered;
Identification mode: To find out what happened and why the system was triggered:
Open and drivers door, leave it open. Turn ignition key from LOCK to ON 2 times and then leave in LOCK position.
Tripped code: 1 security light flash: a door has been opened, 3 flashes when the impact sensor was triggered, 4 flashes when the ignition was messed with or battery disconnected

Nov 19, 2009 | 2007 Subaru Forester 2.5X L.L. Bean...

2 Answers

Keyless remote locks the doors but the horn doesn't honk.


Your lock settings were most probably changed from your remote unit. By pressing both lock and unlock keys together for around two to three seconds you can switch between silent mode and horn mode. Hooe that helps...

Sep 16, 2009 | 2002 Nissan Altima

1 Answer

My 92 Buick horn won't honk ever even when you lock the doors and try to open them without unlocking them --it never honks. What can I do?


I would first try pulling fuses to see if it is bad there. If not, you can try to run wires directly from the battery to the horn to see it it can honk. Disconnect it from the circuitry and then just touch the wires to the terminals.

Jul 16, 2009 | 1992 Buick Park Avenue

1 Answer

How do i enable factory alarm system without keychain remote?


The Simple Act of Locking the Driver side Door WITH KEY Arm the Factory Alarm. And UNLOCKING Same Door with KEY Disarms it The FOB < Rmote for Alarm Just Honks Horn and Flashes Lights, But it Does the SAME ARMIND & DISARMING. I Hope this Helps You out !!

Jun 15, 2009 | 2000 Pontiac Bonneville

2 Answers

Set the combination lock on the driver door of 1999 Ford Explorer


check your car manuel and it should tell you to solve both

Jun 09, 2009 | 1999 Ford Explorer

Not finding what you are looking for?
2000 Nissan Xterra Logo

284 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

75077 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

705 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...