Question about 2001 Dodge Stratus

2 Answers

Windshield jet washers are clogged, how can I reopened again? Do I should take out the hood liner? It has fasteners that I don't know to uninstall and reinstall again later. I will appreciate your advise.

Posted by on

2 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 10,319 Answers

These nozzles are replaceable purchased at any chrysler dealership
cleaning them is not recomended

Posted on Jun 07, 2010

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Governor:

    An expert whose answer got voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 143 Answers

If your not going to take them out,compressed air may blow them out try from the bottle and in from the outlet of the washers

Posted on Jun 07, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My washer fluid won't spray.


Make sure the container is full.
Stand very near the container and have someone attempt to use the washer spray and listen for the sound of the pump to make sure it's working.
If not working, either blown fuse or faulty washer pump.

If it is making noise, you can look on the underside of the hood near the windshield for the washer hoses where they go into the hood.
Carefully pull a hose off and try the sprayer again.

If you get water pumping out, the clog is at the hood nozzles. That can usually be cleared out with a thin sewing needle or a single piece of wire cut off a large wire brush.

If no water came out of the hose you removed, you will need to remove the washer fluid reservoir (large bottle, usually hidden pretty deep into the fender/bumper and drain it, then check for clogs at the washer pump screen.

Dec 29, 2016 | Cars & Trucks

1 Answer

Headlight gap cover installation


the item you are talking about is the cover for the headlamp washer jet has it got headlamp wash? if so the washer jet has fallen off the headlamp and dropped in the bumper liner, the cover clips on to end of jet if it does not have headlamp wash the cover has 2 clips one on each side but they break and fall off in that case we use epoxy glue to refit it

Feb 20, 2014 | 1997 Jaguar XK8

1 Answer

Windshield washer clogged on 2011 Ford Fusion Hybrid


Have you tried pole a piece of wire like off a wire brush into the hole? I know it sounds silly, but most times what clogs the outlets is wax when you wax the car.

Dec 07, 2013 | 2011 Ford Fusion Hybrid

1 Answer

Front windshield washer is not pumping to spray windows need to replace unsure how to get to it Sante Fe 2004


I presume you've check the fluid level in the washer resevior? This particular problem is common. The inlet opening to the pump is clogged by slime. We usually 'unclog' the obstruction using compressed air. The resevior (tank) needs to be removed and flushed/cleaned out. It can be accessed under the RH wheel well liner. There are 2 10mm bolts fastening the tank to the vehicle. remove those bolts. Then disconnect the hoses (one for front, the other for rear wiper/wash). Disconnect the electrical connector to the pump. You can now remove the resevior (tank) from the vehicle and flush/clean it.

Jun 29, 2011 | Hyundai Santa Fe Cars & Trucks

1 Answer

Windshield washer fluid hose has become disconnected


open the hood on the car and you will see the hose has come off on the hood to the washer jets. recconnect it and put a little duct tape around the plastic connector to keep it from comming apart again.

Nov 30, 2010 | 2002 Jaguar X-Type

1 Answer

Windshield washer jets on my 92 Honda accord do not shoot windshield fluid out.


I would check the supply hoses to hood. I would also check the washer pump in the washer fluid bottle.

Nov 15, 2010 | Honda Accord Cars & Trucks

1 Answer

Where is the windshield washer pump on a 1995 olds Aurora?


It is located under the passenger side front fender. You have to remove the "wheel well" liner to access the pump. It is not a costly item and is carried by NAPA. Getting to it is the work. Jack the car up on right front side---remove wheel and then remove wheel well liner . It involves some phillips head screws along with some plastic fasteners.

Oct 15, 2010 | 1995 Oldsmobile Aurora

2 Answers

My windshield washer pump works,but no fluid on


Those little nubs on your hood or the spray jets on the wipers those spray jets need to be adjusted and be pointed up you can use a sewing needle just don't jam them or break them.

Jan 15, 2010 | 1995 Buick Regal

1 Answer

Front windshield washer won't squirt


Sometimes it's as simple as clogged jets where the solution comes out. I would take a fine needle or pin and insert it into the hole where the solution comes out to see if it frees it up enough to squirt first. They sometimes get clogged with salt or dirt.

jackiaria

Mar 24, 2009 | 1997 Plymouth Grand Voyager

1 Answer

Screen washers(front and rear) not working


Quick test since you can hear pumps running: Open hood. Look for a rubber hose going up from engine compartment to underside of hood. This should split somewhere if there are two washer jets on your hood, or else they go to your wipers and squirt directly off them, right? There will be a spot close to where this hose leaves the eng. comp. and joins with the hood that uses a splice connector. You can disconnect the hose here with some wiggling, and hit the squirters again to see if water is at least coming out of this primary hose. Yes? Good then the clog is at the jet end, or squirter end. Use a tiny piece of wire, like a bread tie without the insulation, and poke into the hole of the jet and try to clear out the dirt, or mineral deposit, dried soap scum, whatever. Now squirt again. Should start to clear out, or use compressed air and blow through jet. If your clog is not at the squirting end, follow the hose down to the little pump at the side/bottom of your juice bottle. GOod luck, and don't use too much additive, it clogs easier. Also don't use tap water if you get a lot of scale from hard water. THis will clog, too. Good Luck, TT

Feb 11, 2009 | Ford Focus Cars & Trucks

Not finding what you are looking for?
2001 Dodge Stratus Logo

Related Topics:

111 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8202 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...