Question about 1991 Dodge Stealth

Open Question

How to install a racing chip into a dodge stealth

Posted by on


2 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

  • 5 Answers

SOURCE: 91 dodge stealth will start and stop. Changed the

Have you checked or replaced the fuel filter? Sometimes that can be the problem as well because your fuel filter could be clogged.

Posted on Jan 28, 2010


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

What size fuse for a 1993 dodge stealth starter relay located fuse box

The starter relay in a 1993 Dodge Stealth has no fuse of its own. The starter relay is powered directly from the BLACK/YELLOW wire coming from the ignition switch.

Jan 04, 2012 | 1993 Dodge Stealth

2 Answers

1993 Dodge Stealth Twin Turbo and it has faulted a brand new ignition module

need new switch. if key has a chip switch needs to be relaerd to the pcm dy dealer or someone with the software

May 17, 2011 | 1993 Dodge Stealth

1 Answer

My 1991 Dodge stealth is overheating. I have a new radiator and thermostat installed.. No fluid is leaking and my fans are working. It typicaly runs hot when im sitting still or start traveling long...

Hello Guest and thank you for asking your question, on Fixya.

Here is a simple process that will walk you through a few steps that will pinpoint the overheating problem on your 1991 Dodge Stealth, without even using any tools. It has helped millions of people, and I am certain that it will help you, because I wrote it for people like you. So here is the link:
How to diagnose your overheating 1991 Dodge Stealth

Get more great, money saving, tips and tricks about your vehicle from:

Thanks for the vote, and good luck!

Jul 13, 2010 | 1991 Dodge Stealth

1 Answer

I lost my keys to my 1993 dodge stealth , i do not have another set of keys. Where can i get another set ?

did your key have the chip inside, if not, you can go to your local Dodge dealership with you VIN# and they can look up the vehicle, cut you a key on the spot. They may say they can't but it can be done.

Apr 13, 2010 | 1992 Dodge Stealth

1 Answer

I have a 1992 dodge stealth base and i hooked up a chip to the mass air flow sensor but i didnt wrap the wires up after installing the chip the car shut off when i shut my hood and grounded the wires out.....

You may have actually damaged the MAF sensor itself. Inside the mass airflow sensor are a couple of very delicate resistors which can almost immediately be ruined if the wires get shorted to ground while the ignition key is turned on.

Feb 25, 2010 | 1991 Dodge Stealth

1 Answer

91 dodge stealth will start and stop. Changed the fuel pump and computer chip. Now what?

Have you checked or replaced the fuel filter? Sometimes that can be the problem as well because your fuel filter could be clogged.

Jan 28, 2010 | 1991 Dodge Stealth

2 Answers

Why wont my 91 dodge stealth have fire

Given the history of this product (early 1990 Mitsubishi products) I expect it is the engine ECU, located behind the radio. You'll need to remove the two pieces of carpet trim/panel off of the tunnel, pop off the plastic caps (one on each side) and remove the phillips head screw. The trim now loose will in-hook from a point near the fire-wall and then back by the shifter. Looking behind the dash in the middle the ECU will sit vertically and the (3) yellow electrical plugs within it, unplug these and remove the three bolts/screws holding it in place (if my memeory serves they are No. 10 metric) Note the MD number on the ECU this is important as you must keep this common with the replacement. The death of these ECUs are the (3) capaciors within them. If you like you can open up the ECU and look for these; under them you might notice a thick grease like substance, this is the failure of a leaking capacitor. It is possible for you to replace these capacitors (must be done with care) If you purchase a rebuilt unit the
new capacitors are of better quality and less prone to leaking.

The attached link should assist.

I hope this may have assisted you,

Oct 16, 2009 | 1991 Dodge Stealth

1 Answer

I need to install an alarm on my 1994 dodge stealth but can not find the insturctions

most alarm companys have wiering diagrams on their website or you can go to, they have moste wireing diagrams for cars

Jul 26, 2008 | 1991 Dodge Stealth

Not finding what you are looking for?
1991 Dodge Stealth Logo

Related Topics:

34 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts


Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8273 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides