Question about 1997 Mercury Sable

1 Answer

I am trying to sifen old gas out of 1997 Mercury Sable that has been sitting for 3years to replace gas befor trying to start. I have a hose small enough to fit down fill pipe but stop befor entering tank?

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 2,317 Answers

There is a flap in the filler tube that won't allow a hose into the tank. I would disconnect the fuel line and jump the fuel pump relay and run the pump to drain the gas.

Posted on Jun 07, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My key won't turn to start my car... It's a 92 Sable Mercury.


Try a lubricant.

Mercury Sable key ? Mile High Locksmith ™

www.denver-locksmith.net/2013/12/mercury-sable-key-replacement/
Dec 23, 2013 - Mercury Sable keys have changed over the years. ... 1991, 1992, 1993, 1994, or 1995, then your car requires two keys. ... If your Mercury Sable was made in the year 1997, then some of the cars will have a transponder key, and some won't. ...Insert the new key into your ignition switch and turn it to the on .

Sep 08, 2015 | Mercury Sable Cars & Trucks

1 Answer

1997 murcury sable runs good but when i shut it off it stalls out unless it sits for a few hours


Check fuel pressure at motor with a gauge
& see if it holds

I think the fuel pump has failed,maybe

Dec 15, 2012 | 1997 Mercury Sable

1 Answer

I have a 1997 mercury sable with a dual over head cam. I need the hose replaced that runs off the water pump. what is this hose called?


  • Lower radiator hose.
  • The one that runs from the thermostat is the upper radiator hose.

  • Hope this helps. Thank you for using FixYa.

Regards, Tony

Jul 13, 2011 | Mercury Sable Cars & Trucks

1 Answer

Bought a 1997 mercury sable today, guy said it needed a starter, charged dead battery and replaced starter. It fired right up, was driving it home it died, oil light, battery light, and check engine light...


Try checking the altenator. If the starter and battery were gimpy, the altenator may have a blown regulator too!. It sounds like there is a short in the system causing this problem. Most likely the altenator or component in the charging loop. WF

Sep 15, 2010 | 1997 Mercury Sable

2 Answers

Broken coolant line.


I'm not sure if you can buy just that piece, it's recomended that you replace the entire heater hose assembly.
For reference the NAPA p/n is BK 8155114 go to thier web site and verify this is the part you're needing to replace.
You should flush and replace the coolant if it old.
Hope this help you with your problem.

Jun 10, 2010 | 1997 Mercury Sable

2 Answers

Where is the thermostat location on my 1997 mercury sable?


Follow the upper radiator hose to the engine to where it's held on with the hose clamp. The hose is clamped to the thermostat housing. Remove that housing to reveal the thermostat.


Feb 26, 2010 | 1997 Mercury Sable

1 Answer

1997 mercury sable won't start


sounds like a fuel delivery problem, did you run it out of gas? this can trip a reset switch that shuts down the fuel pump

Mar 30, 2009 | 1997 Mercury Sable

1 Answer

Heater doesn't work


Sounds like the heater core is stopped up. Try removing the heater hoses and backflushing the core.If this doesn't work replace the core.

Nov 22, 2008 | 1997 Mercury Sable

Not finding what you are looking for?
1997 Mercury Sable Logo

315 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mercury Experts

yadayada
yadayada

Level 3 Expert

77499 Answers

fordexpert

Level 3 Expert

5613 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Are you a Mercury Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...