Question about 2000 Chevrolet Venture

1 Answer

Cant remove the alternator - 2000 Chevrolet Venture

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Brigadier General:

    An expert that has over 10,000 points.

  • Master
  • 4,669 Answers

There is a trick to this. Put a jack under the front of the sub-frame. Then remove the two front sub-frame bolts. Then let the front of the sub-frame down until you get just enough room to pull the alternator over the top of the intake.

Posted on Jun 07, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

3 Answers

Alternator removal


it does come out the bottom, remove the tire, and inner fender splash shield, and it will come out through there.

Mar 03, 2015 | 2003 Chrysler PT Cruiser

1 Answer

Do you remove belt when removing alternator


Hi:

To remove the belt, you must loosen the belt tensioner pretty far.
It is located up near the front of the engine, not far from the air conditioning compressor. It has a 10mm bolt that must be loosened, and that will allow the belt to be removed. After the Alternator is replaced, tighten the belt back up, and start the car , shut it back down and adjust the belt as needed.

Mar 22, 2014 | 1998 Honda Civic

2 Answers

Cant find the alternator in my 2002 lincoln ls


3.0L lower front of engine passenger side above splash panel. 3.9L top front of engine under engine cover

Jan 21, 2011 | 2002 Lincoln LS

1 Answer

Does anyone knows how to remove the alternator i


  1. Disconnect the battery ground cable, then disengage the alternator drive belt from the alternator pulley.
  2. Raise and support the vehicle, then remove the righthand wheel and tire.
  3. Remove the righthand outer tie rod end from righthand spindle.
  4. Remove exhaust system Y pipe as follows:
    1. Remove the front and rear Y pipe flange fasteners from the exhaust manifolds.
    2. Remove the stud bolt and nut retainer from the oil pan, then remove the two remaining nuts and bolts from U pipe outlet connection.
    3. Discard the exhaust converter inlet gasket, then remove the Y pipe.
  1. Disconnect wire harness attachments to integral alternator/voltage regulator, then remove the alternator brace bolts from the alternator.
  2. Remove the righthand halfshaft.
  3. Remove the alternator bolts from bracket, then rotate the alternator and remove it through the righthand side of the vehicle.
  4. Remove the bracket bolts and bracket from the cylinder block.
  5. Reverse the procedure to install, noting the following:
    1. Torque the alternator bracket bolts to 15-22 ft lb.
    2. Torque the alternator bolts to 29-40 ft lb.
    3. Torque the alternator brace bolts to 15-22 ft lb.
    4. Torque the output terminal nut to 6.7-8.1 ft lb.

Sep 17, 2009 | 1996 Ford Contour

1 Answer

Porsche boxster alternator belt


some porsches adjust belt tension by adding or removing shims between the two pulley halfs.take the nut off the pulley insert the belt put thebelt,outer pulley and nut back on.

Jul 05, 2009 | 2001 Porsche Boxster

1 Answer

Have a 98 ford windstar already have copressor loose but cant get it out any ideas?


Remove the alternator.Remove the alternator bracket,the compressor will come out. Good luck.

Jun 26, 2009 | Ford Windstar Cars & Trucks

1 Answer

How do i remove the alternator from a 97 saab 900


You do not have to remove the wheel unless you have th 6 cylinder engine (2.3l). Then yes you do:

Disconnect Negative Battery Cable
Remove the air cleaner and hose from between the air breather/cleaner and throttle housing
Relax the belt tensioner off the belt and pry off the belt
Remove the right front wheel, black belt cover/protector, and the wheel hub nut and slide the hub off the drive shaft/outer Cv joint
Disconnect the alternator, remove the alternator/air intake hose, 2 bolts that hold the alternator in and remove it through right-hand wheel housing.

Yes, this is immensely annoying. I hope you figured it out...

Mar 03, 2009 | 1997 Saab 900

1 Answer

1997 Chevy Alternator replacement help


yes it is in the back left rear if facing alt it is a 10mm.or 13mm. bolt it is not easy to get to

Feb 19, 2009 | 1997 Chevrolet Astro

Not finding what you are looking for?
2000 Chevrolet Venture Logo

Related Topics:

231 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75117 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7772 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...