Question about 2008 Nissan Sentra

Open Question

My clifford alarm remote is not working.. am trying to start the car but the alarm goes off and it wont start

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

beauman
  • 60 Answers

SOURCE: My car alarm is blinking

you can try switching the key to the "on" position then open the hood and disconnect the negative terminal of the battery and reconnect after 2minutes. this will allow the alarm to be '"reset" and will recognize that you have the key for the vehicle.

Posted on Aug 16, 2008

  • 69 Answers

SOURCE: keyless remote is not working & alarm goes off & won's turn off

before doing anything... use the key to unlock the door...then the alarm will not go off

Posted on Jul 20, 2010

SOURCE: when you try to start

I had the same problem last week ---- turn key to "on" position and then press and hold red button on dash for 3-9seconds and the alarm will stop. engine should now start.

EVERY Toyota dealer I called did not know what to do nor could they offer any ideas.
I figured it out after hours of playing with different paths.
This one actually worked..........

Posted on Sep 30, 2008

SUL827
  • 93 Answers

SOURCE: My car alarm is blinking

You need to first look under the drivers side dash area near the hood release/fuse panel area and see if there is a valet switch. The switch will look like a little toggle or a push switch. After you locate it, turn the ignition switch to the on position(dont start it) and flick the valet to the opposite position it is in now. If done correctly in most cases the red system light will stay a constant instead of off or blinking indicating you are in valet mode. Next try to start the engine. If this doesnt work you need to remove the alarm system and repair the ignition switch wiring or replace the electrical portion of the ignition switch. The aftermarket alarm cuts into the ignition switch wires and bypasses the start circuit through the alarm module. When disarmed the alarm completes the circuit and allows the car to start. Good luck hope this helps and please rate this.

Posted on Nov 27, 2008

  • 14 Answers

SOURCE: Car alarm stopped working.. Car wont start

the jetta has a faulty alarm system from the factory i have been working on one in my shop. the alarm moddule is inside the dash behind the light switch and has a 10 pin connector and a 6 pin connector. this can be bypassed if you disconnect both connectors and jump the two large wire on the 6 pin connectors, these wires operate your starter. the car will start and run but your alarm will no longer be active. the door locks and everthing else will still work. the only issue i am having is the factory radio isn't working because it is controlled by the alarm. but worse case scenario i can use an aftermarket radio if need be.

Posted on Feb 28, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

GTI. How can I get my Clifford alarm to operate the central locking?


My best advice is to contact clifford direct and explain your problem normally very helpful.

Mar 02, 2016 | Seat Ibiza Cars & Trucks

1 Answer

Alarm goes off when trying to remote start my o 06 malibu was up!!!


i hav same problem chaged battery noticed battery holder was loose so i soldered it very carefully everything works fine xcept remote start alarm just goes off like when you push the panic button not sure what happened dont think i shorted out the circuit board in the fob if engine light is on this car wont start via remote these remotes must b progamed by dealer or pro shop prob using what they call a tech II computer to remote start you hav to press lock button 1st even if car is already locked i figured this out pess and hold lock button then press start alarm dont ring and the car starts.

Jan 13, 2010 | 2005 Chevrolet Malibu

2 Answers

I need help to reset the car alarm. There is no keyless remote. It's a clifford alrm. It started fine then when i turn the car off the alarm light was blinking and now i can't start the car


Look under the dash for a little button that youll push to bypass the alarm. If not one you will need to disconnect the alarm sysem and remove it. It is useless to you anyway without the key pad

Jul 31, 2009 | 1994 Pontiac Bonneville

1 Answer

Car wont start but the alarm goes on and it never used too


try removing the battery + for at least 2 minutes. it should reset the alarm system. if it doesnt work you need to make your remote work try replacing the batteries and try it

May 30, 2009 | 1990 Mitsubishi Eclipse

1 Answer

Clifford immobiliser unlocks doors, does not start car


Find where your fuel pump relay is and check for power there. Most alarm tech's and alarm system dis engages the fuel pump at there relay's.

Simple things to check is the fuse first then go for the relay and if everything there is working properly, it could be your alarm may have gone bad or your fuel pump it self.

Good luck and hope this helps

Apr 13, 2009 | 1996 Audi A4

1 Answer

My Car wont let me start it


Well, my mom found a little button underneath the dash board on the drivers side. And I guess its kind of like the reset button. So she pushed it and started the car and it was fine!

Jan 15, 2009 | 1999 Honda Civic

2 Answers

Lost keyless entry remote


The fuse for the alarm is under the hood. Give a good look and you should find it. Once you have pulled it it will deactivate the alarm I am not sure if this is exactly your problem since you said that the car wont start.... but it is worth a try.

Aug 23, 2008 | 1997 Chrysler LHS

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

1,265 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

75077 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

705 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...