Question about 2005 GMC Canyon

1 Answer

Vehicle is jerking when gas pushed - 2005 GMC Canyon

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 2 Answers

Plugged Cat converter

Posted on Jun 23, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 2009 malibu I am getting a code p0304 cylinder misfire. What is the most common problem with these cars with this code ?


number 4 misfire check either plug or coil --as to jerking if vehicle is not running correct [misfire ]it will not drive smooth trac light --it can be related to the misfire or check abs and brakes and power braking will set off traction control and puts a strain on brakes and c/v axles

Aug 02, 2016 | 2009 Chevrolet Malibu

1 Answer

What make my 1990Chevrolet Silverado jerking while driving


The jerking could be caused by any number of issues.

Could be bad gas, water in the gas tank, Could be a clogged gas filter; possibly fouled spark plugs, bad distributor cap/rotor, bad ignition coil. And the list goes on and on. If you have not had the vehicle tuned up in a very long while, that would be a good starting point.

Jun 02, 2014 | Cars & Trucks

1 Answer

Jerking when gas is pushed or in idle


It has been my experience with nissan that from your description, the EGR valve is bad."exaust gas recurculater" However it also may have a fuel filter issue due to perhaps water in fuel, trash,etc. If the engine operates correctly once you get it past the "shaky"area then the chances of the EGR valve being bad are better.
Hope this helps.....Good Luck!

Mar 28, 2013 | 2000 Nissan Xterra

1 Answer

Whats wrong with my car!?


Hello
The engine and automatic transmission in this vehicles drive train are fully electronically controlled by a computer called the PCM (Power Train Control Module). Whenever a problem like this occurs the computer stores a record of the problem (there are of course some exceptions to this, like the fuel pump, engine coolant temperature sensor and MAF sensor for instance) in the form of a fault code in its memory, to read these fault codes you must have the systems memory scanned with a special tool. Once the fault code(s) are read you then must perform the appropriate diagnostic testing to find and resolve the problem(s) DO NOT REPLACE ANY PARTS UNTIL A TRAINED TECHNICAIN HAS DIAGNOSED THE PROBLEM TO AVOID SPENDING YOUR HARD EARNED MONEY ON PARTS THAT MAY NOT CORRECT THE PROBLEM

Aug 23, 2012 | 2002 Lexus ES 300

1 Answer

My chrysler lhs jerks when i drive what could the problem be?


Fuel, air, fire. 3 components to create combustion. Which of the three are you lacking? Check Engine Light on?

Your statement is vague. Could be engine, transmission or communications between the two. Check the amperage output of your battery and check for any codes; permanent or temporary and post the results.

Aug 11, 2012 | 1995 Chrysler LHS

1 Answer

My 97 sunfire idles fine but when you get on the gas it jerks & jumps if you push it to the floor it dies.?


Sounds to me like a clogged fuel filter or your fuel pump is going out.....I would check and replace the filter first......

Mar 30, 2012 | 1997 Pontiac Sunfire

1 Answer

2000 nissan xterra~ feels like i got watery gas (checked, no) or running out of gas (not). sputters and jerks and loses power badly until can push gas pedal to floor and won't go above 5 mph. first time it...


Mass air flow sensor might be dirty or failing.
Clean sensor when cold with mass air sensor cleaner only.
that controls the throttle opening and closing.

Jun 22, 2017 | 2000 Nissan Xterra

Not finding what you are looking for?
2005 GMC Canyon Logo

Related Topics:

57 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

Freddy

Level 3 Expert

1311 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...