Question about 1993 Eagle Vision

1 Answer

1993 eagle vision odb connector location? EGR valve location? Best way to take off the EGR valve?

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Master:

    An expert who has achieved Level 3.

  • Master
  • 755 Answers

No connector until 96

Posted on Feb 03, 2015

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

michigan man
  • 3533 Answers

SOURCE: location of fuel filter

it could be under the hood or under the car just inside the frame

Posted on Jan 22, 2009

  • 154 Answers

SOURCE: where is the starter on the 1995 eagle vision

It is well buried. You will find the tail end of it just above and rearward of the driver's side motor mount. It is fastene to the trans bell housing. There is probably a trans line support bracket/plate you will need to remove usually mounted to the middle stud. Be sure to disconnect the battery before you start because the cable is connected directly to battery. There also should be a shim plate between the nose mounting and transmission bell housing. That shim can be a pain but it does prevent premature wear to the flywheel ring gear. (it only fits one way) Those starter solonoids are a common failure item. (only gives a click, or sometimes not even that, when trying to crank.) Let me know if this is helpful

Posted on Apr 03, 2009

  • 3 Answers

SOURCE: locate fan sensor on 1997 eagle vision

Your fans (low and high) have number of parts.
1. Temputure sensor
2. Hi and Lo fan relays (PCM)
3. Relay located in the fan assembly itself

If you car over heats either in idle or when you turn the air conditioner you are having an eletrical issue. The fix is easy but can take some time, rewireing and a relay.

Hope this helps

Posted on May 18, 2009

  • 116 Answers

SOURCE: 1996 Vision Eagle runs rough and stalls when started

timing belt

Posted on May 19, 2009

  • 1 Answer

SOURCE: Where is the Fuel Filter located?

The fuel filter is on the passenger side just in front of the rear tire tucked up next to the frame rail for the rear tire.

Posted on Jun 16, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Location of ecm 1993 eagle Vision


It's behind the glove box. Flip down the glove box door, there should be a clip on each side to press in or outwards(can't remember), and the whole glovebox should basically drop to the floor, you will have access to the emc there. Here is a picture: https://static.cargurus.com/images/site/2015/09/11/18/39/pic-8791146478025387550-1600x1200.jpeg

Aug 16, 2016 | 1993 Eagle Vision

1 Answer

Odb code 14 odb code 32


Code 14=MAP sensor voltage output is outside the acceptable range.
Code 32=Short or open in the EGR solenoid circuit. Check for loose, broken, or shorted wire in the EGR valve wiring and connectors. Possible air fuel ratio imbalance not detected during diagnosis.

Jun 07, 2012 | 1993 Dodge Grand Caravan

1 Answer

Where is the water pump located on 1993 eagle vision 3.5 engine


the water pump usually is always located a little above the main pulley

Feb 26, 2012 | 1993 Eagle Vision

1 Answer

MY 1995 EAGLE VISION STALLS OUT , IT STARTS UP FINE BUT AFTER IT WARMS UP AND YOU TAKE IT FOR A RIDE IT WILL STALL OUT


Find the EGR valve. Look up on the internet what it looks like and where it is located for your car. There will be a vacuum hose attached to it. start the car when the engine is cold. when it gets to running temperature and starts to stall, pull the vacuum line off. If the EGR is bad, the car will keep running and idle will return to normal.

May 26, 2010 | 1995 Eagle Vision

3 Answers

2000 sl1 saturn ODB Codes


using an ohmmeter, you may be able to find the proper specs by googling "proper resistance for egr on 2000 saturn sl1"

Sep 24, 2009 | 2000 Saturn SL

1 Answer

Where is the Fuel Filter located?


The fuel filter is on the passenger side just in front of the rear tire tucked up next to the frame rail for the rear tire.

Jun 07, 2009 | 1993 Eagle Vision

2 Answers

1996 Vision Eagle runs rough and stalls when started


BCM I believe on that should be behind glove box area. You'll have to remove knee guard from door to radio, to see it up under near glove box area, screws & brackets holding up there. As far as disabling it, a little google work or go on a forum, you may get info, but sounds like circuit board has to be modified with jumper wire or something. Have you tried unlocking passenger door with key(s) to see if that will disable security system?

May 18, 2009 | 1996 Eagle Vision

1 Answer

Location of fuel filter


it could be under the hood or under the car just inside the frame

Jan 22, 2009 | 1993 Eagle Vision

Not finding what you are looking for?
1993 Eagle Vision Logo

Related Topics:

70 people viewed this question

Ask a Question

Usually answered in minutes!

Top Eagle Experts

yadayada
yadayada

Level 3 Expert

74896 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Stewart Dibbs

Level 2 Expert

267 Answers

Are you an Eagle Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...