Question about 1997 Dodge Grand Caravan
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
on each headlamp assembly, there will be either one or two plastic nuts that you can turn.
If you only have one nut on each, that will adjust the vertical aim of the headlights.
If you have two nuts on each, one will adjust the vertical and the other will adjust the horizontal.
Park your car on a level ground 30 feet from a wall and measure the height from the ground to the bulb and mark on a wall (do this for highs beams and low beams if the bulbs are separate, if highs and lows are the same bulb, only do it for the lows)
If the headlights read VOR, then aim the brightest part or cutoff part just below the mark on the wall. If it says VOL or nothing, aim them 2 inches below the mark on the wall.
Posted on Sep 17, 2009
there are 2 hex screws that one is for adjusting ht and the other is for adjust in and out and they are just inside the hdlt. if you need more advice go to collisionrepairadvice.com
Posted on Mar 10, 2009
SOURCE: headlights need adjusting
The headlights will have small rods or adjusting screws located near the headlight mounting points. Will probably need a torx socket or screwdriver to adjust. Torx is a 6 point type screw.
Posted on Mar 11, 2009
1) open the hood.
2) Carefully remove the three screws holding the headlight assembly in place.
3) Carefully slide the headlight assembly out. At this point you can replace the headlight bulb, turn signal bulb, or the entire headlight assembly. To replace the headlight bulb turn the collar holding the bulb in counter clockwise. Pull the bulb out of the headlight assembly. Replace the bulb. Insert the bulb into the headlight assembly insert the collar and turn clockwise until it locks. (Do not touchglass with your fingers or it will cause the bulbs to catastrophically fail - clean with alcohol pad if you touch the glass)
4) Carefully insert the headlight assembly back into place.
5) Replace the three screws removed in step 2 being careful not to over tighten.
Posted on Oct 30, 2009
Remove the cover plate on the passenger side of the heater box, 3-4 screws.
Unplug the motor assembly, remove 3-4 more screws that hold the motor in place and pull it down from its position. Get an aftermarket motor and installed it in the original housing with the original squirrel cage.
Installation is the reverse of removal.
Posted on Nov 23, 2009
Tips for a great answer:
May 17, 2015 | 1997 Dodge Grand Caravan
Nov 26, 2011 | 2001 Dodge Grand Caravan
Jul 30, 2011 | 1997 Dodge Grand Caravan
Apr 23, 2010 | 2000 Dodge Grand Caravan
Apr 17, 2010 | 2000 Dodge Caravan
Apr 10, 2010 | 1999 Dodge Grand Caravan
Mar 12, 2010 | 2005 Dodge Grand Caravan
Dec 08, 2009 | 1999 Dodge Caravan
Sep 17, 2009 | 2005 Dodge Grand Caravan
667 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: