Breack light of sentro doesnot closed even we locked the car

Your latch might be in the closed position before you even close the door, try using a small screwdriver on the latch while pressing the release button, if it's stuck closed then this will open it to the right position so it will lock closed when you close the door. If this does not work, sometimes the problem is in the striker (the little tab that the lock hits when the door is closed, this usually has 2 small screws holding it in place, you should be able to loosen both screws & adjust the striker forward or backward so the latch will make better contact with it.

The valves can get bent if the belt breaks, replace the belt and then keep your fingers crossed you dodged the bullet on this.

warning light is activated by a micro switch in the door latch, determining which one is the trick. easiest way to pinpoint this problem is to have the vehicle scanned by an experienced tech with the proper tools.

there is a blown fuse in driver side fuse box.

the cable is broken ,it must be changed

I just went out and looked at mine and couldn't find the switch either. However I would reccomend going to each door (front back and tailgate and reshutting each one firmly.

Check the switch plunger. If it is broken and does not depress when the door is closed, it will continue to act like it's open. Replace the switch if broken or faulty.

Won't even work on high setting? If not , check all fuses, if yes, resistor needs replace

Hi, my name is adam. By the way your descrpion says, you are having difficulty with the door ajar. My solution is to take a pink eraser and clean off the sensors on each door. Sometimes road dirt and grime get in there and screw it up. Thank you.

the reason the locks dont work more then likely there is a code stored in the bcm for a lock output circuit normally caused by one if not both of the sliding door acuators. even if you change the acuators the locks still will not work until the code is cleared.