Question about 2000 Jeep Grand Cherokee
Actually, once in a great while they will blink. You can actually 'hear' when they will work. But, for the most part, the turn signal arm and switch are silent and they do not work. My Hazards work fine ! What the first thing I should look for?
2000 Jeep Cherokee Sport
Your Turn Signal FLASHER is out; replace it...
The flasher is located in the Junction Block (under the dash, left of steering wheel. See diagram at very top of this page). The following repair tip was provided by "tntguy":
Look at the end of the flasher relay with the prongs sticking out. There will be 2 plastic tabs holding it together. Break or bend these back. Pull out the insides. On one side will be all the components. On the other side will be solder joints. Get a magnifying glass and inspect these joints. One or two will probably have stress cracks. Just dab a little flux on this joint and heat it with a soldering iron until it melts back together.
You may need to add just a little solder. Be sure to get the pins hot and not just the solder. They need a lot of heat. Slide the relay back into its cover, dab a little super glue or tape it back together, and you're ready to go.
Hope helps (remember rated this)
Posted on Jun 05, 2010
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
Tips for a great answer:
Mar 03, 2015 | 2002 Saturn L-Series
Feb 15, 2015 | GMC Cars & Trucks
Sep 04, 2013 | Cars & Trucks
Jan 25, 2013 | Buick LeSabre Cars & Trucks
Jan 15, 2013 | 1998 Ford Escort
Jan 04, 2013 | 2000 Dodge Neon
Aug 24, 2011 | 2000 Acura TL
180 people viewed this question
Usually answered in minutes!