Question about 1999 Toyota RAV4

2 Answers

Rear driver wheel has light reubbing noise when car in motion goes away when brakes are engaged. Is this brakes or barrings problem? Cost of repair?

Posted by on

Ad

2 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Toyota Master
  • 1,675 Answers

Hi this sounds like your brake pads have worn, or the brake shoes as well, if you have drum brakes on the back it will be shoes, if disk brakes will be pads+shoes (inside the disk) if it was the wheel bearing you would hear a loud humming noise not rubbing noise, is it a metallic rubbing noise or a rubber squeaking rubbing noise? just check condition of tyre on back if it is the squeaking rubber noise cost will depend on where you take it and if you do it yourself, possibly $40 to $50 at a garage/auto shop or possibly $20 to $30 if you do it yourself, this just depends ...hope this helps

Posted on Jun 05, 2010

Ad
  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

On my 2000 blazer i got a loud noise coming from my rear i checked the back brakes and they are good the noise only happens when going forward not in reverse

Posted on Apr 17, 2013

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Clicking noise goes away when braking


Look at the constant velocity joints on that side. When the rubber boot tears it lets road dirt in which fouls the grease and allows premature wear on the cv joint components.

Sep 03, 2014 | Nissan Maxima Cars & Trucks

1 Answer

ABS light comes on and make noise


run diagnostic, check your wheel brg and rotor plate might hav cv grease on it also clean all sensors with brake cleaner

Feb 10, 2014 | 1999 Volkswagen Golf

1 Answer

Back brakes lock up on 2009 chevy pick up


make sure emergency brakes not still engaged.could have faulty proportioning valve in brake mastercylinder.if you see abs light flashing could have faulty wheel speed sensor or bad rear wheel cylinder causing rear brakes lock up.many things will cause rear brakes remain lock up.

Mar 21, 2013 | Cars & Trucks

2 Answers

The ABS system engages when it shouldn't and fails to shut off after the car is stopped. How many sensors are there on a 2000 Grand Marquis? How much do they cost to replace? Is the ABS light the...


TRAC is an option on ford products your better off without,
as it slams on the rear brakes & cuts out injectors, in the winter,
if the rear wheels slip. Really a bad invention. When you need
full control in snow,it is taken away.

The ABS is the electrical part of your braking system

As with any vehicle problem or check light, you get on your
dash,you should not be using the vehicle

You have the car checked for codes in a couple of days,
then diagnosed & repaired within a week

The abs & trac could be a bad wheel speed sensor,
you have 4 as well as other items in that system.

This is a social web site or forum,we answer questions from
home, as you can,so price questions would be addressed
at a repair shop. You never need a dealer for any vehicle
issues,ever,too expensive to go there

Jul 01, 2011 | 2000 Mercury Grand Marquis

1 Answer

My 1997 Honda Accord makes a grinding noise when in motion. When I press on the brakes it stops, when I release the brakes it starts again. The grinding noise continues pretty consistantly when in motion,...


Sounds like a bad wheel hub. Or it could be just the brakes. Can you tell which corner it is coming from? Can you jack up that corner and spin the wheel? Wheel hub job about $400 brakes about $200 or less. Good luck

Oct 22, 2017 | 1997 Honda Accord

1 Answer

Rear brake noise after brake replacement


probably a dumb question, but if there is a backing plate, did you make sure it isnt bent and hitting the rotor? you never want to sand new rotors, although i dont think it would cause this concern. i would suggest lightly scuffing up the brake pads. this will eliminate any noise caused by the contact of the rotors and pads. if it goes away then you know its a problem with the pads/rotors.

scoring of only the inside rotors would make me think that possibly the caliper slides are frozen up. make sure they move quite freely on the slides. it is not uncommon for brake pads to score rotors though.

but brake noises at low speeds that dont' change when applying light brake pressure are usually some sort of metal or something contacting the rotor.

Mar 23, 2010 | Toyota Camry Cars & Trucks

1 Answer

Squealing sound - front driver's side brakes


This sounds like a wear indicator( a metal tab on the brake pad) is doing its job, warning you that the brake pads need replacement soon. you can bend the wear indicators away from the rotor so they won't make contact. This will stop the annoying noise. Replace the pads and check the brakes soon. Brake pads should always be changed on both wheels at thge same time, so change the other front pads also.

Nov 27, 2009 | 2002 Kia Sportage

1 Answer

Brake noise from rear drivers disk brake when turning


sounds like the front brakes need replacing, that what the squeal is. They are made to do that so you know when to replace them

Apr 27, 2009 | 2002 Chevrolet Camaro

1 Answer

ABS light, light come on goes off and comes back at 5-10mph


have had simmilar problemn with my 1992 licoln towncar do have a solution however will cost hundreds you have a ABS speed sensor out as u kno the problem is you cannot only replace one because they are wire through the axels you have to replace both meaning either both front or both rear in your case if front driversside is faulty you will need to replace both unhooking will only cause light to permantely stay on one suggestion that may help atleast to get an inspection would be to dissconnect sensors to that paticular wheel shut off engine and restart when light is off dissconnect batter for 5 mins then reconnect tghis will reset computer inside possibly giving you enough time to get an inspection befoere computer resets and abs comes back on however it is not guarented to work depends on severit y of damaged sensor and how quickly you module can reset note that this is a temo fix abd sensor will not prevent any stopping or cause danger to braking system it will infact stil engage possibly not on that wheel but that is the problem with an abs as apposed to just a standard anti lock braking system more sensor to break and cost hundreds

Feb 10, 2009 | 1992 Cadillac DeVille

Not finding what you are looking for?
1999 Toyota RAV4 Logo

468 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8567 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...