Question about 2002 Chrysler Town & Country

1 Answer

Where is shift solenoid for 2002 town & country?

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 973 Answers

It is located inside your transmission, you will have to take off the transmission oil pan to access it.

Posted on Jun 05, 2010

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
motor1258
  • 6674 Answers

SOURCE: Describe your 2002 Chrysler Town &

Safety neutral switch o.k.? Tried moving shifter through all gears while holding key in start position?

Posted on Aug 03, 2009

66 chrgr
  • 1011 Answers

SOURCE: Describe your 2002 Chrysler Town &

On the driver side of the intake plenum close to the throotle body is were your pcv valve is located :)

Posted on Aug 23, 2009

  • 47 Answers

SOURCE: chrysler town & country shifts on first then seems to go to nuetr

Make sure the cable to the trans is adjusted properly.

Posted on Oct 22, 2009

  • 59 Answers

SOURCE: My 2002 town & country wont shift into high

Bad Transaxle.

Posted on Feb 23, 2010

  • 2 Answers

SOURCE: 2002 town & country blower motor will not

In order to achieve different speeds for the fan motor, there is a bank of resistors that reduce the voltage depending on what speed is selected. This is basicaly the same design for all cars on the road. The fail mode causes the full voltage to bypass the resistor bank so the fan runs at high speed (maybe even higher than your normal high setting). On most newer vehicles, including your '02 T&C, to help keep the resistors cool, they are mounted to a heatsink and then that assembly is mounted in a hole in the A/C ductwork just below or behind the glovebox. My '02 T&C has the 3 zone auto temp control and it had a fancier resistor block, but the function is the same. You should be able to get the cheaper one for <$25 at a parts store.

Posted on Apr 30, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Can I put a 2003 town & country transmission into a 2002 town & country


most likely it will fit unless the manufacturer changed the application that year but its not likely suoldnt be a problem

Mar 03, 2013 | 2002 Chrysler Town & Country

1 Answer

1998 Chrysler town and country wont shift into drive


Is the check engine light on ?
You may have a problem with a solenoid or pressure problem in the transaxle.

Jul 31, 2012 | 1998 Chrysler Town & Country

2 Answers

I have a 2000 chrysier town & country 3.8 it shifts gears sometimes and then it is stuck in one gear can anyone help?


It sounds like you are either low on transmission fluid, or you have a shift solenoid or TCC Solenoid that is failing. Check the transmission fluid level when the engine is warmed up. If the fluid is at the correct level, see if your check engine light is on. If the CEL light is on, you probably have a failed Solenoid Valve. Have the code checked to find out which solenoid is faulty.

May 24, 2011 | 2000 Chrysler Town & Country

1 Answer

The key is stuck in the Ignition & will not come out ,& key will not turn to off position shift lever will not lock either


We have a 2002 Town & Country, and this problem happen to us - we had to have the ignition switch replaced and we have had no other problems with this!

Mar 23, 2011 | 1996 Chrysler Town & Country

1 Answer

2001 Chrysler Town & Country lx 3.3L need hellp cant find this code PO752


The ODBII Code PO752 means:
Shift Solenoid A Stuck On. It's a tranny solenoid.

Sep 23, 2010 | 2001 Chrysler Town & Country

1 Answer

Trouble codes on a 2000 Chrysler town and country


0775 is Presure Control Solenoid "B", 0784 is 4-5 Shift these are trans codes from the transmission Solenoid. This is a changable part for any mech. Part is around $200 & includes the gasket.

Jun 26, 2009 | 2000 Chrysler Town & Country

2 Answers

2002 chrysler town and country wont leave limp mode


try getting a new shift solenoid for it. i had the same problem on my 2002 chrysler town and country and my plymouth breeze which is also a dodge product. it is very simple to do and doesnt take all that long. the part will probably run you about 150 to 200 dollars but it should fix your problem.

Dec 31, 2008 | 2002 Chrysler Town & Country

Not finding what you are looking for?
2002 Chrysler Town & Country Logo

Related Topics:

505 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8273 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...