Question about 2008 Dodge Caliber

3 Answers

Want to change oil and oil filter on my 2008 4 cylinder dodge caliber vehicle, and need to know how can I reprogram the command "change oil" that shows up as an option on the blue lighted odometer reader.

Posted by on

3 Answers

  • Level 1:

    An expert who has achieved level 1.


    An expert that got 5 achievements.


    An expert whose answer got voted for 20 times.


    An expert who has answered 20 questions.

  • Contributor
  • 20 Answers

Tone man is right, its 4x within 5 seconds I think

Posted on Jul 14, 2010

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 775 Answers

According to the owners manual, which you can download free from, turn the ignition to the on position, do not start. slowly depress the gas pedal 3x to the floor. turn the ignition off. start the car. if the light did not reset. repeat the procedure.

Posted on Jun 05, 2010

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that got 5 achievements.


    An expert whose answer got voted for 20 times.

    New Friend:

    An expert that has 1 follower.

  • Expert
  • 115 Answers

Special tools are required for this. You'll need to take it to a repair facility.

Posted on Jun 05, 2010

1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

2008 dodge caliber engine diagram

There is a Dodge website (not from the corporation, but from fans) for Dodge vehicles and they have a subsection on the Caliber. There is a 2007 or a 2008 service manual online there if you join their group. good luck.

Apr 05, 2014 | 2008 Dodge Caliber

1 Answer

What parts do I change to tune up my 2008 dodge caliber

For a standard tune-up, the parts needed include an air filter, oil filter, fuel filter, spark plugs, and spark plug wires. You should also have oil, transmission fluid, coolant, windshield washer fluid, and brake fluid available. A tune-up consists of topping off or replacing fluids, changing spark plugs and spark plug wires, changing the fuel, oil, and air filters, and checking the pressures of the tires. More detailed tune-ups run a diagnostic test on the vehicle to check for any codes that indicate additional issues.

Mar 16, 2014 | Cars & Trucks

1 Answer

How can i change the transmission oil and filter and how many liter of oil i well used in dodge caliber 2008

you have to raise the car take the trans pan off be careful the fuild will pour out fast.tip lossen all pan bolts a little bit then take just half the bolts out slowly so only one side of the pan comes down fuilded will drine take whole pan down.the filter is up in there pulls right off some only have one bolt to take off put new filter in push in place replace pan gasket that comes with filter.put pan back up criss crossing the bolts till tieght than add about 3 and a half L fuiled check add as fuild till full may take up to 5L or more.tip make sure you shift the trans threw the gears than recheck fuild.goodluck may be messy

Feb 27, 2011 | 2008 Dodge Caliber

1 Answer

I have a 2008 dodge caliber with 65K miles and am moving cross country, about 2300 miles. what services should be performed on a caliber with this mileage.

oil change spark plugs air filter make sure brakes are in good condition also check transmission fluid and coolant good luck

Feb 07, 2011 | 2008 Dodge Caliber

2 Answers

How often should i change my oil in my 2008 dodge caliber

If you like your car, change every 2,500 miles. Manufacturers say longer, and that seems to work, but oil change is pretty cheap compared to oil related failures...

Sep 12, 2010 | 2008 Dodge Caliber

2 Answers

How do I reset oil change setting on 2008 dodge caliber, just changed and says need change

get in, turn car to run and press gas pedal to the floor 4 times within 5 seconds

Jan 15, 2010 | 2008 Dodge Caliber

1 Answer

Dodge caliber oil viscosity

no it will not cause any harm over the corse of 3000 miles. 5w30 is just a little thicker. 5 is the thickness when oil is cold. 20 or 30 is thickness when oil i hot, it will be ok just dont do any hotroding. only down part is that if the dealer finds out it will void the warranty.

Jan 02, 2009 | 2008 Dodge Caliber

Not finding what you are looking for?
Cars & Trucks Logo

250 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts


Level 3 Expert

75005 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7710 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides