Question about 1998 Dodge Durango

1 Answer

I have a 2002 dodge durango 4.7 i have power to all the fuse boxes, BUT NO power to the PCM, Why? also when cranking over im reading 40lbs. of oil pressure, WHY? alos could the oil sencer, & cam sencer wires be missed placed with each other?

Posted by on

  • snuffy399 Jun 07, 2010

    yes all fuses working, thanks for responding, wait for you to get back, with more



1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Brigadier General:

    An expert that has over 10,000 points.

  • Master
  • 3,489 Answers

40 lbs sounds like great pressure to start an engine with. Let me review the wiring diagrams and get back to you. Have you checked all fuses?

Posted on Jun 05, 2010


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

My 2013 dodge avenger wont start. Im getting a p0688 ECM/PCM code. What should I do

P0688 (generic) = ECM/PCM Power Relay Sense Circuit /Open
P0688 DODGE - Auto Shutdown Relay Control Circuit Low

Check all the ECM fuses, if the fuses are OK try replacing the ASD (Auto Shut Down) relay.

Read more:

Possible causes:

- Weak battery - Low voltage while cranking
- Faulty Engine Control Module (ECM) relay
- Blown ECM fuse
- Faulty ECM
- ECM harness is open or shorted
- ECM circuit poor electrical connection

Feb 13, 2016 | Dodge Cars & Trucks

3 Answers

Car will not start but will turn over

Quick Google search says most likely internal PCM failure or wiring to/from PCM. See below link.

Jan 03, 2015 | 2001 Dodge Durango

1 Answer

A knocking that starts when engine is cranked then it goes away

The knock is likely a worn connecting rod bearing. Are you using the correct weight of oil, never use any heavier than 10W30W, heavy oil viscosity's cause slow circulation through the oil passages and starve the engine's bearings for oil.

May 17, 2012 | 2002 Dodge Durango

1 Answer

I have a 2003 Dodge Durango 5.9 8 cyl. I am trying to smog it but the smog check station can't read my Durango's computer to tell if my O2 sensors pass.Would this be the PCM need be replaced ? I...

maybe, maybe not. First thing, does the aux power ( cig lighter) work? if not then most likely the fuse that supplies power to both is bad. Next thing to check is if the connunication port is getting power. If you look at the port under the dash there are two rows of slots. numbering is 1-8 across the top row left to right, and 9-16 across the bottom row left to right. 4 & 5 are ground and 16 is power. Should have 12 Volts, if not and the fuse is good, then you might have a bad PCM.

Aug 18, 2011 | 1999 Dodge Durango

1 Answer

Headlights, power door locks, rear windshield wiper and remote control does not work on 2002 Dodge Durango.

It sounds like a fuse. Check your manual to locate your fuse box, check to see what fuse goes to to the headlights, door locks etc, and check the fuses to see if they are burnt out.

Feb 02, 2011 | 2002 Dodge Durango

2 Answers

Where is the asd relay on a 2001 Dodge Durango 4.7L? My Durango ran fine then would not start at all it cranks but won't turn over, We have tested the fuses and other relays and they are all working fine,...

The PCM has 3 connectors plugged into it. Try wiggling each connector and listen for a clicking sound, starting with the connector furthest from the front of the durango, and the middle connector with a white top.
If this doesn't help, replace your PCM.

May 22, 2010 | 2001 Dodge Durango

1 Answer

2002 Durango: I have a 2002 dodge durango and my brake went to t...

Most of the Gen 1 Durangos had the useless rear wheel ABS. This fuse most likely goes in the the PDC or power Distribution Center under the hood next to your battery.

How is the pedal now? Your 02 has rear drum brakes which sometimes need to be adjusted to keep a firm pedal.

May 17, 2010 | 2002 Dodge Durango

1 Answer

2002 Dodge Durango turnsignals, radio, sunroof no longer operate

Sounds like the forward control module, sometimes referred as the body control module. Take it to the dealer.

Jul 02, 2009 | 2002 Dodge Durango

Not finding what you are looking for?
1998 Dodge Durango Logo

Related Topics:

40 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts


Level 3 Expert

78919 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides