Question about 2000 Suzuki Esteem

1 Answer

No start cranks over but no start. is fuel pump in tank? 1.6l cant figure out were spark is sent from

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Sergeant:

    An expert that hasĀ over 500 points.

    Champion:

    An expert who has answered 200 questions.

  • Expert
  • 218 Answers

The fuel pump is in the tank, and the spark plug wire's could be hidden under a plastic cover on that motor

Posted on Jun 05, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

95 Park Avenue Ultra dies for no reason I can find, I've replaced the crank sensor, cam ssensor, spark module, fuel filter, I've had the injectors tested, fuel pump tested, plugs & wires t


As you have probably figured out by now, you will have to treat it as a no start and troubleshoot it when it fails to start. Until you figure out if you are loosing spark or fuel to the injectors when the engine dies you have no direction to go in.

Aug 20, 2012 | Buick Cars & Trucks

2 Answers

Cranks but wont start


you need to check for spark at the plugs while cranking.then check for fuel entering the intake at the injectors.you don`t say if its a 4 or 6 cylinder.if its a 4 cylinder you can look into the throttle body while someone cranks the motor and you should see fuel squirting into the intake.if you have no spark then check to make sure the cap and rotor is in good condition and the rotor is turning(if not then the timing belt maybe broken and needs replacing.also check the plugs as if they are worn so bad you won`t get any spark.a common problem on these is the coil pickup in the distributor going bad.there is a 2 wire connector that comes out of the distributor with a plug,if you follow this wire back into the distributor you will see the pickup.also check and see if you can hear the fuel pump running while cranking,you may have a bad fuel pump.you may have to remove the gas cap and listen at the filler neck or listen under the car were the gas tank is.if the fuel pump is not running then you can hit the fuel tank in the middle while someone cranks the motor and it might start.if so then the fuel pump is no good another common problem.there is a fuel pump relay under the hood on the drivers side that sometimes goes bad or there is bad connections.most of this checking is good for the 6 cylinder as well except you can see the fuel squirting into the intake.it could also be a bad computer that will have to be checked out at a shop.

Apr 10, 2011 | 1991 Plymouth Acclaim

1 Answer

My car won't start after replacing the engine when told it was timing problems and easier to replace the whole thing rather than tinker with it, and a new fuel pump when there was no fuel being sent...


I wonder if maybe some wiring got pinched when replacing the engine, that is completely illogical that you have no fuel or spark. Thats what I would do is start checking for power and ground at fuel pump and spark sources like the crank sensor. That would be the only thing that makes sense to me.

Mar 27, 2011 | 1998 Plymouth Breeze

1 Answer

My 1991 lexus will not start when the ignition is turn with the key. The ingine constantly turns over without starting and preceeds to kill my batterie.


Well if it is cranking you need to see if you are getting spark and fuel.....Try turning the ignition on without cranking the motor....You should hear your fuel pump making a whirring sound for about 3 sec.and then shut off...If no sound from pump (which is located in the fuel tank) check the fuel pump fuse If fuse is good check fuel pump relay...If all checks out ok with fuel pump take into consideration when the fuel filter was changed last....I dont recommend adding fuel injection cleaner to your tank without first changing fuel filter...additive is designed to break up debris thus breaking up all trapped particles in filter sending debris through your injectors.... To check for spark pull the #1 spark plug wire and place it on an angle on tip of plug (allowing you to see if spark is present) have an assistant crank engine while you look for spark..... Do not hold spark plug wire in your hand while engine is cranked.... I hope this has helped you

Jun 12, 2010 | Cars & Trucks

1 Answer

Toy turns over but wont run change fuel filter n fuel pump still


The fuel pump should run for a second or two when you first turn the key on, but then shuts down to prevent the engine from flooding if the computer does not get a signal from the crank or cam sensors which the computer uses to trigger the ignition system. So no spark no fuel. Check to see if you have a spark in the ignition system.

Aug 28, 2009 | 1990 Toyota Camry

2 Answers

Wont start turns over but no start


1 Inspect Battery Battery Discharged or Faulty. 2 Inspect Battery Cable Corroded, Broken, Shorted or Poorly Connected Battery Cable. 3 Inspect Fuel Filter Clogged or Dirty Fuel Filter. 3 Inspect Distributor Cap Distributor Cap Cracked or Burned. 5 Inspect Coil - Ignition Faulty Ignition Coil. 6 Inspect Wireset Worn, Damaged or Faulty Spark Plug Wire(s). 7 Inspect Spark Plug Incorrectly Gapped or Fouled Spark Plug(s). 8 Inspect Starter Starter Motor Faulty. 9 Inspect Fuel Pump Low Fuel Pressure. 10 Inspect Solenoid Switch Faulty Starter Solenoid Switch. 11 Inspect Relay - Fuel Pumpat Faulty Fuel Pump Relay. 12 Inspect Fuel Injector Pressure Regulator Faulty Fuel Injector Pressure Regulator. 13 Inspect Ignition Switch Improperly Connected or Faulty Ignition Switch. 14 Inspect Starter Drive Faulty Starter Drive. 15 Inspect Fuel Injector Dirty or Worn Fuel Injectors. 16 Inspect Fuel Pump Strainer Clogged or Dirty Fuel Pump Strainerat. 17 Inspect Engine Control Computer Incorrect Operating Information Being Delivered and Sent From The EEC. 18 Inspect Fuel Tank Fuel Tank Empty. 19 Inspect Carburetor Carburetor Flooded or Faulty Choke. 20 Inspect Distributor Worn, Loose, or Incorrectly Installed Distributor.

Jul 02, 2009 | 1997 Ford F250 SuperCab

1 Answer

1996 Lincoln Continental turns over but won't fire or start,check engine light never goes out..cant confirm if its the cam sensor...


Threepoints of interest.

Fuel pump ( can you hear it working)

Your crankshaft position sensor ( controls spark) & the

Mass air flow sensor (controls the air / fuel ratio to engine )

Good luck.

crank sensor - fromnt of engine at crank pulley
MAF sensor - 1st sensor on duct exiting the air cleaner
Fuel pump , in fuel tank.

Jun 15, 2009 | 1996 Lincoln Continental

1 Answer

Will not fire.


actually it sounds like your crank position sensor may be faulty.

Apr 15, 2009 | 1990 Saab 900 Hatchback

3 Answers

1997 GMC K1500 4x4 5.7 ex.cab SFI injection system


fuel pump died replaced it truck ran poorly afterwards. Had a prussuer test done pump determend pump was no good. Put in another ran good for 2 days started running poorly hard to start no power. 2nd fuel pump. So i figure another bad new fuel pump wow changed it put in a third brand new fuel pump. Still will not eve start now. I had it tuned up 2 months ago new plugs rotor, cap, etc. put in a new fuel filter made sure it is on proper checked all connections for leaks. this cannot be a fuel pump problem now. no problem with the elctrical i figure i have great spark on ignition tester. I can hear the fuel pump prime when i turn the key. but when i went and checked the fuel port i had no pressure. When it is being cranked gas sews out of the test port. Also i dont if this is comon cause i used to turn my keyand go. but when i have someone turn the key and i listen at the gas tank whn the key is shut off i hear gs spraying back into the gas tank. So i am open for opinions.

May 18, 2008 | 1993 GMC Sierra K1500

Not finding what you are looking for?
2000 Suzuki Esteem Logo

Related Topics:

134 people viewed this question

Ask a Question

Usually answered in minutes!

Top Suzuki Experts

yadayada
yadayada

Level 3 Expert

76109 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Boyet Soriano
Boyet Soriano

Level 2 Expert

293 Answers

Are you a Suzuki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...