Question about 2006 Kia Sedona

Open Question

Limp Home Valve location ? Electronic Throttle Control location ? MAC, TPS, MAF, and MAP Sensor location ? App Sensor location ?

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 148 Answers

SOURCE: engine stalls

your on the right route but also check egr valve

Posted on Jul 07, 2008

  • 1 Answer

SOURCE: 1989 Cavalier Z24 3.1 rough idle and hesitation

its just white cuz i too the cat off..

cuz i thought my proble could have been to do with the cat...

cuz i lost power driving up hills and on highways now it just will start the die right away

or start and idle really bad...

any ideas???

i was thinking crank sensor.. or injectors

Posted on Oct 01, 2008

garybevan667
  • 7 Answers

SOURCE: Check engine lite says the Throttle Postion Sensor is Bad

The TPS is usually located on the inlet manifold at the rear of the engine.If you look at where the accelerator cable connects to the throttle housing it should be there. It's held on by 2 torx or hex head screws & has a wiring block connector with 3 wires going in to it. This connector should simply pull off when you squeeze the clasp. You didnt say which engine you have but the TPS is similar across the range. You must make sure the ignition is off when unplugging it otherwise you will generate a fault code in the Engine Managment System. Once replaced switch the ignition on for 5 seconds & then switch off. This should position the sensor ready to start the engine.

db2b932.jpg
544fcd5.jpg

Posted on Nov 24, 2008

mecanica03
  • 874 Answers

SOURCE: 2001 Acura 3.2 CL Type-S TPS and Map sensor issues...

no need to replace the throttle body , and i think that you make a test before to buy any piece . disconnect the negative battery terminal few minutes, then connnect and start engine again, drive few minutes by observing the engine, if light comes again, replace only map sensor ,good luckl

Posted on Apr 24, 2009

centralvalle
  • 386 Answers

SOURCE: where are maf and map sensor located in a 2001

it is always in the intake before the throttle body, sometimes in the plastic ducting hose leading into the intake airhorn. look for wires coming from the unit in this area, you should be able to track it down easily... please rate my help. thanks

Posted on Aug 07, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

P1296 code 1996 Concorde


P1296 CHRYSLER - 5 Volt Reference Voltage Missing At Throttle Position Sensor
https://www.autocodes.com/p1296_chrysler.html

Mar 02, 2017 | 1996 Chrysler Concorde

Tip

Throttle Actuator Control - drive by wire


1.5) TAC - Throttle Actuator Control
What is it? Some vehicles have indirect throttle control "drive by wire". Instead of the accelerator pedal position being conveyed directly to the throttle plate by cable linkage, it is detected by an electrical sensor and this is fed to the ECU. The ECU in turn sets the position of the throttle plate appropriate to the sensed position using an electric motor. The throttle plate position is, in turn, checked by the throttle position sensor and this signal is sent to the ECU to confirm that the requested throttle plate setting and its recorded position are in agreement.

Where is it located? The first part of the TAC is located on the inner wing/fender and consists of rotary device to which the accelerator cable is attached; the degree of rotation (pedal depression) is detected electrically and this is signalled to the ECU. The second part of the TAC is located on the throttle body and acts on the throttle plate shaft.

Symptoms of a faulty TAC
Associated OBD2 error codes DTCs: P0120, P0124, P1516; P2102, P2103;P2111 - P2118

  • Sudden power loss/limp home: If the ECU detects any fault with the throttle actuator control directly or with the position feedback via the TPS it engages an immediate engine shut-down to either idle speed or limp-home speed.

How to fix? The TAC is part of complex systemand the failure of the TPS has to be eliminated first as a possible source of error. A simple electrical connection failure can also give rise to the shutdown so all associated connections should be checked to ensure that they are clean and bright to allow electrical continuity.


NEXT 1.6) EGR Exhaust Gas Recirculation valve

on Jul 15, 2011 | Mercedes-Benz E-Class Cars & Trucks

1 Answer

Got p0748 p0108 code on my 04 honda odyssey. Car sat for about one year. Replaced fuel pump yesterday and it started right up. Can I get info on locations of where sensors are?


PO 748
service the transmission .....check solenoids

- Dirty transmission fluid - Low transmission fluid level - Faulty line pressure solenoid valve 'A' - Line pressure solenoid valve 'A' harness is open or shorted - Line pressure solenoid valve 'A' circuit poor electrical connection

Read more: http://www.autocodes.com/p0748.html

P0108
is the code for a problem with the MAP electrical circuit sensor having too high voltage input to the Engine Control Unit (ECU). This means that the voltage input to the ECU is too high and that it is not in the correct range for proper engine operation to work with inputs from the Mass Air Flow Sensor (MAF) and Throttle Position Switch (TPS). P0108 OBD II Trouble Code Manifold Air Pressure MAP Barometric Pressure...


odyssey map sensor is on the throttle body

Map sensor


26349763-lyuervfxp0xfzshzuykucxk0-2-0.jpg

Nov 10, 2016 | Honda Cars & Trucks

1 Answer

Engine trouble code P1295


- Faulty Throttle Position Sensor (TPS)
- Throttle Position Sensor (TPS) harness is open or shorted
- Throttle Position Sensor (TPS) circuit poor electrical connection
- Faulty Powertrain Control Module (PCM)
- Faulty Mass Air Flow (MAF) sensor
- Faulty Manifold Absolute Pressure (MAP) sensor

Jan 28, 2015 | 2007 Hyundai Entourage Limited Minivan

1 Answer

My 2004 Xg350 is stuck in limp home mode.


code p1155 refers to electronic throttle system (ETS)- malfunction===causes --wiring--ETS limp home valve

code p1193 refers to ETS -limp home valve --on===causes --Low RPM
code p0302 refers to cylinder 2 misfire detected===causes--engine mechanical fault--wiring---ignition/ fuel system---injector---ECT/MAF sensor---ECM.
Pulling a battery lead to reset is a waste of time as it corrupts the CPU program. Use a code reader to reset . It is quicker and doesn't run the risk of program corruption

Dec 21, 2013 | Hyundai XG350 Cars & Trucks

1 Answer

Hi my Saab 2001 93 2.0 turbo convertible has lost power get into limp home mode I reset it every few weeks codes come up p1105 p1260 p1251 p 1264 what do u think is wrong ?


code p1105 refers to manifold absolute pressure(MAP) sensor, TC system-leak detected. causes ---intake leak, ---hoses There are to references to p1105 The second response is still map sensor but the causes are---TC system--mechanical fault--air leak between throttle body-TC,map sensor---TC system--exhaust blockage
code p1260 refers to throttle return spring--weak spring force. causes ---mechanical fault,--,throttle control unit
code p1264 refers to throttle valve opening-accelerator released causes ---throttle control unit---mechanical fault

Mar 28, 2013 | 2001 Saab 9-3

1 Answer

I don't know if it is an EGR problem or what kind of problem it is. Have a 2005 Chevrolet Avalanche with Reduced Engine Power light coming on, a year ago we replaced the throttle body sensor after it was...


2005 Chevy Avalanche.And you did the Throttle body sensor. Reduce power light coming on, APP and TPS that a shot in the dark, As for the EGR if that is a problem The vehicle is a speed density it also uses a MAF (mass air flow) . Whenever that light comes on I'm finding it in the transmission parameter not the TPS or APP (accelerator pedal position) first the 2005 Transmission has a high failure record, There is a transmission pressure control solenoid that is given wrong input data and send the transmission to self destruct. If this is your second problem similar to last year go ahead put a throttle body sensor, but the APP need to be in sequence with it. As for the EGR no it wont cause sluggish failure it is monitored by the MAF if the MAF fails then its back up by the MAP. For the reduced power light get the ECM reflashed

Apr 25, 2011 | Chevrolet Avalanche Cars & Trucks

1 Answer

My 2003 chevy truck goes into limp mode and pulls code PO220.Where is the tps sensor located?


Symptoms - Engine Light ON (or Service Engine Soon Warning Light)
- No throttle response Possible Causes - Harness or connector (The TP sensor circuit is open or shorted.)
- Electric Throttle Control Actuator (or Throttle Body Motor)
- Accelerator Pedal Position Sensor (APP) P0220 Description Electric Throttle Control Actuator consists of throttle control motor, throttle position (TP)sensor, etc. The throttle position sensor responds to the throttle valve movement.
The throttle position sensor has the two sensors. These sensors are a kind of potentiometers which transform the throttle valve position into output voltage, and emit the voltage signal to the ECM. In addition, these sensors detect the opening and closing speed of the throttle valve and feed the voltage signals to the ECM. The ECM judges the current opening angle of the throttle valve from these signals and the ECM controls the throttle control motor to make the throttle valve opening angle properly in response to driving condition.
When is the code detected? An unexpected voltage from the TP sensor is sent to ECM.

Dec 08, 2010 | 2003 Chevrolet Silverado 1500

1 Answer

Truck wont start


Is it getting fuel?
is it getting spark?


as for the code.........here is the code list for gm vehicles



Code: Meaning:
12
No Distributor pulses
13
Oxygen sensor
14
Coolant Temp sensor circuit
15
Coolant Temp sensor circuit
21
Throttle Position Sensor
22
Throttle Position Sensor
23
Manifold Air temperature sensor
24
VSS (Vehicle Speed sensor)
25
Manifold Air temperature sensor
32
EGR system
33
MAP sensor or MAF sensor depending on engine
34
MAP sensor or MAF sensor depending on engine
35
Idle Air Control Valve
36
MAF Burn-off circuit
41
No Distributor pulses, cylinder select error
42
Electronic Spark Timing or Bypass fault
43
Electronic Spark Control fault
44
Lean exhaust
45
Rich exhaust
46
VATS system fault
51
PROM fault
52
CALPAK fault
53
System over-voltage
54
Fuel pump circuit
55
ECM fault
61
Oxygen sensor fault (degraded sensor)




Jul 17, 2008 | 1990 GMC Sierra

Not finding what you are looking for?
2006 Kia Sedona Logo

Related Topics:

268 people viewed this question

Ask a Question

Usually answered in minutes!

Top Kia Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

yadayada
yadayada

Level 3 Expert

74945 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7697 Answers

Are you a Kia Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...