Question about 1995 Nissan Quest

1 Answer

How do I replace the flasher unit on a 1996 Nissan Quest?

I need to replace the flasher unit on a 1996 Nissan Quest. I've already purchased the replacement and I've looked in all 3 of the fuse boxes, but I can't find anything referring to the turn signals on the fuse map. Can anyone tell me where the flasher unit is located, and what the procedure is for replacing it? Thanks!

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 60 Answers

Flasher unit should on the side lower panel next to to hood release hatch open the side panel and its there on the side bolted its stated flasher unit

Posted on Jun 05, 2010

  • alangossett Jun 05, 2010

    Thanks Topmark, that's what I needed to know. I see there are five similar sized units off to the right of the fuses, but they are not listed on the fuse diagram so I wasn't sure if one of them might be the flasher.

×

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I am changing over all turning signal lights to leds and I need to change flasher unitflasher unit


You need to install a solid-state flasher(usually for trucks that pull a trailer occasionally,but not always).This allows the flasher to switch on/off at the same rate regardless of how many bulbs are connected(incadescent bulbs pull more amperage,making a bimetal filament flasher cycle too fast).You will use the solid state type for the opposite reason(LEDs do not pull enough amperage to heat the filament and cycle the flasher).You may have to search for the right type to fit your Nissan(there are two and three wire flashers).

Nov 26, 2013 | 1995 Nissan Quest

1 Answer

Where is flasher unit


1995 Nissan/Datsun Truck Quest Mini Van 3.0L SFI 6cyl

The Flasher is located: Front seating area, driver side, under dash, passenger side of steering column, mounted behind instrument cluster.

Nov 26, 2013 | 1995 Nissan Quest

1 Answer

Where is the turn signal flasher located for a 2000 Nissan Quest


2000 Nissan/Datsun Truck Quest Mini Van 3.3L SFI 6cyl


Flashers

Print
The turn signal/hazard lamp flasher is located behind the driver's side of the instrument panel to the right of the steering column.on the fuse block
REPLACEMENT
  1. Disconnect the negative battery cable.
  2. Locate the flasher assembly under the driver's side of the instrument panel. Press the tab on the flasher and slide it from the bracket.
  3. Detach the flasher from the electrical connector and remove the flasher from the vehicle.
  4. The installation is the reverse of the removal.

Nov 04, 2013 | 2000 Nissan Quest

1 Answer

1996 Quest: how many miles to replace timing belt for nissan q...


it's a freewheeling engine. Interval is 105,000 but most go to 160,000 easily.

I would just kep driving, no engine damage will happen if it breaks. engine will just stall.

http://groups.yahoo.com/group/villagerquest/

May 18, 2010 | 1996 Nissan Quest

1 Answer

I need to know where the signal light flasher is located on a 1993 nissan quest


It is behind the left kick panel by drivers foot. It pulls away and exposes a steel bracket with 3 cans on it. The Lucas black plastic case id the flasher. It is easier to remove the screws and the bracket to expose the release clip for the flasher.

go here too. please rate. thx.

http://groups.yahoo.com/group/villagerquest/

May 12, 2010 | 1993 Nissan Quest

3 Answers

Nissan Quest 1996 won't start. Battery good.


tap the starter at the same time turning the key. if it starts ,replace starter.

Mar 14, 2010 | 1996 Nissan Quest

2 Answers

Where is the flasher relay for an 01 Nissan Quest? not certain where it is and which one.


M11 location near left side of steering wheel near the middle of the column

Combination Flasher unit.
3 wire Color
Orange
Purple
Red


let me know

Sep 20, 2009 | 1995 Nissan Quest

1 Answer

1996 nissan quest not firing I already replaced the distributor


dont think all your message is on here dont know if you have replaced the coil or not but i think it could be ignition timing could be out or plugs could be faulty or leads hope i have helped you

Apr 01, 2009 | 1996 Nissan Quest

1 Answer

Replacing belts after replacing water pump on 1996 nissan quest x


the easist way is to loosen the alternator slide the alternator down then slide the belt where it should go then pull up on the alternator again and bolt up Please rate my response thank you very much

Jan 29, 2009 | 1996 Nissan Quest

1 Answer

Nissan Quest 1996 minivan


you need to remove the lower balljoint and the center nut and it should come right out. use pb buster or wd-40 on the splines. they tend to rust up

Oct 02, 2008 | 1996 Nissan Quest

Not finding what you are looking for?
1995 Nissan Quest Logo

715 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

75005 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

705 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...