Question about 1999 Dodge Ram

1 Answer

Should I use tefon tape when installing coolant temp sending unit on 1997 Ram 5.2

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 2,317 Answers

Yes, or some silicone sealer on the threads.

Posted on Jun 04, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the heat sensor on a ford thunderbird 1997 4.6 liter


On the 4.6L, the coolant temp. sending unit is one of two at the front of the intake manifold. The one on the left is the coolant temp. sending unit(gauge). The one on the right is the coolant temp. sensor(computer).

Jul 09, 2014 | 1997 Ford Thunderbird LX

1 Answer

After my 96 ram 1500 318c.u. gets up to temp. the temp gauge keeps going up. it never has over heated but i dont drive it very far. ive replaced upper and lower hoses, thermastat and radiator cap. Im lost?...


Thanks for choosing FixYa and welcome. That would be my next guess. Maybe a bad coolant sensor. You might have a bad water pump as well. Make sure the fans are kicking on properly also. Check your radiator.

Apr 22, 2011 | 1997 Dodge Ram 1500 Club Cab

1 Answer

My temp guage shows 130 to 135 but temp is at 197


Change the engine coolent temperature sending unit.Good Luck.

Dec 08, 2010 | 1997 Dodge Ram 1500 Club Cab

2 Answers

Engine temp


try skewing the engine coolant temperature sensor with a multi-meter and a temp vs resistance or voltage chart. the ect could be out of range and not set a code. also check actual engine temp with an infrared thermometer. hope this helps

Jan 26, 2010 | 1997 GMC Jimmy

2 Answers

Truck runs rich, black smoke, it seemed to have started once we changed the thermostat.Someone said it is limp mode? or bad ground Any ideas Randy


sounds like your coolant temp sending unit may have failed and the pcm is not getting the correct engine temp to govern the air/fuel mixture. this is not the coolant temp sensor for the radiator fan,that is a separate sending unit. what temp thermostat did you install? it should be a 190-195 degree to keep the coolant temp correct and help with the emissions.

Nov 01, 2009 | Dodge Ram 150 Cars & Trucks

1 Answer

I have a 1989 Ford F 450 Super Duty, 7.3.L DSL Can you tell me where the Oil Pressure sending unit, and the Water Temp. sending unit are located at on this motor? The Oil Pressure gauge is only fluttering...


oil pressure sending unit is close to oil filter.temp sending unit on front of intake.check fuses for temp sending unit and coolant temp gauges if all is good make sure grounding is good.if grounds good your gauges is faulty.

May 13, 2009 | 1999 Ford Super Duty F 450

1 Answer

Water temp gauge for 1997 saab 900s in not working.


Have you tried replacing the coolant temp sensor?

Apr 18, 2009 | 1997 Saab 900

1 Answer

2001 Jeep Grand Cherokee Engine temg gauge not working


If you changed the coolant temperature sensor and it had a 5 volt ref signal to it then you replaced the wrong part. You need to replace the coolant temperature sending unit.  The coolant temp "sensor" is an input to the ECM for your fuel injection system. The coolant temp "sending unit" is for coolant temp reading at the gauge, It is an NTC switch (negative temperature coefficient) which means as temp increases/resistance decreases. 

Dec 19, 2008 | 2001 Jeep Grand Cherokee

Not finding what you are looking for?
1999 Dodge Ram Logo

Related Topics:

55 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

74945 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7697 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...