Question about 1997 Ford Thunderbird LX

1 Answer

Want to remove the motor from my 1997 ford thunderbird and replace same. Can I remove motor and tranny at same time? I have been told I have to remove motor and tranny seperately...

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 22 Answers

I have had my engine out (1991 Cougar 5.0), and I did it separately. I do not think both could be removed at the same time with a conventional engine hoist. It is a pain separating them. Be sure to replace the rear main seal!!

Posted on Jun 04, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Iam no mech but is it hard 2 change the motor n transmission mounts in a 96 ford thunderbird 3.8 engine if it is whats the going price 2 do so i dont get taken


It is fairly easy to do if you have a lift, but it is possible to do on the ground with a jack and jack stands. You will need to be able to unbolt both sides of the mount and support the engine with the jack while you replace the mounts. If you download the autozone app to a smart pone or tablet it will give you a repair estimate calculator,

Mar 09, 2018 | Ford Cars & Trucks

1 Answer

Can you tell me where the fuel pump is located and how to remove it from a 1997 Ford Thunderbird?


dude have someone sit in car set ebrake crank motor and you reach under car and give a good smack in the middle of the fuel tank if car starts replace fuel pump or have some one crank it check the fuel pressure valve on the fuel rail see if there is fuel if no fuel replace pump

May 20, 2014 | 1997 Ford Thunderbird LX

1 Answer

My 1997 ford thunderbird stalls, idles rough, backfires, and has trouble accelerating


it could be as simple as your spark plugs, they may need to be checked for proper gaping and also check to make sure plugs are installed properly, could also be your timing might be off, could also be the throttle position sensor, these could all be effecting the fuel to air ratio, I would start with the easiest problem 1st......hope this was of some use to you.....

Jul 08, 2012 | 1997 Ford Thunderbird LX

1 Answer

1997 ford thunderbird won't pass inspection


has the cataletic converter been punched out to make it more like a resignator?

Jun 04, 2012 | 1997 Ford Thunderbird LX

1 Answer

Do i have to remove my timing belt in order to replace my water pump in my 1997 ford thunderbird lx its a 4.6 v8


Your car use3s a timing chain not a belt. The water pump will be serviced by first removing the serpentine belt and then removing the water pump pulley and then finally removing the water pump. It is a fairly easy pump to replace.

If you have any further question please ask I I will be happy to help.

Aug 14, 2011 | 1997 Ford Thunderbird LX

1 Answer

I need to get the radiator fan motor off the shroud


hello, you say the motor is hinged to the removed shroud ? I haven't seen one in a while but look at the objects. Do they have a little "crater " in the middle on one side? If it does , it is a rivet.
Take a drill with a thin bit and drill it out from that concave or crater side.
you will need to replace the rivets with new nuts and bolts. make sure you use a lock washer on the nut side with flat washers to hold the bolt tight. otherwise the vibration from the fan will loosen them quickly after replaced.

Aug 12, 2017 | 1997 Ford Thunderbird LX

1 Answer

1997 ford thunderbird 4.6 v8


check your tranny and engine mounts.
they may be bad or going bad and will create that vibration. specially the tranny ones.

Jan 22, 2009 | 1997 Ford Thunderbird LX

Not finding what you are looking for?
1997 Ford Thunderbird LX Logo

113 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

78936 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

fordexpert

Level 3 Expert

5676 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...