Question about 1998 Chevrolet S-10 Pickup
The 2.2 is a 4 cylinder and all other stock motor's for an s-10 are v6's if the motor your thinking of is a 4.3L vortec then good choise, it and a 350cid v8 use the same bell housing but u will have to upgrade to a tranny from the larger engin's to make it work, and to hadle tha added pewer reliably
Posted on Jun 06, 2010
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
Tips for a great answer:
Sep 03, 2012 | 1979 Pontiac Firebird
on Mar 16, 2010 | Volkswagen Jetta Cars & Trucks
Remove the TV cable or transmission throttle cable from the carburetor or throttle body. Remove the upper bolt holding the transmission dip stick but do not remove the tube. Disconnect the negative cable to the battery. Drain the transmission fluid by removing the transmission pan. Replace the pan after draining the fluid.
Remove the shift linkage and the wires to the neutral safety switch. Remove the speedometer cable by unscrewing the cap at the point it enters the drive gear in the tailshaft. If it has an electronic speedometer, disconnect the electrical connector.
Install the engine support stand above the engine. Remove the CV joints. Remove all electrical connectors from the transmission. Remove the bolts in the torque converter. Place the floor jack under the transmission. Raise the transmission just enough to support it. Remove the transmission mounts. Lower the transmission enough to have access to remove all the transmission bolts. On a rear wheel drive vehicle, remove the bolts in the bottom of the transmission mount. Raise the transmission enough to remove the cross member.
Once the bolts are out remove the cross member and then lower the transmission. Remove the dip stick tube from the transmission by lifting up. If it is hard to come out tap its mounting bracket with something and it will come up and out. Support the transmission securely on the jack. Using a flat head, separate the transmission from the engine. Lower the transmission.
hope this helps
but you can also just pull the motor and trans for better access ive also got an 85 chevy im about to do some work on ganna pull and rebuild the motor which is a first for me so if u know any one i could also get some tips from help would be awsome thank you
Nov 10, 2011 | Honda Cars & Trucks
Sep 06, 2010 | Ford Explorer Cars & Trucks
Oct 20, 2009 | 1996 Volkswagen Jetta
Sep 30, 2009 | 1986 Volkswagen Golf
May 04, 2009 | 1997 Ford Taurus
May 04, 2009 | 1996 Chrysler Concorde
Mar 23, 2009 | 1996 Chevrolet Blazer
Jun 02, 2017 | 1998 Chevrolet S-10 Pickup
145 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: