Question about 2004 Pontiac Bonneville

1 Answer

04 bonneville service engine soon is on how do i reset it?i have replace bad injectors and it just passes e-check (the old way)

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.


    An expert whose answer got voted for 500 times.

  • Master
  • 749 Answers

Best way to erase the codes causing the light to come on is with a scan tool or code reader.Alternatively you can disconnect the battery cables for a few minutes.This will erase codes but may also cause the vehicle to run poorly for a few minutes until the computer relearns values.If your radio has a theftlock it may require a code to be put in before it can be used again.

Posted on Jun 04, 2010


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

1997 pontiac bonneville ssei got a O2 sensor bad code, replaced the sensor and still get the same code

when all else fails go to a pep boys or Firestone, let them check it. You cant by - pass good service and new tools. Advance Auto Parts has the handheld device

Jun 08, 2017 | 1997 Pontiac Bonneville

2 Answers

Have a 1998 dodge caravan with service engine soon light still on after fixing code 205 and 206. Tried to reset it but the light will not go off. I need to pass emissions soon. What do I need to do.

The symptoms for this code (both) will likely be a misfire and a rough running engine. Poor acceleration. The MIL will also be illuminated. The causes of a P0206 engine light code could be any of the following:
* Bad injector. This is usually the cause of this code but doesn't rule out the possibility of one of the other causes
* Open in the wiring to the injector
* Short in the wiring to the injector
* Bad PCM

Your possible solutions, first, using a DVOM check the resistance of the injector. If it isn't within specs, then replace the injector.
* Check for voltage at the fuel injector connector. It should have 10 volts or more.
* Visually check the connector for damage or broken wires.
* Visually check the injector for damage.

Also, if you have access to an injector tester, activate the injector and see if it operates. If the injector operates, then you likely have either an open in the wiring, or a blocked injector. If you do not have access to a tester, swap the injector with another one and see if the code changes. If the code changes, then change the injector.

At the PCM, remove the driver wire from the PCM connector and Ground the wire. (Make sure you have the correct wire. If you're not sure, do not attempt) The injector should activate
* Replace the injector

Hope helps.

Aug 08, 2011 | 2001 Dodge Caravan

1 Answer

1996 bonneville keeps missing what about MAP sensor ? MAS replaced Plugs replaced throotle posistion sensor also

have you isolated what cylinder is causing the misfire . You need to check the coils for proper spark at each plug. If you have spark then you will need to check each injector for proper fuel. you can do this by unplugging each injector one at a time to try to isolate which cylinder the missfire is on
or you can have your local parts store scan the car and tell you what code is stored . Most misfire with cause a service engine soon light to come on if the light is on then there is a code store .

Mar 06, 2011 | 1996 Pontiac Bonneville SE CA Value

2 Answers

Engine skipping when at an idle or at a steady running?

There are a few reasons this could happen. I would first check that you plug wires are on well. If they are I would check the plugs and replace if needed. let me know if that helps, if not let me know and I'll tell you a few other things to check

Oct 07, 2010 | 1996 Pontiac Bonneville SE CA Value

1 Answer

Service engine soon code 3rd. cyclinder miss

sorry but,,if u have a miss fire in #3 ,,that's coil or wire or plug or injector,,,dont know y they replaced the battery or alt unless they were bad??? hope it helps

May 24, 2010 | 2003 Lincoln LS

1 Answer

Service engine soon light has been on for two weeks in a 2001 pontiac bonneville sle

Hi,read your car service manual,it will show you how to reset service engine light.
good luck!!!!!!!

Feb 24, 2010 | 2001 Pontiac Bonneville

1 Answer

Just had brake work and an oil change on my 2000 bonneville, and now the service engine soon light is on. could it just need to be reset?

Most Likely, yes. If there was a real problem, the "Check Engine" light would be on. This one is just a service interval reminder light.

Nov 20, 2009 | 2000 Pontiac Bonneville

Not finding what you are looking for?
2004 Pontiac Bonneville Logo

370 people viewed this question

Ask a Question

Usually answered in minutes!

Top Pontiac Experts


Level 3 Expert

78267 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8836 Answers

Are you a Pontiac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides