Question about 1999 Chrysler Sebring

1 Answer

1999 chrysler sebring convertible jxi code p1495 intermittant shut off while driving. Replaced fuel pump and filter, distributor, spark plugs and wire. Was advised by ZJLimited to remove connector from the solenoid (back wall, just to the dirver's side of the air-hat). Check the harness & measure the voltage coming fromthe harness and the resistance of the solenoid. Where is the "leak detection pump solenoid" located on the 99 chrysler sebring jxi convertible located? It is not on the back wall of the driver's side by the Air Hat. (What is air-hat? do you mean Air Filter?) Please advise. Are you sure it is not on top of the gas tank?

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 1,297 Answers

Replacing the fuel pump relay is one thing but what about the (ASD auto-shut down) relay

additionally...

  • what engine size?
  • what transmission?
  • any codes?
  • does the pump run KOEO?
  • Do you have spark?
  • What is the cranking speed?

you may find faster service by subscribing to a "live chat" since there are so many questions and variables in your concern

Posted on Jun 04, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the fuel filter on a 1996 chrysler sebring convertable jxi


Inside of the fuel tank. Everything is together as a unit...your fuel pump, fuel pressure regulator, and fuel filter.

Feb 11, 2016 | 1996 Chrysler Sebring

2 Answers

My 1998 chrysler sebring convertable wont start I replaced the fuel filter and fuel pump new battery the car will turn over just wont start


Verify you have spark, those are known to have issues with the camshaft sensor in the distributor. I have put 2 distributors in my daughter's 97 sebring jxi, did the same thing.

Jul 22, 2014 | 1998 Chrysler Sebring

1 Answer

I cannot find my emergency fuel pump shut off switch for my 1999 chrysler sebring jxi


Hi

Fuse # 8 in the power distibution center, under the hood should be checked since it powers the fuel pump relay and the engine startet motor relay.

Good Luck

Rodney

Jun 13, 2011 | 1999 Chrysler Sebring

1 Answer

1999 sebring dies after driving but will start after it sets for a while


I had same exact problem with my 1999 Sebring Convertable jxi, Problem ended up being a bad Crankshaft Positioning Sensor

Dec 20, 2010 | 1999 Chrysler Sebring

2 Answers

My 2000 Chrysler Sebring JXI cuts off while i am driving, or stopped, have replaced the fuel pump, fuel relay, fuel filter care still cuts out...please help !!


WE HAVE THE SOLUTION.

WE ALSO HAVE A 2000 SEBRING CONVERTIBLE JXI

REPLACE THE IAC AND EGR VALVE, REPLACE ALL SPARK PLUGS AND WIRES; THREE SPARK PLUG ARE HIDDEN UNDER THE MANIFOLD.

CAR NOW RUNS PERFECT!!!!!!

Sep 15, 2010 | 2000 Chrysler Sebring

1 Answer

1999 Chrysler Sebring Convertible code P1495. I


Code 1495 = Leak Detection Pump Solenoid Circuit

Remove the connector from the solenoid (should be on the back wall, just to the drivers side of the air-hat). You will have the solenoid to check and the harness. What you want to measure is the voltage coming from the harness and the resistance of the solenoid.

Turn the key to the "ON" position but do not start the motor; the voltage at the connector should be at least 10V or more,.now, check the resistance of the solenoid (should be around 35 ohms).

Hope helps.

Jun 03, 2010 | Chrysler Sebring Cars & Trucks

1 Answer

Where is the fuel filter located on a 2004 Chrysler Sebring sedan?


Some of the Sebrings have two filters(one is called a sock).The sock(which all sebrings have) is located in the fuel tank itself on the pump module.If this model is the JXI then the external filter is located on the belly of the car between the tank and drivers rear seat. I hope I could help!!!

Apr 29, 2010 | 2004 Chrysler Sebring

Not finding what you are looking for?
1999 Chrysler Sebring Logo

1,257 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

76051 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8265 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...