Need to know where the crank sensor is on2000 grand cherokee is

Jeep Crank Sensor Replacement, P Codes P0351, P1391 ...

? 6:24
www.youtube.com/watch?v=7D0vUEDSwXo
May 12, 2013 - Uploaded by Robert DIY Replaced the crank sensor on this 2003 Jeep Grand Cherokee.... to replace my crankshaft position sensor on my 1998 grand cherokee laredo.

Jeep Crankshaft Position Sensor Replacement (CKP, CKPS ...

? 4:07
www.youtube.com/watch?v=1Ho5iAKQV00

Oct 27, 2013 - Uploaded by WeekendHandymen
hi , do you think if I replace crank sensor will solve the problem ,my jeep .... Where's the crankshaft located in 99 jeep grand Cherokee laredo .

you need to check if you have fuel pressure, may be a fuel pump problem

From what I researched, 93-96 4.0 6cyl will work.

More than likely needs a crank sensor, Try cranking with the crank sensor disconnected, you should not get the dashes in the cluster. The crank sensors take out the communication system of the vehicle

97 cherokee crank sensor replaced, still shuts off, code 351

i changed the crank position sesor but still doing the same wont fire over.

You need a quarter inch ratchet and a socket to fit the two bolts...You will also need about 100lbs of patience (it's a real pain to reach)
Good luick

Here's the link and I'm sure you will get the solution of your problem 1996 Jeep Grand Cherokee Service Repair Manual INSTANT DOWNLOAD

have the crank sensor replaced this controls the spark and injector pulse it is located on the drivers back side of the engine above the transmission housing!

need to know what engine but on six cylinder it is on the bell housing at the left rear of engine,on 5.2/5.9 it is on the right side behind the head in the block,and on 4.7l it is on the engine block above the starter.