Question about Chrysler Sebring

1 Answer

Car would not start, replaced crank sensor in trans. now it will start, bur misses and runs so bad you cant back it out of garage. car ran perfect until it would not start at all

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Master
  • 2,272 Answers

The car starts but misses and runs very bad this indicates that an ignition coil or spark plug may be failing or a fuel injector may be failing. Also check in the gas tank .Is the car running out of gas. Check if car is running out of gas or low on gas , dirt in the bottom of the fuel tank, clogged fuel filter, and clogged injectors. Replace fuel filter and pour a bottle of fuel injector cleaner in the gas tank.If all the above mentioned possibilities checked out OK. Then Get the car scanned at diagnosis center.At diagnosis center you will receive the error code.As per the error code it will detect the exact faulty part in the car due to which the problem is occurring.For more help :--- at you can get  your car scanned absolutely free And also they deal in parts so you can get the required parts replaced as per the faulty code received from car diagnosis.
Thanks. keep updated for any more can rate this solution and show your appreciation.


Posted on Jun 03, 2010


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

What is causing my 1996 jeep grand Cherokee to start then shut off after rough idle?

the 1 bolt sensor , must be calibrated, removing the sensor wrecked the calibration, and the sensor then gets smashed,
(1 of the 4 kinds do that)

what code,??? I cant help you lacking that. nobody can.
DTC errors what are the or what where they, forgot them?

the new sensor, from the dealer has the calibration pad on it.
after market not, and is sold separate none jeep, causes that new sensor to smash into the fly flex plate, and wreck it. (CKP wrecked)
here is the offical jeep pages, on that.



if this is yours, and now the end of it is wrecked
get new one, and use a .030" inch think spacers,
and glue it on the end. it will wipe off on first start and bam, its now perfect.

if no DTCs .using a real scan tool? or the mostly lame key on/off/on 3 times trick.
this key jive way is weak, as it will not see many errors.!!!
the key on way, can also miss , CKP and CMP errors
when you key off and engine, the key off can reset some very important errors, like P034xx p035x or any P03xx errors.
why not tell your DTCS, ????
above is on USA cars, not outside.....

Nov 01, 2016 | 1996 Jeep Grand Cherokee

1 Answer

2003 Buick 3800 engine 82,000 actual miles on it multiple/random misfire code How it started.. Car was running fine. Check engine light started flashing and engine started missing. What...

You can't rule anything out yet. It could be a plug or injector among other things, but probably not low fuel pressure. If you have a code 300 and nothing else, you may have to wait until the problem gets bad enough to set additional codes. And if any of the sensors fail, such as the cam or crank sensors, you'll get a code for those to be tested.
Have the plugs been checked or replaced in the past 30,000 miles ?

Mar 12, 2014 | 2003 Buick LeSabre

1 Answer

2000 Park avenue ultra speedo jumps sporradically and trans shifts down upon deceleration only. No ECM codes!

first : get rid of the mechanic you used . the problem is probably in the speedo head unit take out the old one and take to a reliable electronics tech . or buy a new one

Feb 26, 2014 | Buick Park Avenue Cars & Trucks

1 Answer

I have a 2007 jeep patriot. It stalled at stop sign started ran rough. Parked came back drove it home ran u- scan code p0017 replaced crank and cam sensors still runs rough changed plugs were bad. I was...

code p0017 refers to crank/ cam oosition sensor bank 1 sensor B -correlation ===causes --wiring--CKP sensor--CMP sensor--mechanical fault.
It also refers to control modules, cooling fan--no signal===causes -- wiring--ECM.
If it has a timing chain then the the advice that it will not be the chain is good. So I suggest checking out the cam/ crank sensors and wiring

Oct 22, 2013 | 2008 Jeep Patriot

1 Answer

I got a 1991 chev lumina 3.8 car i have a miss in it that i cant find u can start it up dont miss drive it five six miles clear up dont miss a lick then it start missing cut off a little while start it up...

You could have a bad injector, ohm the resistance of each one. they should all match. I am thinking maybe 14 ohms but could be wrong, check specs for your car. you need to at least narrow down which cylinder then check for spark on that cylinder while the miss is happening. some of these 3.8 engines would melt the plastic intake manifold at the egr passage and leak coolant into the cylinders, are you losing coolant?

Nov 30, 2011 | Chevrolet Cars & Trucks

1 Answer

Jeep was having trouble starting but eventually started and ran. Then just cranked but didnt turn over and run. I replaced starter, that didnt work. Then replaced crank position sensor, and that seemed to...

Just wondering if the senor could be a bad one. Open your gas cap and turn your ignition on and have someone back there to listen into the filler tube. They should hear the fuel pump kick on, if not you problem is it. I had a jeep and did all the work on it, including a new fuel pump, crank sensor, water pump, radiator and everything else. GOOD LUCKKKKKK

Oct 09, 2010 | Jeep Cherokee Cars & Trucks

2 Answers

2001 jeep grand cherokee 4.0 engine shuts off

it is possable/likely a bad ECTS (engine coolant tep. sensor), this can cause the injectors to allow to much fuel into cylinders and cause a low compression and or flooding situation, good luck, marty

Jun 07, 2009 | 2000 Ford Focus

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

14 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts


Level 3 Expert

79186 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers


Level 3 Expert

814 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides