Question about 2005 Dodge Ram 2500 Truck

1 Answer

2005 dodge ram 2500 a/c blower dosent kick on replaced the blower variable resistor. checked the fuses still dosent kick on the morot is good i hot wired it to test but only in high what am i missing ?

Posted by on

  • Anonymous Mar 19, 2014

    What can be done jvc screen7" dosent fit on a 2005 dodge ram?

×

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

I am having the same issue. I can wiggle my keys in the ignition when it is not started and get the blower to come on. I am assuming it is ignition relay.

Posted on Jun 14, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1992 Dodge Dakota 2wd 3.9L V6 Air conditioning/Heater dosent blow? when i turn the air or the heat on i can hear the compressor kick on but it dosen't blow cold or hot? any help would be appreciated


Roger it sounds like the blower motor is not comming on. There is a resistor network located in the engine compartment on the passenger side mounted to the firewall, that controlls the blower motor. The connections may have corroted or the unit itself is bad. That was the first thing I had to relpace when I got my used 92 Dakota. There is also a 30 amp fuse in the fuse box under the dash board . If that is blown I would suspect the blower motor is seized up or just pulling too much power.

Nov 29, 2011 | 1992 Dodge Dakota

1 Answer

I have a 2001 Dodge ram 2500 gas 360 cube. My fan switch works on the high setting for the blower. If you turn to any of the 3 remaining lower speeds it shuts the blower off completly. Are there any other...


Yes, there is one under the hood on the heater box. It has a plug going directly into it (5/6 prongs I think). The plugs have a reputation for going bad as well as the resistor. For some reason they overheat and melt. You can unplug it and make a diagram of where the wires on the plug go, cut it off, and wire them individually. Or, you can locate a salvage yard that might still have one left. As well as the resistor. I hope I've helped. If so please rate my assistance and leave a testimonial.

Dec 28, 2010 | 2001 Dodge Ram 2500 Truck

1 Answer

My ac is very cold but doesn`t blow very hard even on high why and what is the fix. sam


the problem is the blower fan. it is either the resistor or the fan blower itself. check for power at fan, if power check fan resistor. if these check out ok, then it is in the switch.

Jun 19, 2010 | 2005 Dodge Ram 2500 Truck

1 Answer

2006 dodge 2500 diesel blower resistor, where is


Dear,

Check the attached Picture and you find the location.

Regards,
Eng. Ghassan Alasmar


ghassun_0.gif

May 12, 2010 | 2006 Dodge Ram

1 Answer

Heater blower motor only runs on the highest setting. I have replaced the blower motor itself. What could be the problem?


if you are getting only one speed from the blower motor then it would be the (blower motor resistor) causeing the problem. the blower motor resistor is located under the dash on the passenger side next to the blower motor. unplug connector and remove two screws from housing. to test the resistor connect a continuity tester to the resistor. check between the input to the output sides of the resistor for continuity. if not replace the resistor.

Apr 12, 2010 | 2005 Dodge Ram 2500 Truck

1 Answer

03 ram 2500 blower will not work at all changed blower, resitor and control still nothing all fuses are good


Check the connector that attaches to blower resistor. For a melted plug, corroded terminal and wiring. This is a very common with problem.

Jul 14, 2009 | 2003 Dodge Ram Maxi

Not finding what you are looking for?
Cars & Trucks Logo

287 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8273 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...