Question about 1997 Buick LeSabre

1 Answer

How do you disconnect the lift wire and lock the passenger side windows in the up position on a 97 Buick Le Sabre?

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 65 Answers

On gm products the drivers door is the master door .the wires run through the switch there before they goto the pass door. pretty easy to figure the wires out.if you cant a local stereo shop thats a viper security dealer can get you a wire diagram for the whole car..ie best buy etc.

Posted on Jun 03, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

The electric windows and door locks only work on drivers side of a 2000 buick le sabre limited. why?


The passenger side locks an windows don't work with thier own switches ? Check for B+ voltage at the front passenger door module . Do you know how to do that ? You need to take the front right door panel off . Check for a broken wire inside the rubber boot from the body to the door .
Power Windows
The vehicle is equipped with power windows controlled by the door modules. The DDM receives a window switch request, over the SBI serial data, from either the passenger door module wired to the window switch pressed or from the driver door switch assembly. The DDM checks the Class 2 serial data to see if the status information is correct (i.e. ignition switch position) to permit window operation.
If the status information to permit window operation is correct, the DDM sends the command to the door module controlling the window to move the window as requested.

May 21, 2017 | Buick Cars & Trucks

1 Answer

How do I change a starter for a 2005 buick le sabre


  1. Disconnect the battery negative cable.
  2. Raise and support the vehicle. Refer to Vehicle Lifting.
  3. Remove the torque converter cover.
  4. Disconnect the battery positive cable from the starter.
  5. Disconnect the wire from the solenoid S terminal on the starter.
  6. Remove the 2 starter motor mounting bolts.
  7. Remove the starter motor.

Sep 20, 2014 | 2005 Buick LeSabre

1 Answer

How to replace drive/serpentine belt for '97 buick le sabre 3.8? do u have to remove engine mount/bracket or just engine mount?


You don't have to remove the mount. Go thru the wheel well on the passenger side and remove the motor mount bolt just right of the crank pulley. Then remove the stud that the nut was on. Then remove the sleeve that the stud goes thru. Then you can change the belt.

Sep 18, 2010 | 1997 Buick LeSabre

1 Answer

Defroster / heater fan won't shut off /1995 Buick Le Sabre


Moe, I think you hi blower relay is bad. With this I mean the contacts in the relay are welded shut and you should replace the relay if the blower is on high all the time. Do this by removing the black plastic cover right behind the engine and removing the relay all the way to the drivers side of the relay bank. you will have to insert a small screwdriver under the relay and bend the little tang that holds the relay in place. then slide the relay out towards you and remove the green lock tab and unplug the relay from the wiring harness. if the blower finally stops then just insert a new relay in its place and reassemble in the reverse order. Good luck.

Dec 31, 2009 | 1992 Buick LeSabre

2 Answers

I have a 2001 buick le sabre. The rear widow does


That is the problem....however the cable spun off the spool and you need to buy the power window assy. On line it was a good fair price (about $35-50) it has 3 studs that holds it to the inside door and 2 bolts at the window that secures the assy to the window. All work can be completed in 30 mins..

Sep 09, 2009 | 2001 Buick LeSabre

1 Answer

Passenger side window dont work


Each window has a little motor that powers it. This may need to be replaced. If you can hear the motor running then the window could have fallen off the track

Sep 09, 2009 | 1993 Buick LeSabre

1 Answer

97 buick le sabre turns over but wont start


Good Morning,
The coil pak is usually the problem with these buicks. You can buy a new one at your local auto zone store for around $50.00 and you can install it yourself in about 20 minutes! It just might be a quick fix without paying a mechanic to diagnose it. If you decide to install a new coil pak remember to disconnect one side of the battery first and above all only replace one spark plug wire at a time. Please let me know if I can be of further help and thank you for using FixYa!

Mar 23, 2009 | 1997 Buick LeSabre

Not finding what you are looking for?
1997 Buick LeSabre Logo

116 people viewed this question

Ask a Question

Usually answered in minutes!

Top Buick Experts

yadayada
yadayada

Level 3 Expert

76109 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8270 Answers

Are you a Buick Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...