Question about 2001 Lincoln LS

1 Answer

I have a 2001 lincoln ls. A while back my sunroof stopped working properly. It will go up in vent mood but wont open fully in the backwards position. I found 2 black metal bars 1 on each side of the frame that have com loose completly. I looked for the bars on the ford parts site but they are not even in the window schematics

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Lincoln Master
  • 17,970 Answers

For Lincoln LS 2000-2005 check this procedure to repair...

Moonroof - Power Moonroof

I have a 2001 lincoln - 25b1bdd.jpg

Fig. Power Moonroof exploded view


Motor Initialization Procedure

  1. Before servicing the vehicle, refer to the Precautions section.
  2. Turn the key to the ON position, then begin moving the glass panel using express open or express close.
  3. While the glass panel is moving, press and hold the tilt switch for 10 seconds.
  4. The glass stops as soon as the switch is pressed.
  5. After 10 seconds, release the tilt switch.
  6. Press and hold the tilt switch.
  7. The glass will move to full tilt position and stop, but do not release the tilt switch.
  8. Continue holding the tilt switch for an additional 10 seconds. After 10 seconds, release the tilt switch.
  9. Press and hold the tilt switch.
  10. The glass panel is driven in the tilt up direction to the tilt up hard stop.
  11. The drive recognizes a hard stop has occurred.
  12. The drive reverses the glass panel to the normal tilt up soft stop position.
  13. After the glass stops, release the tilt switch.
  14. Within 5 seconds of releasing the tilt switch, press and hold the switch.
  15. The drive moves through the full closed position to the full open position and back to full closed.
  16. Test the express open and express close using the switch.

Removal & Installation
Motor

NOTE Make sure the roof opening panel glass does not move during the motor removal or installation. The roof opening panel timing may be affected and cause the roof opening panel glass to bind.
  1. Before servicing the vehicle, refer to the Precautions section.
  2. Remove the overhead console and disconnect the 4 electrical connectors.
  3. Disconnect the roof opening panel motor electrical connector.
  4. Remove the 3 screws and the roof opening panel motor.
  5. To install, reverse the removal procedure.
  6. If the roof opening panel glass moved while the roof opening panel motor was removed, perform the motor initialization procedure

Hope helps.

Posted on Jun 02, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2001 cadillac deville sunroof open and want close


Check the RAP fuse in the rear fuse box , this fuse powers the sunroof control module ! Fuse Block - Rear , Left rear of the passenger compartment, under the rear seat .
The sunroof module contains the logic for the opening and the closing of the sunroof. The sunroof motor assembly contains the reversible DC drive motor, the gear train, and the limit switch.
The sunroof module determines the sunroof motor direction based on inputs received from the overhead console sunroof switches. When the ignition switch is in the ON position or when retained accessory power (RAP) is active, voltage is applied to the sunroof module via the RAP relay. For a description and operation of the RAP system, refer to Retained Accessory Power (RAP) Description and Operation in Retained Accessory Power. The sunroof module controls the sunroof motor direction by changing the polarity of the applied voltage. The sunroof module remembers the sunroof position whenever the ignition switch is turned to the OFF position. The limit switch is used as an input to the sunroof module to indicate that the glass is fully closed, or in the comfort stop positions. The limit switch is grounded when the sunroof glass is in the fully closed or comfort stop positions, otherwise it is open.
The SLIDE CLOSE mode is initiated by moving and holding the sunroof slide switch (ROOF) forward. This applies a ground provided from the sunroof limit switch low reference circuit to the sunroof switch close vent signal input of the sunroof module. The sunroof module controls voltage to the control circuits of the sunroof motor. The sunroof motor will run until the limit switch contacts are closed. The closing of the limit switch will apply the sunroof limit switch low reference circuit to the sunroof limit switch soft stop signal circuit to the sunroof module, indicating the flush closed position has been reached. As the sunroof is approaching the close position the sunroof glass will force the wind deflector downward.
You need to have a factory scan tool hooked up an have it checked for DTC'S in the sunroof control module ! a code reader will not do this , a code reader will only check the engine codes for OBD 2 .
Important: The following must be completed before using the symptom tables.
  1. Perform Diagnostic System Check - Power Sunroof in order to verify that all of the following are true:
  2. ?€¢
    No DTCs are set.


    ?€¢
    The control modules can communicate via the serial data link.

  3. Review the system operation in order to familiarize yourself with the system functions. Refer to Sunroof Description and Operation
your better off taking to the dealer !

May 09, 2015 | 2001 Cadillac DeVille

1 Answer

Good morning I have a 2001 lincoln ls all my windows and sunroof stopped working I when to message center on the message center it says merry feature data error can you please help me out


I have an 2001 Town Car and that happened to me. I checked the fuses listed in book. Sorry but I needed to take to dealer to fix. Hope you get better help.

Apr 02, 2015 | 2001 Lincoln LS

1 Answer

I have a 2001 lincoln ls v8 my sunroof will slide back but when you close it it will close but it wont raise up to close all the way can someone help and tell me how to fix it


Start by making the tracks slicker with parafin, bees wax or graphite. If the motor is weak, you can run a larger positive wire going to the motor. If those don't work, you may have to replace the motor.

Jan 05, 2015 | 2001 Lincoln LS

1 Answer

2001 yukon xl which fuse is the sunroof fuse


In the under hood junction box , fuse CTSY LP 15 amp . Instrument fuse panel PWR WDO CB 25amp .
Sunroof Motor Synchronization
Synchronization will be necessary anytime the sunroof module battery positive voltage circuit is interrupted. The sunroof module will be synchronized when the controller learns the full vent position. The sunroof system will ignore any open request until the system has been synchronized.
To synchronize the sunroof:
  1. Turn ON the ignition, with the engine OFF.
  2. Using the close/tilt up portion of the sunroof switch, operate the sunroof glass until it reaches the full vent position.
  3. Verify that the system operates normally.
Once the sunroof glass reaches the full vent position, the actual position is stored in the memory of the sunroof module. The sunroof module will stop the motor one motor revolution before the defined actual positions
Hope this help ! good luck !

Dec 24, 2014 | 2001 GMC Yukon XL

1 Answer

Lincoln ls sunroof


sounds like its a slight adjustment . There is 3 torque screws on the left and right side that you must loosen . Use a silicone lube to spray or rub on the sunroof weather stripping . place roof even or dead flush with the body of the car and tighten in the close position

Mar 14, 2014 | Cars & Trucks

1 Answer

Moonroof wont close all the way


Do you know how to test automotive electrical circuit's with a DVOM - digital volt ohm meter ? When adjusting the moon roof did you see any switches ? sunroof limit switch
Measure the reference voltage of the sunroof limit switch soft stop signal circuit at the sunroof control harness connector to a good ground.
Does the reference voltage measure near the specified value?
4.5-5.5 V
Notice: Do not open the sunroof glass past the full open soft stop position. Doing so may damage the sunroof assembly and or the roof top.
Connect a jumper wire to the sunroof limit switch soft stop signal circuit at the sunroof control module harness to a good ground.
Turn ON the ignition, with the engine OFF.
Using the sunroof switch, operate the sunroof system, not to exceed the full open soft stop position.
Does the system operate as requested?

Do you know what a wiring diagram is ? Free one's here
http://www.bbbind.com/free_tsb.html Enter vehicle info. year ,make ,model an engine size . Under system click body & accessories ,then under subsystem click on sun roof . Click the search button then the blue link . See the control module , motor an the two switches ? One is probably miss adjusted . or bad !

Power Sunroof System Components
The power sunroof system consists of the following components:
• Sunroof control module
• Sunroof motor with the limit switches
• Sunroof switch
• Sunroof glass-spoiler type, with glass sliding above roof
• Sunshade
• Rail and track assembly upon which the sunroof glass rides
• Power sunroof system circuit breaker: PWR WDO 25 A
• Ground: G204

Sunroof Limit Switches
The sunroof limit switches track the position of the sunroof glass through two limit switches:
• Soft Stop limit switch through the sunroof limit switch soft stop signal circuit
• Vent Stop limit switch through the sunroof limit switch range signal circuit
The sunroof control module monitors the limit switches and based on the input combinations, determines the position of the sunroof glass. As a sunroof limit switch closes, the 5 volt reference will be shorted to the sunroof limit switch low reference circuit, pulling the 5 volt reference to 0 volts.
The sunroof control module monitors both sunroof switch input requests and based on the sunroof limit switch input combinations, will control an output to the sunroof motor, to drive the sunroof glass to the requested position.

Sunroof Motor
The sunroof has a bi-directional motor. When the motor is not operating both circuits are grounded. When the motor drives the sunroof glass in the direction from the closed to vent or vent to open position, the following occurs:
• Voltage is supplied to the sunroof motor open circuit.
• Ground is maintained to the sunroof motor close circuit.
When the motor drives the sunroof in the direction from the open to vent or vent to closed position, the following occurs:
• Voltage is supplied to the sunroof motor close circuit.
• Ground is maintained to the sunroof motor open circuit.
The sunroof control module is equipped with a timer circuit which stops the operation of the sunroof motor after 8 seconds.

Dec 23, 2017 | 2003 Pontiac Sunfire

1 Answer

2000 Lincoln Ls


replace your roof relay it controls both the up / down and, forward / backward motors

May 03, 2009 | 2000 Lincoln LS

1 Answer

2002 Oldsmobile Alero Sunroof Stuck in the Vent position


The sunroof continues to open and close normally from front to back, but the vent stays open.

Apr 01, 2009 | 2001 Oldsmobile Alero

Not finding what you are looking for?
2001 Lincoln LS Logo

Related Topics:

2,497 people viewed this question

Ask a Question

Usually answered in minutes!

Top Lincoln Experts

yadayada
yadayada

Level 3 Expert

80637 Answers

fordexpert

Level 3 Expert

5687 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Are you a Lincoln Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...