Question about 2006 Dodge Charger

1 Answer

2007 Charger Turns on, all ok, but will not go

2007 Charger Turns on, all ok, but will not go out of park to drive or reverse. Break also feels a bit tighter then before

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.


    An expert who has answered 1,000 questions.

  • Master
  • 1,374 Answers

Hopefully its still under warranty! its either the shifter / cable needs adjusting or gear lock button is seized.
Shifter release is on the brake pedal. I recommend taking it to a repair shop UNLESS its under warranty and watch what they do cause this will happen again.

Posted on Jun 02, 2010


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

2 Answers

Ford Ranger won't move?

you might need a new whole transmission or new brakes or brake fluid.

May 03, 2016 | 2003 Ford Ranger Regular Cab

1 Answer

For some reason my 98 honda accord 2.3 engine. Its starting to jerk slightly when I drive over 45 miles an hour nd I break to a complete stop thats when I feel the jerk. Sometimes the jerk can be harder...

Front brake rotors need to be turned and new pads. Adjust rear brakes. the front brakes are doing all of the stopping. (overheating the rotors, premature pad wear).

May 20, 2017 | Cars & Trucks

1 Answer

Why my Mazda 5 2006 model sometimes its hard to shift the gear from Park position to Drive every time I start the car even I press the break pedal hard. I need to pump the break manny time before its shift...

I had the same exact problem a few months back. I found that if you look up high on the brake pedal, you will find a switch that it hits to activate the brake light. This also serves as an interlock switch for you to switch the vehicle out of park. There are plastic tab holding the switch in place to replace it. They are a bit pesky. Once you get it loose, you can follow the wires coming from it and unplug it. Once that is done.. you just reverse the process and install the new one. Putting the new one back in went much faster for me. Its about a 1 hour job at most and the part runs about $18 from the dealer. Have fun!

Feb 28, 2011 | 2007 Mazda MAZDA5

1 Answer

Hi, I own a 1997 Ford E 350 Econoline, I have the following transmission engagement problem: Truck will not start: Transmission will not engage any gear, neutral or park. The shift lever feels like is not...

The weld on the manual lever is known to break loose. First, with the wheels off the ground, with the lever in the park position, does the drive shaft lock in park? If yes or no sometimes, drop the trans pan. I bet the nut on the lever camd loose.

Mar 31, 2010 | 1994 Ford Econoline

2 Answers

2007 dodge charger stuck in park, won't shift

This is a recall defect look it up on i just stumbled upon this website today triying to find a solution to my problem.

Apr 25, 2009 | 2006 Dodge Charger

1 Answer

Wont go into reverse

good morning and welcome to fixya
very nice car. dumb question for you, is the car still under any warranty that covers the drivetrain? it sounds like to me that the reverse shift solenoid has either one gone bad or two the wire harness going to it has an issue. are there any check engine lights on, if so have those been recovered and diagnosed yet? does the vehicle do fine in all other gears, no slipping or anything. does the auto stick work ok? let me know so i can try to help you out more. thank you

please dont forget to rate this solution????

Mar 13, 2009 | 2007 Dodge Charger SRT8 Sedan

Not finding what you are looking for?
2006 Dodge Charger Logo

230 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts


Level 3 Expert

78267 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides