Question about 1998 Saab 900

1 Answer

In onwers manual we did what stated to open convertable top,,,,,,,,,took lever off manual to try auto swicth in car ......not working now does this need a reset

Posted by on

Ad

1 Answer

First thing to look at is the fuse box located underneath the drivers side steering wheel. Open up the cover and on the backside is a diagram. Look on this diagram and it will show you what fuse controls the convertible top. Replace the fuse and now try to use the auto switch. After you replace the fuse and it still don't work then you will need to replace the tonneau top motor. Click on the link below to view a replacement for your 1998 Sabb 900

http://www.saabservices.com/saab_tonneau_cover_trouble.html

Posted on Jun 02, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Want to convert my electric audi 80 roof into a manual one


no need to convert.
the electic roof can be opened manually by:-
unlock the roof using the handle on top of the windscreen and push roof back as far as posible.
lift flaps adjacent to door pillers
you will see a small lever which can be retracted (both sides)
when these levers are retracted the roof will push down fully into its compartment
when erecting the roof ensure that the two levers are fully open to accept the roof retaing lugs

Mar 29, 2013 | 1994 Audi Cabriolet

1 Answer

1992 corolla won't accelerate


the auto-transmission control linked to accelerator pedal might have changed its position.loosen the screw on the sliding lever,start the engine ,slowly slide the lever and once it started engaging set t/m about 900rpm.

Feb 27, 2012 | 2007 Toyota Corolla

1 Answer

My 328i 1999 convertible is half way open and dont wanna close or open. how do i manually close it?


u need to remove the bottom part of ur rear seat, just pull it out. There is a lever to left side under this seat with a red flap, pull the lever it will diengage the motors that control ur convertible soft top. This will set it to manual mode, u can now slide it open or shut manually. Have a look at this video on utube http://www.youtube.com/watch?v=boiybaJkMrI

Feb 14, 2011 | 1999 BMW 328 Series

1 Answer

I need to remove the right rear panel of my new beetle convertible to find out the problem. There is a little door at the top and when the top goes up this door is supposed to go under and forward so...


it takes a throx to remove the screws on the bug, you can purchase a manual at an auto parts store, they will more then likely have to order it, at least for the 2000 new beetle we had they had to order it and it was under $25. I took the front fenders and bumper off as I had to fix a radiator leak, Hope this helped Tim

Oct 23, 2010 | 2003 Volkswagen New Beetle Convertible

2 Answers

1996 BMW E36 Convertible to stopped working.


Change switch first checking all contacts(wires to clips)

Jun 25, 2009 | BMW 318 Cars & Trucks

4 Answers

E36 BMW convertible top operating it manually


Hey there, I have experienced the same problem. You need to reengage both motors if you have disengaged them pulling the lever undernearth the rear driverside seat. Make sure to put the black lever back under the seat to the position before pulling on it.

You should have the top in the down position before engaging the motors back in place.

To engage the motors: The motors are located under the carpet in the trunk on the driver side. There are two black clips you will need to remove in order to pull the carpet back. One of the motors is located near the taillight. This motor is responsible for the storage lid cover. The motor that is located further in the drunk is the motor for the fabric top to move up and down. Make sure to firmly press these motors back into place. They should not move.

Once you have engaged the motors, go into your car put the key into the ignition and have the convertible top button pressed up (meaning to close the top), move the key to the accessory positio and hold it for 10-12 seconds. You will finally see the trunk lid get pulled closed. The car will now attempt to completely close the lid. If your motors are working fine it will close. If your only intention is to get the lid to close on it's own it should be accomplished.

Good luck!

Jun 12, 2009 | 1997 BMW 328

1 Answer

Convertible top on BMW will not raise or lower. Is there a manual way?


you can change to manual operation by pulling the releasse lever under the l/r seat and this deactivate the moters the roof will open and close manual but you will have to comvert the rear lid when open to secuer the resar lid when the roof is open and this to hold it down.two ruber hold downs like you would use a a beash buggy bonnet

May 24, 2009 | 1994 BMW 3 Series

2 Answers

Trunk,backend of car stuck in up position


My 2007 EOS stops with the truck up in the air, going up or down, when the temperature is very hot. The manual says if the hydraulic fluid gets too hot, you must wait for it to cool. I find this unsatisfactory as I live in a very hot state. I had it in the shop several times, then found this in the manual, and took it in again last week; the service manager at the dealer says he has seen reports of this, but there is not solution that he knows of. I am contracting the National Headquarters this week, and then an attorney if they do not remedy it as I only have a few more months of warranty to work with them....hope this helps.

Apr 20, 2009 | 2007 Volkswagen EOS Convertible

1 Answer

Car broken into. Took it to chrysler dealership because, the steering column was broaken and convertible top was cut. Fog light was on the multifunction switch before they replace it with a used one. The...


call the manager of the dealership and demand answers tell him your unhappy and tell him you will contact chrysler re this problem if its not rectified . ok good luk

Jul 19, 2008 | Chrysler Sebring Cars & Trucks

Not finding what you are looking for?
1998 Saab 900 Logo

Related Topics:

95 people viewed this question

Ask a Question

Usually answered in minutes!

Top Saab Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

yadayada
yadayada

Level 3 Expert

76649 Answers

rgbypoet

Level 2 Expert

166 Answers

Are you a Saab Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...