Question about Hyundai Motor 2003 Elantra

Open Question

I need to remove the passenger side front door on 2003 Elantra

I need to remove the passenger side front door on a 2003 Hyundai Elantra to do some body work. I have everything taken off the door but I can't figure out how to disconnect that big electrical connector from the door to the car. How does that come apart? I have all the connectors in the door disconnected. The heavy rubber strain relief going into the door seems too solid to pry out and where it connects into the car almost seems like a plug but I'm not sure how to get it apart. My Haynes manual and the Alldata system at the library don't show this detail.
Thanks!!

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 840 Answers

SOURCE: Remove door trim to replace power window switch

you dont have to take the trrim off on this car look at the outline of the switch open from rear and pull forward then you can change the window switch/ Please rate my response thank you very much

Posted on Feb 01, 2009

ghost4548
  • 776 Answers

SOURCE: 2003 Hyundai Elantra.. Numerous problems with the alarm.....

Go to http://www.hmaservice.com/ and register (vehicle by VIN). Afterward, you'll have access to technical information (manuals, wiring diagrams, service bulletins, etc) about your vehicle.

Posted on Jun 28, 2009

  • 15 Answers

SOURCE: ELANTRA ALARM PROBLEM

If the alarm keeps going off constantly and the remote has no influence on the alarm its most likely a connection problem. A hyundai dealer might be able to fix it but since you can start the car something you might be able to try is....
Check and make sure the remote battery is in the right way. Make sure all of the doors are closed, the trunk is closed, open the hood, connect the battery, close the hood all the way and try to lock and unlock the doors. Hope this works but if not, sorry it didn't work.

Posted on Jul 08, 2009

  • 850 Answers

SOURCE: front pass side cv axle removal on 2003 hyundai santa fe

pull swiftly !!! on the axle hub
as its got a big circlip in there & that is why it feels STUCK!
Cheers Rob

Posted on Aug 15, 2009

ghost45
  • 1280 Answers

SOURCE: 2003 hyundai elantra gls abs/tcs light on

unless you can discover what DTC (Diagnostic Trouble Code) has been recorded/set in the control module, it's anyone's guess.

Posted on Sep 10, 2009

Testimonial: "thankyou"

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

2006 Hyundai elantra air bag light sensor where is it and how to reengage passenger air bag


check fuses and relays their are different locations for air bag sensors and their is also seat belt sensors and seat switches [check the connections under the seat ]---their are sensors under the front bumper behind the valance by the radiator support also if air bag curtains passenger side between inner fender, door and door pillar the following links have information or what to look for and assist in solving your problem the recall doesn't cover your vehicle but it pertained to the passenger air bag problem as well as the 05 posting
Why is my airbag light on 2005 Hyundai Elantra Air Bags Frontal Sensor Control Module Problems More than 280 000 Hyundai Elantras Recalled Over Air Bag Problems

Aug 14, 2016 | Hyundai Cars & Trucks

1 Answer

Replace left front fender


Replace left front fender - Fixya

www.fixya.com/cars/t26028082-replace_left_front_fender
Dec 29, 2015 - replace left front fender - Hyundai Motor 2003 Elantra question. ...Question about Hyundai Motor 2003 Elantra. Open Question ... How do i remove left front fender clip on a Lincoln ls 2002? Jan 04, 2015 ' 2002 Lincoln LS.

Replace 2003 hyundai elantra front passenger outside door ...

www.fixya.com/cars/t17348691-replace_2003_hyundai_elantra_front
Mar 26, 2013 - Question about Hyundai Motor 2003 Elantra. Open Question.Replace 2003 hyundai elantra front passenger outside door handle. Need to replacebroken exterior door handle on front passenger .... replace left front fender.

Dec 29, 2015 | Hyundai Motor 2003 Elantra

1 Answer

Need to intall new front exterior drivers side door handle on a 2002 Hyundai Elantra GLS


remove the interior door trim and you will see small nuts holding the handle onto the outer door skin. Remove any rods /clips and undo the nuts and the handle will come out.

Mar 18, 2014 | Hyundai Motor 2002 Elantra

2 Answers

Are struts on the front or back of this car?


The struts model (MacPherson Strut),are both in front and back of this car.
2000 - 2006 Hyundai Elantra Shock Absorber and Strut Assembly - Rear, Driver Side, KYB GR-2/EXCEL-G, Twin tube, Strut Assembly. $72
2000 - 2006 Hyundai Elantra Shock Absorber and Strut Assembly - Rear, Passenger Side, KYB GR-2/EXCEL-G, Twin tube, Strut Assembly $68
1996 - 2006 Hyundai Elantra Shock Absorber and Strut Assembly - Front, Driver Side, KYB GR-2/EXCEL-G, Twin tube, Strut Assembly $67
1996 - 2006 Hyundai Elantra Shock Absorber and Strut Assembly - Front, Passenger Side, KYB GR-2/EXCEL-G, Twin tube, Strut Assembly $63
Of course this is only the cartridge, you have to transfer the spring, and the top mount of the existing strut. You need a pair of coil spring compressor to do the job. The basic procedure to replace a strut is:
Remove the top nuts that secure the strut assembly to the frame mount inside the engine compartment. Do not remove the center nut.
Mark the lower strut mounting location on the hub for installation reference. The alignment will be close if the new strut is installed in the same position.
Remove the bolts that hold the strut assembly to the hub.
Remove the strut assembly from the vehicle.
Mark the top mount for installation reference. Using a side mounted spring compressor, compress the spring and remove the top nut and retaining washer. Pull strut assembly out from the bottom of spring.
Slide the new strut assembly up into the spring and reposition the top mount onto the spring in the same position that it was removed. Install the retaining washer and top nut.
Tighten the top nut to the manufacturer's specifications and carefully remove the spring compressor.
Place the strut assembly back into the vehicle.

Oct 16, 2010 | 2000 Hyundai Elantra

1 Answer

2003 Elantra GSL power windows don't work.


could be the driver side master window switch... if the driver side window switch assembly is broken then the windows will not work... try using a test light to see if you got power to the with and and ohm meter to check all four switches on the drivers side

Jul 11, 2010 | Hyundai Motor 2003 Elantra

2 Answers

The front passenger window only goes down but not


it's working from the drivers side. i would assume the passenger switch is bad or there is a wire disconnected from the switch.

Mar 29, 2010 | 2001 Hyundai Elantra

1 Answer

How to replace interior door latch on elantra?


Remove any and all screws from the door panel, including removing lock and window controls. then take a large flat-tipped screwdriver and pry off the panel all the way around. FInally lift panel up and off the door. Now you will have access to the inside of the door. Everything from here is self explainable.

Dec 07, 2009 | Hyundai Motor 1999 Elantra

2 Answers

Need power window diagram for 2000 hyundai elantra


is this what your looking for??
Front Door Glass:
36c72f3.jpg

Apr 25, 2009 | 2003 Hyundai Tiburon

1 Answer

Right side passenger door


inside door handle or linkage is broken ,youll have to take inside door skin off,inspect whats damaged and replace

Feb 25, 2009 | 2001 Hyundai Elantra

1 Answer

Remove door trim to replace power window switch


you dont have to take the trrim off on this car look at the outline of the switch open from rear and pull forward then you can change the window switch/ Please rate my response thank you very much

Jan 31, 2009 | Hyundai Motor 2003 Elantra

Not finding what you are looking for?
Hyundai Motor 2003 Elantra Logo

Related Topics:

41 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8140 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...