Question about 2001 Chevrolet S-10

2 Answers

2001 s-10 po 452 and co265

I have a po452 and co265 codes on a 2001 s-10. The SES light comes and goes. Sometimes it won't come on for a month at a time. Only one code, the po452. I have replaced the gas cap and the purge seloniod that is mounted on the rear axle. The only other thing I can think of is the FTP sensor that is on the fuel pump unit, Any advice? Also have a co265 code for the ABS which is Elec. Brake Control Module Motor Relay Circuit or something along those lines. This code also comes and goes, could this be a relay? I would think it would be electrical since sometimes it's fine and other times it throws my ABS light on. Any advice would be great. Thanks.

Posted by on

Ad

2 Answers

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Hey i have the same problem with the po452 but i cant find anything. but i also had the co265 problem and turns out it is a faulty abs brake system and the only way to fix it is to get a new brake controule module, its the crome flat thing in the right back corner of the s10 if you where standing in front of it. it has a couple of wires that plug into the bottom and a couple screws holding it down just unplug and unscrew, then the thing should pull straight up it will have six prongs sitting there if you pulled apart the right thing. the only bad thing is finding another one for cheap. i was stressing because you can only get them new from the dealership and they cost a thousand bucks or more, so i went to the junk yard and got one for 5 bucks and havent had the code pop up.

Posted on Jul 09, 2010

Ad
  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 973 Answers

After you replaced all these parts did you clear the ECM with a OBD II scanner or did you just leave it?

Posted on Jun 01, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Just had fuel pump replaced code po452 came the check engine lite


Depending on the make model and year, code 452 means there is a problem with the pressure sensor for the gas tank. The sensor could have been damaged, or not connected.

Oct 22, 2015 | Cars & Trucks

1 Answer

I got code PO 452, PO 443, PO 449 all EMS codes what do I need to replace and how hard to do your self?


The codes only tell the mechanic what to test, not what to replace.
You would need to get the shop manual for your vehicle to have the test instructions for each code.
Code 452 is a problem with the fuel tank pressure sensor circuit, 443 is evap canister purge and 449 is the vent valve circuit.
The evap system and those components would need to be checked out.

Oct 22, 2015 | Cars & Trucks

1 Answer

Engine light is on and after diagnosed it shows evop po 452 and po 441, i need help.thanks


code P0441 could mean one or more of the following has happened:
  • Bad vacuum switch
  • Broken or damaged EVAP line or canister
  • Open in PCM purge command circuit
  • Open or short in Voltage feed circuit to Purge Solenoid
  • Faulty purge solenoid
  • Restriction in EVAP solenoid, line or canister
  • Corrosion or resistance in purge connector
  • Bad PCM
code 452 is evap system- Could be lose gas cap. If you have got gas recently reset code make sure gas cap clicks. ALSO IN THE FUTURE GIVE US YEAR AND MAKE OF VEHICLE THIS HELPS US NARROW DOWN THING.

Aug 25, 2013 | Cars & Trucks

1 Answer

HELP PLEASE


Code 452 is for a low voltage signal coming from the pressure sensor. The computer sends voltage to the sensor and expects a return voltage within a certain range.
If you have replaced the pressures sensor and the problem continues, it may be in the wiring between the computer and the sensor.

Jun 09, 2013 | 2003 Hyundai Tiburon

1 Answer

NEED TO KNOW WHAT CODE PO137,PO141,PO452 MEAN FOR A 2000 DAEWOO NUBIRA


two codes are for an oxygen sensor & the 452 for the evap system

Google OBD2 Systems followed by the code

Nov 29, 2012 | 2002 Daewoo Lanos

1 Answer

Have 04 mercury grand marquis check engine light is on for code po452 had that fixed and light still on


Well ---PO 452 is still FTP Sensor Circuit Low Voltage Detected
new sensor or not



If the sensor reads less than .22volts with key on /engine off --you get a hard fault (code)


Check Sensor Connector


Sensor with no pressure or vacuum in tank is 2.4 to 2.8 volts
Key On/Eng Off On scan tool PIDS


You just need a shop with a data base & proper test procedure
or a different tech or different dealer.


I have the 2004 gas engine emissions diagnostic manual for all
2004 fords, as I have a Lincoln LS,so I don't know why a pro
couldn't resolve

Nov 25, 2012 | 2004 Mercury Grand Marquis

1 Answer

Failed 2001 chevy blazer code 452


(PO452 general motors code, low evaporative emmisions control input) Believe it or not it could be that the gas cap is not on tight or needs to be replaced. Other than that: vacuum line or evap. canister leak.

Nov 02, 2012 | Cars & Trucks

1 Answer

Trouble codes PO440 and PO452


PO440-EVAP SYSTEM NO FLOW DURING PURGE.CODE PO PO452 - FUEL TANK PRESSURE SENSOR CIRCUIT LOW INPUT.

Oct 07, 2012 | Chevrolet Avalanche Cars & Trucks

Not finding what you are looking for?
2001 Chevrolet S-10 Logo

1,109 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8273 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...