Question about 1996 Chevrolet Blazer

1 Answer

I have a 97 blazer starts fine stalls at 230deg starts when cool

I have a 97 blazer starts fine runs untl hot and thn shuts down//wait 1 hour wl start again untill hot then wl stall agn PLEASE HELP ME// already changed feuk filter and icm

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 13 Answers

Check the electronics in the distributor. Chevs are notorious for the electronics going bad inside of the distributor.

Posted on Jun 12, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have 84 ramcharger started fine used for about 1/2 hour plowwing driveway shut off would not restart until cooled off 2nd time it has done this?


Sounds as if the ignition control module is getting hot and not allowing it to restart. Had the same issue with a Dodge b-250 van, except for the plowing part. It would run for about an hour and start sputtering and shut off. After it cooled down, van would start and run great for the same length of time and do it again.

Feb 22, 2015 | Dodge Ramcharger Cars & Trucks

1 Answer

Drivability problems after driving 20 - 30 miles


Try changing or switching out the distributor. Most likely getting hot and shuts down. Does it crank but no start whenever it stops? May only start when it cools down again.

Dec 12, 2013 | 1996 Nissan Quest

1 Answer

I have a 97 expedition and it will start with no problem but when i drive and the suv and it gets to the normal tempeture and i turn the car off it will not start i have to wait for 20 min or more until...


I would say your starter is faulty. Since the vehicle runs fine, and doesn't start up after being shut off until it has cooled down, it sounds more like a starter that loses contact when it is hot. You could check the starter terminals for 12 volts using a multimeter when the key is turned to Start the engine after warming up the engine and shutting it off. If 12 volts are present, replace the starter. If 12 volts are not present, check the Starter relay.

Apr 15, 2011 | 2001 Ford Expedition

2 Answers

Every now and then it will stall out. just wait about 1/2 hour and it will start up and run good again


Sounds like the "Crank Position Sensor"...especially because it will start fine a few minutes later...tough to confirm by codes on this one...do any of your gauges go beserk when your Buick stalled? This would again point to the same intermittent starting and running problem...part is about $35. May need help to install...:)

Dec 13, 2010 | 1997 Buick Skylark

1 Answer

My 1988 chevy beretta v6 2.8 liter runs fine starts nice, when it gets running and gets hot sometimes it will stall out not all the time but just sometimes, and when i have been drivin it for a while say...


its common for chevy vehicles-you have a problem with your crank positioning sensor,our 06' colorado does that- sensor maybe $50.00,look into that sensor..
hope that helps you-good luck!

Nov 05, 2010 | 1988 Chevrolet Beretta

1 Answer

My 97 buick runs cold stalls when hot wont start for 1 hour


Sounds like it is fuel related. Ck fuel pressure to be sure. Also ck the pressure regulator on the fuel rail, It is a small metal cylinder at the end of the fuel rail to ck pull to vacumn line off (hot not running after shutting the engine off). If there is fuel in the vacumn line it is bad. Good luck

Dec 23, 2008 | 1997 Buick LeSabre

1 Answer

1997 chevy blazer trouble starting


97 don't have carb that year its TBI injection . Inspect/fuelpump relay/pressurereg.switch/pump/filter

Nov 18, 2008 | 1997 Chevrolet Blazer

3 Answers

I have a 350 chev, motor, put in a new cam and lifters adjusted lifter, set timing .vacume on carb, problem is when i drive the car and turnit off i have to wait till the motor cool down to start .i am...


I have a '81 Firebired that did the same thing with the factory-issued Flintstone-mobile 3.8L V6. Everything but the starter worked correctly: new 185 thermostat, perfect 50-50 coolant misture, no leaks, etc., but still had to wait 1-2 hours for a cool down.

It may be that your original starter is dying. Your starter relay is over-heating and opening the circuit. You can replace the starter and/or buy a pre-made heat shield for the starter or fab one yourself. Regardless, just remember that the goal is to keep the starter as cool as possible.

To prove this is in fact the problem get the engine hotter than usual in your driveway then shut it off. If it won't start cool it down with a bag of ice (don't burn yourself). Should take less than 5 minutes to cool it to start.

Good luck!

Jul 20, 2008 | 2007 Chevrolet Impala LS Sedan New Cars

Not finding what you are looking for?
1996 Chevrolet Blazer Logo

Related Topics:

320 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75077 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7768 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...