Question about 2007 Toyota Tundra

Open Question

07 toyota tundra crewmax fog light wiring diagram truck did not come wiyh fog lights is it pre wired and is there a spot for a switch on the dash

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 7 Answers

SOURCE: the security system is going off in my toyota tundra 2001 truck

lock the doors then shut it and unlock it with the key on drivers side it should go off and start

Posted on Mar 22, 2009

mecanica03
  • 874 Answers

SOURCE: My 2007 Toyota Tundra 4.7l shows VSC OFF lights

check air filter for dirty , how many miles or kms have your car? , maybe need to replace spark plugs, try to reset the ecu for a momentany malfunction, remove the negative battery terminal few minutes and reconnect,start engine and drive, check if lights goes off , please write me

Posted on Jul 05, 2009

  • 1 Answer

SOURCE: how to replace brake pads & rotors

I have a 2006 Sequoia which should have the similar if not the exact same brake system. Changing the pad is very easy and straight forward. No special wrenth was involved. Easier than sedans since no worry to damage the brake fluid pipe.

Posted on Jul 11, 2009

  • 1 Answer

SOURCE: Toyota Tundra 2005. ABS, Airbag, Tire & cruise dash lights flash

how do you turn the maintenance light off after making oil change?

Posted on Sep 02, 2009

  • 1861 Answers

SOURCE: 2003 Toyota Tundra Limited Stepside truck. No Brake light

Hello.

We would suggest that you look at the wiring connector under the bed, that feeds the taillamps.

You will probably find a coroded wire in the connector. If the 3rd brake lamp works, all of the fuses and switches are good.

Posted on Dec 25, 2009

Testimonial: "All connectors were fine. It ended up being that both brake light blubs blew at the same time. Thanks"

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

All warning lights came on when i started my truck and then died, never had a problem befor


Do they stay that way? usually bad wiring causes that - if all stay lit.

Jul 04, 2014 | 2010 Toyota Tundra CrewMax

1 Answer

Toyota tundra suddenly wont start


It could be almost anything. to isolate the problem let's start with the battery. If you turn on the head lamps do the light up bright?

Apr 17, 2014 | 2009 Toyota Tundra CrewMax

1 Answer

Engine starts and dies. After several restart attemps and 15 min it will start


is the IMMO Light on the dash , unhappy?
RTM. on IMMO,= immoblizer.
if not IMMO
its EFI, (maybe) that
means tune it up filters, and all new spark plugs gapped to factory spec.

Jan 22, 2014 | 2008 Toyota Tundra CrewMax

1 Answer

I am trying to wire up a set of OE style after market fog lights .Can you help me locate the parking light power tap under the dash?


If it was not equiped with fog lights from the factory it will not be there, Make shure you use a relay on them, Plus a inline fuse on the postive wire going to the switch for them, From the positive terminal on the switch just run the wre to the fuse block, If you dont use a relay on them you can overload the circut, end do a lot of damage to the circut ,

Nov 11, 2012 | 2008 Toyota Tundra CrewMax

1 Answer

2004 tundra fog lights do not turn on.


Try to wire them straight to 12v to rule out anything with the lights themselves. You've tested with a meter to the leads at the light with them switched on?

Mar 15, 2012 | 2004 Toyota Tundra SR5

1 Answer

Wiring diagram for spotlights on a discovery I/II (1999) Would like to mount and wire the spotlights up so as they come on highbeam only, and would like to connect it into the ' rear fog light ' switch....


You can find factory wiring diagrams here (free RAVE Download) http://www.landroverresource.com/ And sure you can wire your spots into rear fog switch, depending on watts/draw of your lights you might want to "UP" the fuse rating

Mar 20, 2011 | 1999 Land Rover Discovery

1 Answer

2007 Tundra: Which fuse if for the dash board that controls all...


hello please help I got a tundra 2007 w/ no hazard turn signal & running lights (front yellow lights) HELP PLEASE all fuses check ok.

May 17, 2010 | 2007 Toyota Tundra

2 Answers

I need a wiring diagram for fog lights oem to my toyota


The link below is a Typical fog lamp / driving lamp hookup. Keep in mind that in most states, for these lamps to be 'legal' (and thus pass inspection), you must wire them such that:

1. You can cut them off (in other words, there must be a switch installed to turn them off)

and

2. They may only be operated with the low beams. (therefore, you must power your on/off switch from the low beam circuit)

http://www.accessconnect.com/fog_driving_lights_wiring.htm

Feb 28, 2009 | 2005 Toyota Corolla

1 Answer

Need wiring shematic for fog lights 2005 toyota corolla


im pretty sure these cars were already prewired for fog lights .there should be some plugs behind the bumper to fit them.if not get back i will explain how to wire them up.best of luck.

Sep 04, 2008 | 2005 Toyota Corolla

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

288 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

74945 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7697 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...