Question about 2002 Volvo S40

2 Answers

Abs ligth an breake turn on, the break fluid is Ok level up, the car is VOLVO S40 2002 1.9 Turbo, the car breake ok. what i do?

Posted by on

2 Answers

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 11 Answers

I think it could be a wheelsensor problem.My car do the same sometime .If i stop engine and start again it works fine again.

Posted on Nov 28, 2014

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 462 Answers

Very common problem on Volvo , ABS module is bad.
This is not effecting the brake system , meaning you'll still have normal brake operation , but on slippery road Anti Lock System won't work.
That system prevent wheels to be locked up by driver and prevent car going into spin.

Posted on Jun 01, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1.Why is my break light indicator on dashboard on even when break is not engaged.Note,my break is active and fluid level is ok. 2. Why is my ABS light on and refused go off from dashboard.


Not sure about the Honda setup, but when my Dakota had those lights both lit, it was a bad speed sensor in the system. I had the additional symptom of no speedometer reading until about 30mph.
It seems that the VSS in my system was used at lower speeds by the ABS system to determine when to activate. If the ABS light goes on, many vehicles will also activate the brake light since the two are undoubtedly related.

Dec 10, 2015 | 2003 Honda Accord

1 Answer

1.Why is my break light indicator on dashboard on even when break is not engaged.Note,my break is active and fluid level is ok. 2. Why is my ABS light on and refused go off from dashboard.


Because you have a problem in the ABS system . With the light being on there is a DTC -diagnostic trouble code stored in the ABS control module . EBCM - electronic brake control module . The red brake light also will come on with ABS problem . If you are unfamiliar with this I suggest you take your vehicle to a ASE certified repair facility that is .

Dec 10, 2015 | Cars & Trucks

1 Answer

Where is the ABS valve power relay located on 2004 Mercury Sable ? ABS light on and code C1266 showing.


abs valve power relay circuit failur,this is what the code c1266 meens,hope this was some help,all the best.

Nov 10, 2015 | Mercury Cars & Trucks

1 Answer

I just changed the breaks on my 2004 optra 5 ls and there are still spungy? What could be the problem?


Hi,

Most likely cause is air in the break lines. This can happen if the break lines are not bled during the break job. If you did bleed the lines during the job you may be low on break fluid. If the fluid level is OK then you should bleed the breaks again, making sure the fluid level stays high.

Jan 29, 2015 | Cars & Trucks

1 Answer

Today my scion xd abs ligth and break ligth came on, what could be the problem and how unsafe can it be.


Well you can drive without ABS the brake light came on because the ABS. I would have it serviced they might tell you the ABS unit is bad you don't need ABS they just prevent your tires from locking up during heavy break use

Jan 30, 2011 | 2008 Scion Xd

1 Answer

The abs system comes on while braking normally at every stop.


You probably need to change the break pads or fluid level. If eveything's OK, check the ABS sensor.

Nov 20, 2009 | 2002 Ford Explorer Sport Trac

1 Answer

Anti-lock light comes on along with the break warning light, fluid level good no softening on the break pedel...no identifiable difference in performance but the lights remain on.


ABS ligth coming on for no reason is usually dirty sensors on one of the wheels. can often happen after driving through mud etc, Also the serrated disc which the sensor looks at on the hub can get clogged up causing same problem. brakes will still work ok but you will have no ABS function. I have had limited success with this (very common) problem by pressure washing the wheels and hubs. failing that its a case of wheels off and cleaning it all up by hand. Another cause can be bad connection, cracked/trapped sensor wire. Difficult to tell which wheel its on though.

Sep 05, 2009 | 2000 Mitsubishi Eclipse

2 Answers

2002 Volvo S60 (T5) The break ligth warning


This has to do with the anti-lock brake system. It will be fine without it, but if you want it fixed get it done at a dealer not a shop. It will cost a lot more but the repairs will be done right and will last longer.

Jul 29, 2009 | 2002 Volvo S60

1 Answer

ABS/Brake dash light on 2004 Chevy Astro rear wheel Drive


Look for wires hanging, near the tire area under the car. An ABS sensor wire may be broken or the sensor is damaged.
Getting the system scanned will tell you exactly what is going on.

Jun 19, 2009 | 2004 Chevrolet Astro

1 Answer

Auto transmission slips then grabs


first thing i would try is changing the transmission fluid out and filter, i beleive its almost 8 quarts. use a full quart of lucas transmission additive with the new fluid. if this doesn't help, the transmission will either need replaced or rebuilt

May 24, 2009 | 1996 Ford Probe

Not finding what you are looking for?
2002 Volvo S40 Logo

Related Topics:

239 people viewed this question

Ask a Question

Usually answered in minutes!

Top Volvo Experts

yadayada
yadayada

Level 3 Expert

74945 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7697 Answers

Are you a Volvo Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...