Question about 1998 Dodge Durango

Open Question

How do i get the factory security to shut off ive tryed using the key in the door and that dont work no more and i pulled fuses and relays it start and shuts off and the security light is blinking

Posted by on

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

3 Answers

I replaced the battery in my 2008 Chevrolet Colorado and the factory alarm aka my horn won't stop going off. How do I reset my alarm?


pull the horn relay till its sorted
factory alarm may need a diagnostic scanner
might be a faulty module

Apr 16, 2017 | Chevrolet Cars & Trucks

1 Answer

03 eclipse spyder auto v6 .Ive cussed out my wife, broke my favorite flashlight and have wasted 3 days and a hundred bucks. So if anyone can help please do. It will not start. No crank no start. Put the...


Put the battery cables back on shut the doors and lock the drivers door with the key then unlock it with the key. This will shut the alarm off it it goes off and may get the car out of the lockdown mode it seems that it is currently in. If that does not work you may try and call your local Mitsubishi dealer and ask one of the guys in the service or parts dept if the car has a lock down mode and what procedure has to be done to unlock it, mor than likley the will tell you and you wont have to spend a dime. This is all regarding the factory alarm however.

Jan 05, 2013 | Cars & Trucks

1 Answer

I have a 1996 3.8 liter camaro. I was driving my car down the road when the gages started jumping and i found out that problem it was the battery and aldernater well after i changed them problems i have...


Hmmm, a puzzle.

The only way to disarm these alarms is with
the factory remote or turning on the ignition.
To turn off the factory alarm.

Ok, do you have the remotes?
If so, let's ID the system.
Go to www.KEYLESSRIDE.com & use th fcc #s
on the back of it.

If not try this:

Programming Factory Security on GM Cars and Trucks
Instructions for programming the GM factory security systems that do NOT
disarm from the driver's door key cylinder. This programming is for the
cars and trucks listed below.

96+ Camaro
96+ Firebird
99+ GM Trucks
99+ GM Sport Utility Vehicles

Step #1 Turn the ignition on then off.

Step #2 Remove the radio fuse only (not the fuse that says acc/radio).

Step #3 Turn the key to the accessory position. When you do this you
will get two chirps from the door buzzer. Should you hear only
one chirp, your vehicle does not have factory security and these
instructions do not apply. You need to hear two chirps.

Step #4 Press the unlock switch on the door. This will give 1-4 chirps
depending on the program step. Continue pressing the unlock
switch until you get to the desired chirp setting.
1 Chirp - Security off
2 Chirps - Remote Only
3 Chirps - Factory Setting
4 Chirps - Passive Arming

Step #5 Turn the ignition off.

Step #6 Put radio fuse back in.

Jul 03, 2011 | 1996 Chevrolet Camaro

2 Answers

Hi, My 1997 Monte Carlo will not start. My dad had the breather off to clean it out and decided to pull the car up a few feet onto the driveway so it would be easier to work on, he pulled it up with the...


If the security light is flashing, it is DEFINITELY a security system issue. Intermittent ignition switch failures are common.

First, make sure you are using the correct key for the vehicle. Use a FACTORY key, NOT a copy made at the hardware store. Turn the ignition switch to the ON/RUN position (do not try to start the vehicle yet). If the security light is not flashing, go ahead and try to start the engine. If it does not start, release the key to the RUN position and observe the security light. If it is flashing, wait about 10 minutes until it stops flashing then without turning the key off, turn the key to the start position again. If you are using the correct key it should start. If it does not, your car will have to be towed in for service.

Jun 22, 2011 | 1997 Chevrolet Monte Carlo

1 Answer

Security system I bought a 93 Grand Cherokee used & not running.Ive fixed it & drove it for two days.While trying to fix the power windows I woke-up a security system that I didnt even know I...


If it's the factory security system that honks the horn and flashes the headlights, you can shut it off by turning the key in the door cylinders or in the rear tailgate key cylinder. If it's an aftermarket alarm, look for a small silver switch under the dash and usually turning the ignition on and flipping that switch will permanently put the alarm into valet mode. Good luck.

Mar 16, 2011 | 1993 Jeep Grand Cherokee

1 Answer

95 caprice classic starts runs good then the doors lock and it shuts off and you wait five min and it will do it all over again. ive checked all the fuses and replaced the alternator the fuel pump fuel...


Just guessing but is there a security system in htis car?
Being a 95 it may have a factory security, the key does it have a chip built in?
You can bypass and use a regular key,
if none of these apply check idle air,

Sep 30, 2010 | 1995 Chevrolet Caprice Classic

1 Answer

2006 Hyundai Tucson Car - the battery is totally drained & dead so it wouldn't open with the remote opener. Now that we used the key when the car starts to get battery power back the alarm sounds...


this is for honda acura but it also might work for you too.
Open hood ensure new battery is disconnected.
Open main fuse panel cover under hood and remove horn relay (so you don't have to listen to the horn).
Use the key to lock the drivers door.
Connect the positive battery terminal.
Connect the negative battery terminal (security system will now activate, hazards lights will flash and horn would be going off if the relay was not removed).
Use the key to unlock the drivers door.
Get in, close drivers door.
Use the key to start the engine.
Security system will deactivate.
Get out of vehicle, reinstall horn relay, replace fuse panel cover, close hood.

Oct 15, 2017 | 2005 Hyundai Tucson

3 Answers

My 1998 dodge intrepid wont start and the alarm wont shut off


Try "cycling the key in the passenger door lock. Turn it all the way to the right and all the way to the left.

Jul 16, 2010 | 1999 Dodge Intrepid

3 Answers

Dome light stays on even when door is shut


I had te same problem and cleaned all door switches with WD-40 and worked them a little. The problem went away Try that before you try to change a switch.

Nov 29, 2008 | 1996 Ford Windstar

Not finding what you are looking for?
1998 Dodge Durango Logo

715 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8518 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...