Question about Renault Sport

Open Question

I have a mk1 laguna sport w reg rear cylinders have been replaced but the near side rear showing little or no effort

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 117 Answers

SOURCE: rear brake drum

you need to remove wheel , caliper , disk , then the two pins that hold the shoes in,then springs this will allow access to the cilynder wich you can then clean and service.
please leave feedback
cheers

Posted on Jul 01, 2008

  • 1 Answer

SOURCE: renault laguna 2 rear hub turqe settings reg 51

hi -
THE REAR HUB TORQUE SETTING IS 280 NM OR 207 IBF FT. HOPE THIS HELPS
good luck kas

Posted on Oct 14, 2008

emissionwiz
  • 75235 Answers

SOURCE: how do i remove the rear drums off a renault laguna

soak them with rust removing oil (WD 40) and hit them on the edges with a brass hammer until the rust bond breaks loose.

Posted on Apr 07, 2009

  • 20 Answers

SOURCE: heated rear window of a renault laguna is not working

hi.disconnect both sides of heated element on rear screen.connect a wire on one side and the other side maybe using a spade connector.connect one side to a 12v car battery same with the other.may get a slight spark.leave on and see if screen gets hot.better when mist is on screen to see working.if it doesmt demist more than likely screen needs replacing.try a electric meter connected on screen.should be lowish resistance.also try connecting a volt meter to the screen heater connections you taken off screen.one lead one side and same with other.set meter to volts normally 20v setting.put key in car switch one rear screen .voltage should read on meter.about 12v.if not switch may be faulty or heated screen relay.hope this helps

Posted on Jun 07, 2009

rtpflh
  • 546 Answers

SOURCE: HI have a ren laguna 1.6 sp w reg, has a power

check power steering fluid level in the reservoir of the power steering pump,check condition and tension of pump drive belt.

Posted on Oct 14, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Renault laguna 1.9tdi dynamique 51 reg. hazard warning lights do not work, changed fuse still not working. whats wrong with them


If your turn signals work, then replace the flasher for your hazards. Turn your key on then give a left turn signal. Listen for the "clicking" sound near your brake pedal and accelerator. Once you locate your turn signal flasher (small, "cylinderical", device) the hazard flasher should be near it. Simply pull out the flasher and replace... just plugs in.

Jun 07, 2009 | 2000 Renault 181

1 Answer

How do i remove the rear drums off a renault laguna


soak them with rust removing oil (WD 40) and hit them on the edges with a brass hammer until the rust bond breaks loose.

Apr 07, 2009 | 2000 Renault 181

1 Answer

Heated rear window of a renault laguna is not working


hi.disconnect both sides of heated element on rear screen.connect a wire on one side and the other side maybe using a spade connector.connect one side to a 12v car battery same with the other.may get a slight spark.leave on and see if screen gets hot.better when mist is on screen to see working.if it doesmt demist more than likely screen needs replacing.try a electric meter connected on screen.should be lowish resistance.also try connecting a volt meter to the screen heater connections you taken off screen.one lead one side and same with other.set meter to volts normally 20v setting.put key in car switch one rear screen .voltage should read on meter.about 12v.if not switch may be faulty or heated screen relay.hope this helps

Mar 18, 2009 | 2004 Renault 181

1 Answer

Rev counter high.


sounds like the sensor module

Dec 13, 2008 | 2000 Renault 181

1 Answer

Renault laguna 2 rear hub turqe settings reg 51


hi -
THE REAR HUB TORQUE SETTING IS 280 NM OR 207 IBF FT. HOPE THIS HELPS
good luck kas

Sep 23, 2008 | 2001 Renault Sportwagon

2 Answers

Renault laguna 3L 24v v6 Y reg


I believe that they count tehse cylinders starting from the fly wheel side of the engine!

Jul 02, 2008 | 2000 Renault Sportwagon

1 Answer

Rear brake drum


you need to remove wheel , caliper , disk , then the two pins that hold the shoes in,then springs this will allow access to the cilynder wich you can then clean and service.
please leave feedback
cheers

Jul 01, 2008 | 1986 Renault Sport

2 Answers

Renault laguna sports 2005 how to switch on the reversing sensors


As regards the auto lights. Just flick the sidelights on twice in quick succession and they should work. The reverse to cancel them. Can't say about the reversing sensors......best o luck. DK.

May 14, 2008 | 2005 Renault 18I

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

29 people viewed this question

Ask a Question

Usually answered in minutes!

Top Renault Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

xxxxxx xxx

Level 3 Expert

4836 Answers

yadayada
yadayada

Level 3 Expert

75197 Answers

Are you a Renault Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...