Question about 1996 Ford Taurus

1 Answer

My anti theft alarm goes off and makes it to where I can't start my car how do i bypass this

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Ford Master
  • 17,970 Answers

You can't do it; the Theft System it's integrated to the vehicle control computer ECU/PCM; you need install one INTERFACE to make this work.

Review this Wiring Diagram and this comment: when installing a 791 TRANSPONDER BYPASS System on this vehicle it will be necessary to remove the BOTTOM STEERING COLUMN Cover and IGNITION SWITCH TUMBLER to gan access to the Factory Transponder System around the Ignition Switch. To do so will require that you first look at the bottom of the STEERING COLUMN COVER to identify the screw holes from the IGNITION SWITCH TUMBLER RELEASE PIN HOLE, that is required to remove the Ignition Switch Tumbler, the IGNITION SWITCH RELEASE PIN HOLE is the SMALLEST Hole in the plastic cover in this picture. NOTE *** to remove the IGNITION SWITCH TUMBLER, a TORX #15 Bit on a Screw Driver will work just fine. Incert it up into this hole and press, at the same time, turning the IGNITION SWITCH ON and the Tumbler will pull out at the same time. This Must be done to remove the IGNITION SWITCH TUMBLER so that the BOTTOM Steering Column Cover can be removed to gain access to the TRANSPONDER SYSTEM built around the IGNITION SWITCH.

Also, its possible that you need other details from the Taurus's Owners Manual.

Hope helps.

Posted on Jun 01, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

99 explorer alarm disables. Motor dies


Anti-theft system can keep vehicle from starting , Alarm is for vehicle content theft , open door without key alarm sounds (horns) ! PATS - passive anti theft system PATS enables and disables the engine from starting ,it will not cause the engine to die ! You have some other kind of problem ! If the vehicle engine doesn't turn over an red light on top of dash flashes fast ,then you have anti-theft system problem !
PATS differs from the perimeter anti-theft system in that PATS enables and disables the engine from starting. If equipped, the perimeter anti-theft system protects the perimeter of the vehicle (doors, hood and trunk) and sounds an alarm.

Aug 17, 2016 | Cars & Trucks

1 Answer

Engine wont start alarm lockout on 2004 buick rainier


Sallie, may have to have security reset at the dealer if you can not do it yourself. Check the attached links,instruction and guides, Good luck
"I hope this helped you out, if so let me know by pressing the helpful button. Check out some of my other posts if you need more tips and info."
Passlock III reset procedure reset security system on chevy buick...
Anti theft Alarm System Vehicle Security Keys Doors and Windows Buick...
Do It Yourself GM Security bypass
Won start Anti Theft Ignition Switch

Jun 25, 2016 | 2004 Buick Rainier

1 Answer

How do i bypass the anti theft system in a 2002 Stratus


Unfortunately if you are referring to the factory anti-theft system - it will have to have computers replaced. Once the Engine Computer sees a Theft Alarm request it will remain there forever and it will shut down the fuel system until seeing an OK To Start from the Theft Alarm.
If it is after market alarm - find it and disconnect wiring - restore connections to original
does that help?
If you are having trouble with the system? Make sure the battery is good and fully charged. There are entry switches on the back side of the lock cylinders on both front doors (probably knocked off when the door is "Slim Jim'd") and the trunk lock.
If your battery is dead and you try to jump it - you will have to turn off the alarm again after hooking up the jumper

Jan 29, 2015 | 2002 Dodge Stratus

1 Answer

Microbus 2.3i Conlog alarm system. Alarm box got wet and now the van does start. How do I bypass the alarm box if all the wiring is white.


You can't just by pass anti-theft systems ! Software programmed into BCM , PCM . Your best bet is take it to qualified repair shop ,

Jun 10, 2014 | Cars & Trucks

1 Answer

Anti-theft goes off on 93 nissan 300zx


youv've engaged the anti-theft circuit it will need reset at a dealer

Sep 04, 2012 | 1989 Nissan 300ZX

2 Answers

2000 Isuzu Rodeo (just purchased), anti-theft alarm goes off periodically for no apparent reason. Was going to remove fuse, but it is already gone. How can this be possible, unless someone has bypassed...


THATS WHY THEFT SECURTY ALARM GOING OFF THEFT SECURITY SYSTEM NOT WORKING FUSE IS MISSING.MORE LIKELY THE GUY SOLD YOU THE CAR BECAUSE OF FAULT IN THE THEFT SECURITY SYSTEM, GOING COST TO FIX.

May 30, 2011 | 2000 Isuzu Rodeo

1 Answer

My BMW E30 1992 does not want to start. It sounds as if the anti theft code does bot want to disarm once one has put in the right code. So disconnected battery and waited fro 24hours reconnect battery...


Here is information on disarming the alarm! First you need to know if it is a factor or after market system! Here is how you tell if the headlights are flashing, the alarm system is factory installed. Inserting the key into the driver door lock and turning to the left then back to the right is supposed to disarm it. If the parking lights are blinking,, the alarm is an aftermarket add on, and there should be a disarm button under the dash on the driver side. If it' an aftermarket alarm, you should be able to have it removed. There is a way to bypass the factory alarm. There is a wiring harness in the driver's door. You will have to remove the door panel to find it. The wire is dark green and purple. Splice into that wire and ground it to the chassis and the alarm should no longer work

Jan 22, 2011 | BMW 325 Cars & Trucks

2 Answers

Need bypass factory alarm in 99 dodge


well thats an interesting idea but by bypassing the alarm your car will not usualy start it is a safety feature that is built in to all chrysler autos it will disable the starter coil door locks windows and half the electrical systm as a safety feature and anti theft feature

Dec 30, 2009 | 1998 Dodge Caravan

1 Answer

How do I bypass alarm for 1994 buick lesabre


Yes ,I now how to do this I posted it earlier. March 1,

Feb 14, 2009 | 1994 Buick LeSabre

Not finding what you are looking for?
1996 Ford Taurus Logo

525 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75817 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

fordexpert

Level 3 Expert

5495 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...