Question about Chevrolet 1500

1 Answer

My 1996 chevy vortec engine My 1996 chevy vortec engine in a 4x4 suburban, always has an empty coolant reservoir, i always have to refill it the temp never goes past 210,the radiator has coolant but has to be topped off, it runs very good .

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Expert
  • 4,070 Answers

Hi! The problem may be simple. When filling the reservoir, it should only sit on the max, hi or full level. If overfilled, the coolant tends to come out of the breather hose. I strongly suggest that dont fill the coolant above the recommended level. Hope this helps and have a good one!

Posted on Jun 01, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

3 Answers

Coolant reservoir empty after sitting overnight


Check the water pump and see if coolant is around it.

Jul 26, 2015 | Cars & Trucks

1 Answer

Coolant reservoir empty when sitting overnight


You must have a coolant leak. If there are no signs of a leak, you may have a gasket on the engine that has gone bad, and the coolant is being pushed out the exhaust system. The coolant expands when hot and cools when the engine cools. During the cooling stage the cooling system creates a suction on the coolant in the reservoir and draws enough coolant back into the system to keep it full. Apparently you are loosing enough coolant somewhere that the reservoir can not fill the system before going dry.

Jul 26, 2015 | 1998 Ford Windstar

1 Answer

Adding water to a 1996 ford contour?


Check the level of the coolant in the reservoir at least once a month. Be sure to read and understand precautions when servicing your vehiclein this chapter.If the engine coolant has not been checked for a long period of time, the engine coolant reservoir may eventually empty. If this occurs, add engine coolant to the coolant reservoir. For more information refer toAdding engine coolantin this chapter.
Automotive fluids are not interchangeable; do not use engine coolant, antifreeze or windshield washer fluid outside its specified function and vehicle location.

Check page 169 from Ford-Contour-Owners-Manual for other details.

Hope helps (remember comment andf rated this).

Jul 20, 2010 | 1996 Ford Contour

1 Answer

1996 gmc k1500 4x4 5.7 vortec motor no start keep


Replace the coolant sensor on the front of the intake manifold.The coolant sensors on this engine does go bad and wont set a check engine light. The sensor will read about -32 to 0 degrees when they do go bad. The computer thinks it is that cold and sends tons of fuel to the engine. If you try to start the engine with the throttle depressed to the floor it puts the fuel system in clear flood mode and wont fire the injectors. Engine will start then and run very rich. The coolant sensor has two wires on it and sometimes you need to replace the wiring pigtail going to it as the sensor can seep coolant into the connector and corrode the terminals. All the parts are available at pepboys and autozone or napa. Good luck

Jan 05, 2010 | 1996 GMC Sierra

1 Answer

Radiator and reservoir are empty after water pump change.


fill the raditor to the top only when cold, top off the coolant bottle level to full cold, reinspect the coolant bottle after the engine get to proper operation temputure and add coolant to the bottle only. NEVER take off the radiator cap when hot!

Nov 05, 2009 | 1996 Chevrolet Camaro

2 Answers

Do i need to add coolant to my reservoir if it is empty, 97 chevy suburban


Yes. Before you do, remove cap on rad when engine is cool & top it up too, if needed. Keep an eye on temperature gauge for a day or 2 & coolant bottle level, just in case there is another problem.

May 10, 2009 | Chevrolet Suburban 1500 Cars & Trucks

1 Answer

Transmission fluid capacity


do you have an owners manual? if so check the capacities chart it will give a refill capacity

Apr 07, 2009 | 1996 GMC Suburban

1 Answer

I need to refill my rear windsheild washer fluid on my 00 suburba


if i am not mistaken it uses the same reservoir as your windshield washers. if its not working it may be plugged or malfunctioning.

Mar 13, 2009 | 2003 Chevrolet Suburban 1500

1 Answer

Coolant in exhaust pipe but not the oil


THIS SOUNDS LIKE YOU ARE TALKING ABOUT EGR PIPE. AND NO IT WONT CAUSE COOLANT

Dec 30, 2008 | 1990 Chevrolet Suburban

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

38 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75005 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7710 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...