Question about Cadillac Fleetwood

1 Answer

I just installed a new motor in my 1996 cadillac fleetwood brougham and need to know where the leveling system is located to make sure its connected cause it doesnt work, i have checked my fuses and they seem to be good

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Master
  • 10,319 Answers

It is above and front of the rear axle
Follow the wires to the front for one maybe pinched

Posted on Jun 01, 2010


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

My 1996 Cadillac fleetwood brougham had a leacing radiator so I changed it and now it wont stop overheating any tips?


Assuming you replaced the radiator with new or refurbished. You probably need to replace the thermostat. It is usually located on the engine block in a housing at the end of the top radiator hose. Probably just two bolts in the thermostat housing.

Good Luck,

Sep 11, 2016 | 1996 Cadillac Fleetwood

1 Answer

My 1994 cadillac Fleetwood brougham power steering pump with electric variable orifice is not working is there a bypass system i could use?

Hi there, sorry to say I do not think so. If the power steering system is specialised, designed for the car, there is unlikely to be another backup system to substitute for it when it breaks.. If the PAS pump is broken then it is a matter of replacing it. Please check the link below for sellers of recycled parts

Or you may want to obtain a new part from a motor factor/parts retailer

Jun 05, 2015 | 1994 Cadillac Fleetwood

1 Answer

1996 cadillac fleetwood brougham fuel pump location

the fuel pump is located in the fuel tank and it must be dropped to replace.

Aug 24, 2013 | Cadillac Fleetwood Cars & Trucks

1 Answer

1993 cadillac brougham fleetwood. how do you change the pickup coil?

  1. Disconnect the wiring harness from the Crankshaft Position (CKP) sensor.
  2. Remove the fastening bolt for the CKP sensor.
  3. Remove the CKP sensor and the O-ring seal from the engine block. To install:
  4. Thoroughly clean the mating surfaces of the CKP sensor and the engine bock.
  5. Install the CKP sensor with a new O-ring seal, into the engine block.
  6. Install he fastening bolt for the CKP sensor
  7. Attach the wiring harness to the CKP sensor. Be sure to route the cable correctly Fig. 1: The location of the Crankshaft Position Sensor (CKP) - 3.0L engine 91044g04.gif
    Fig. 2: Location of the CKP sensor connector - 3.0L engine 91044g05.gif
prev.gif next.gif

Nov 05, 2010 | 1993 Cadillac Fleetwood

2 Answers

Firing order for 1989 cadillac fleetwood

For the 1989 Cadillac Fleetwood:
I do not know if you have the Fleetwood Brougham with the 5.0L V8, or the Fleetwood FWD (Front Wheel Drive) with the 4.5L V8; however I have included both below.

For the Fleetwood Brougham 5.0L V8:
Firing Order:

For the Fleetwood FWD (Front Wheel Drive) 4.5L V8
Firing Order:

Let me know if this helped, or if you have additional information or questions. Feel Free to contact me at!

May 19, 2010 | 1989 Cadillac Fleetwood

2 Answers

1996 Cadillac Fleetwood Brougham. First it would not shut down when car was turned off. Had to pull the fuse everytime I turned off the vehicle to save the battery. Now blower does not work at all. Was...

I also had a hard time finding the blower motor resistor on my 1996 Cadillac Fleetwood Brougham 4 door. In my case it was located under the dash clear to the right side on the passenger side (if you are sitting in the passenger seat it would be directly above your right foot). To be super carefull you should disconnect the battery first. Next remove the plastic cover under the entire dash I think it is a 9/32 to remove the cover. You can now see the blower motor,nextto the blower motor is the blower motor speed control module, it plugs into the air duct for cooling, it is held in the duct work by 2 screws, 9/32 I think. here is a paicture of the part so u can id it faster, but remember it is right next to the blower motor.

STANDARD MOTOR PRODUCTS Part # RU546 Price $123.00


Dec 07, 2009 | 1994 Cadillac Eldorado

1 Answer

1996 fleetwood brougham right turn signal will not cancel automatically. What are the steps necessary to dismantle the SIR and steering wheel/column to install a new turn signal part. Is the hazard switch...

You may have the tools, but you should pay particular attention to the warnings about the air bag. That module contains a very powerful explosive that can activate even with all power removed, and can present a very serious hazard during removal to get at the turn signal assembly. I strongly recommend either letting a pro do it, or at least get the GM service manual for the vehicle and follow the instructions very carefully.

Jun 27, 2017 | 1996 Cadillac Fleetwood

1 Answer

1996 Cadillac Fleetwood Brougham Muffler

get your sensors checked before trying to do anything

Apr 27, 2009 | 1996 Cadillac Fleetwood

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

78 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cadillac Experts


Level 3 Expert

80339 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Cadillac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides