Question about 2006 Mitsubishi Galant

Open Question

I need to remove the rear door panel on my 2006

How do I remove the rear door panel on my 2006 mitsubishi galant se

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

fastboyz
  • 674 Answers

SOURCE: galant rear wheel hub

remove your rear wheel then remove the brake assembly. there are 4 bolts that hold the hub to the rear axel with anti lock brakes you will have a wire to remove from the hub. it may tak a large hammer and chisel to remove the hub. but it will come off. then reinstall (if there is any shims behind the hub they must be put back in in the same directions (these are alignment shims) some have some dont. tighten bolts and test drive the ca 5 miles or so. then retighten the lug bolts. and then again after 100 miles.
hope this helps 99116a8.jpg

Posted on Aug 24, 2008

motor1258
  • 6674 Answers

SOURCE: rear strut removal

Check this link & scroll down to 1994-2000 models.

http://www.autozone.com/shopping/repairGuide.htm?pageId=0900c152800382b2

Posted on Jan 31, 2009

  • 6 Answers

SOURCE: Replacing speakers in Mitsubishi Galant

If the car is an 03 galant it is very simple to remove.
DRIVER SIDE:
Remove the window crank if it is not Electric Window.
Remove the Screw that holds the "Open Door Handle" cover.
Remove the Screw that holds the "Pull Handle Pocket"
Remove both plastic covers.
Remove all 3 hidden crews that have a plastic cover over them.
One is toward the front of the door top and the other two are toward the rear of the door top and bottom side.
Carefully pry around the door trim panel to disengage it from th retaining clips, along the sides and bottom. If you have electric windows, disconnect the if from the door trim to access the speaker. Same procedure for both doors.

Posted on Mar 03, 2009

  • 337 Answers

SOURCE: Rear Struts 2003 Mitsubishi Galant

http://www.autozone.com/shopping/repairGuide.htm?pageId=0900c152801d5371

Posted on Mar 03, 2009

  • 295 Answers

SOURCE: how remove the rear inside door panel on a 2001 oldmobile aurora

The inner door panel is held in by clips and screw.
Look at the door near the door handle there should be screws holding it in and along the outer edge of the door. Once loose, and the door handle removed or the arm rest removed. The door panel then prys out , because of the clips that hold it on. Then pops out by applying pressure to the panel upward to the top of the door. The clips always break because of the design and plastic.

Good luck

Posted on Mar 21, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Mitsubishi galant es 1999 power window off track


Did you already removed the door panel? If yes check the track, it could be loose

Mar 30, 2013 | 1999 Mitsubishi Galant ES V6

1 Answer

My rear window has dropped into the door panel how do i get it back up


Look in the yellow pages under auto glass, make an appointment have them take it apart and reinstall it.

Sep 15, 2010 | 2006 Mitsubishi Galant

1 Answer

I need help replacing my 2007 mistubishi galant


To Do what are you trying to do? please explain with just a little more.. Thank You.

Apr 02, 2010 | 2007 Mitsubishi Galant SE Sedan

1 Answer

How do you take the driver side door panel off of a 06 galant


You should find screws in the armrest and plastic push clips evenly spaced around the edge of the door panel. Use a stiff putty knife, slide it between the door panel & the door frame. Slide it left or right until you find the clip and pry up. It will pop out. When you have poped all of the clips out push the entire door panel up to disengage the top from the window edge.

Jan 10, 2010 | 2006 Mitsubishi Galant

1 Answer

Replacing drivers side rear view mirro in Mitsubishi Galant 1997


On the inside trim, you can remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. Then you'll need to manipulate the panel and disconnect the door handle linkage from the door handle and disconnect the wiring for your controls. Then you can access the bolts that secure the mirror onto the door

Apr 04, 2009 | 2007 Mitsubishi Galant SE Sedan

2 Answers

Replacing speakers in Mitsubishi Galant


If the car is an 03 galant it is very simple to remove.
DRIVER SIDE:
Remove the window crank if it is not Electric Window.
Remove the Screw that holds the "Open Door Handle" cover.
Remove the Screw that holds the "Pull Handle Pocket"
Remove both plastic covers.
Remove all 3 hidden crews that have a plastic cover over them.
One is toward the front of the door top and the other two are toward the rear of the door top and bottom side.
Carefully pry around the door trim panel to disengage it from th retaining clips, along the sides and bottom. If you have electric windows, disconnect the if from the door trim to access the speaker. Same procedure for both doors.

Feb 25, 2009 | 2003 Mitsubishi Galant

1 Answer

2004 Mitsubishi Galant window probem


your going to have to remove the door panel. remove the screws and you will iencounter plastic pieces call christmas trees these are a pain but the sell a tool for these at an auto parts store for about 10 bucks. disconnect the plug if you have power windows, if you have manual windows there is a clip that holds the handle on the shaft. use a small screwdriver to remove this. now you can remove the panel awy from the door. this will allow access to the window regulater. you said it sounded like something is loose. check to see if the control arm is disconnected from the lower part of the window. hope this helps

Sep 01, 2008 | 2003 Mitsubishi Galant

Not finding what you are looking for?
2006 Mitsubishi Galant Logo

Related Topics:

376 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts

yadayada
yadayada

Level 3 Expert

75077 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7768 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...