Question about 1986 Ford Thunderbird

1 Answer

Does a 1986 ford thunder bird have a emergency fuel cut off switch?

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 56 Answers

If it is fuel injected, then yes. Probably in the trunk behind a side panel.

Posted on Jun 05, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Emergency fuel shut off valve location 1998 ford windstar and how do you reset it


The fuel shut off is a switch - inertia fuel cut off switch , it cut's electric power to the fuel pump . If it was tripped just push the button ! Located behind- driver side kick panel !
25831256-ndo1tyfldgifo4kgcezu4gls-1-0.jpg

Aug 21, 2015 | 1998 Ford Windstar

1 Answer

Have a 95 ford thunder bird at idle the engine has aalmost like a skipping vibration what could this be pretty sure it's firing on all 8


It sounds like a engine ignition misfire to me, have the plugs and plug wires been replaced? If not replace them taking care to route the plug wires exactly as the factory did, replace any broken loom holders for the plug wires, this is very important.

Sep 03, 2012 | Ford Cars & Trucks

1 Answer

1994 ford thunder bird oil pressure switch location


The 4.6 engine is on the driver's side of the block under the exhaust manifold.

Sep 02, 2012 | Ford Thunderbird Cars & Trucks

2 Answers

Where do i find the external fuel pump on a 1984 fuel injected ford thunderbird? The fuel pump that isn't in the gas tank failed but I don't know where its located I just got the car.


ford expert is incorrect. the 1984 t-birds have a primary and a secondary pump. the primary pump on the fram rail is located in a small housing in front of the rear axel.

Oct 10, 2011 | 1984 Ford Thunderbird

1 Answer

Have 1986 thunderbird 2.3 turbo car runs but when you get on gas cuts out ease up runs fine car has sit for about 5 yrs


this sounds like a fuel flow or supply problem.you may also have a sensor problem that controls the turbo operation under different throttle and load positions for proper operations.i`ve seen turbos impellers seize or not turn freely.these are different areas to check into,note parts for these turbos and supercharged t-birds are hard to find when it comes to components as they only made them for about 3 years.

Apr 16, 2011 | 1986 Ford Thunderbird

1 Answer

My ford thunder bird 1990 well start and run good but after it runs for a while it well turn off


Have a diagnostician check that your fuel pump is operating correctly. Older fuel pumps tend to temporarily "fail" when they warm up, due to pump wear.

Nov 06, 2009 | 1990 Ford Thunderbird

1 Answer

Car will not start


yes there is a fuel pump shut off in the passenger compartment.

Mar 04, 2009 | 1988 Ford Thunderbird

1 Answer

86 t bird


It "won't crank?" Meaning, it won't turn over, or it won't ignite?

If it won't turn over, then it is likely the battery or starter or ignition switch.

If it does crank (turn over) but won't start, and you are specifically not getting any fuel nor spark, then it is likely the hall effect sensor (see "control module" and "pickup coil"). It is two pieces, both on the distributor. Total cost will be around $50 ~ $75 or so.

You'll have to take the distributor out to get to the device, then set timing to complete the job.

--Mark

http://www.marksatterfield.com

Jul 08, 2008 | 1986 Ford Thunderbird

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

103 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

74945 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

fordexpert

Level 3 Expert

5467 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...