Question about Dodge Pickup

1 Answer

31... volts of ac when testing outside metal of motor home .

Posted by on

1 Answer

Look for a short in your wiring. Check all of your cables and harnesses and look for a loose positive wire touching metal somewhere inside or outside your motor home

Posted on May 31, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2004 Isuzu ascender rear fan does not work. tested blower with 12 volts works fine, installed new blower motor resistor no help, could be rear ac controller?


You may have a bad controller. Test for 12 volts coming out of it on the biggest wires. It is usually the culprit. They are in the junk yards and not usually all that expensive.

Jul 02, 2017 | Isuzu Cars & Trucks

1 Answer

Ac blower quit?what switch is the ussaull culprit


What make , model an year vehicle ? Probably blower motor or blower motor resistor or could be a control processor . But those are just guesses . Testing the blower motor electrical circuit is the proper way to a fix . Do you know how to do automotive electrical systems testing using a DVOM - digital volt ohm meter ? How to read an use a wiring diagram to pin point places in a wiring circuit to do testing at ?
Blower Motor Problems Auto Repair Help

How to test blower motor and resistor subscriber requested

Newer vehicles with automatic climate control have a control processor in charge
HVAC Blower Motor Circuit

If you don't know any of this your best bet would be to take to a qualified repair shop .


May 15, 2017 | AC Cars & Trucks

1 Answer

Heater,ac fan wont blow.


Could be the blower motor , The blower motor control switch or a blown fuse , You would need a wiring diagram to test the circuit ! Do you have a DVOM - digital volt ohm meter ! Electric Testing Techniques You Need to Know Do you know how to use A DVOM

Oct 03, 2015 | Cars & Trucks

1 Answer

1996 jeep cherokeecranks no spark on coil or distributer


Test procedure:


1. Test powers and grounds at the Powertrain Control Module (PCM) on the C1 connector. Pins 2 and 22 are power, then check pins 31 and 32 for ground.

2. Next, test the 5 volt power supplies at pin 17 of the C1 connector and pin 31 of the C2 or middle connector for shorts to ground. Sensors on the circuit are the Camshaft Position (CMP) sensor, Crankshaft Position (CKP) sensor, Throttle Position Sensor (TPS), Manifold Absolute Pressure (MAP) sensor and Vehicle Speed Sensor (VSS).

3. Unplug the sensors on the 5 volt power supply, one at a time, while monitoring the 5 volt supply.

4. When the shorted sensor is unplugged, the PCM will wake up and scan tool communication will return.

5. The wiring harness could also be shorted to ground on one of the 5 volt power supply wires. Cut the wires at the PCM on pins C1-17 and just unplug the center connector. Then check for the 5 volts on the PCM of the connector or checking for any continuity to ground with the sensors unplugged at the PCM connector on C1-17 and C2-31 to check the wiring harness

Nov 16, 2013 | Cars & Trucks

1 Answer

No heat,,no ac,no fan,,dont matterwhere i set the heat or ac,temp,does not change


Sounds like a defunt blower motor & or blower motor switch, lots of testing to be done to find which one is the culprit, useage of an ohmns and dc volt meter is necessary as well as a 12 v test light, also look at the condition of the fuse for the heater/a/c located in the under dash fuse panel should be labeled as such.

Aug 12, 2010 | 2000 Mercury Grand Marquis

2 Answers

Heat ac fan quit blowing fuses ok what next?


Hi. You will need to acquire a volt meter, and test the blower motor for proper voltage(12v). If the motor is registering a 12 volt current(at contacts with the switch activated), simply replace the fan motor. If not, replace the fan relay, or resistor switch.

Nov 26, 2009 | 2005 Pontiac Grand Prix

1 Answer

1999 pontiac grand prix gt dual climate control not working prope


The sensor is located near the hood latch area in front of the radiator. If the temp is reading incorrectly, chances are it is defective. You can purchase a new one, they relativly inexpensive.
Disconnect the electrical connector then remove the sensor.
Good luck, let me know.
Regards,

Jun 19, 2009 | 1999 Pontiac Grand Prix

2 Answers

Vent


Get a new blower motor and relay.

Apr 28, 2009 | 2004 Isuzu Rodeo

1 Answer

Blower motor isnt workin still


did you test the motor from an outside 12 volt sorce? or did you plug it in the car wireing? after you got it in and found it did not work, have you test light the power wire for motor in car to see if its got good light or if its weak light. There is a chance you got a bad motor. or its not getting full power from car wireing. I believe thies heating systems work thru the ac systems. i'am gussing is a climent control heating.

Feb 03, 2009 | 1992 Cadillac DeVille

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

14 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

75817 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8180 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...