Question about 1996 Chevrolet K1500

1 Answer

My 1996 4x4 chevy suburban with a vortec engine will not reach operating temperature,I have already replaced the water pump and the thermostat,After I drive it and then I park it I loose anti-freeze thru the reservoir,I have to refill it about every 3 times I use it,it does not matter hoe long I drive it,after I use it and then park it this happens

Posted by on

  • nobuggs May 31, 2010

    Yes this solution was helpful

×

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Chevrolet Master
  • 76,073 Answers

Did you bleed the air out of the cooling system?
if not do this .


The generic method of bleeding air from the cooling system is to use a floor jack and raise the front of the car as high as poss, then fill the coolant recovery tank full and run the engine until it just starts to overheat, high end of normal zone on gauge, then shut the engine down and run cold water over the radiator core, this will self bleed the system and the coolant will be pulled from the recovery tank, repeat as necessary, never let the recovery tank run dry or more air will be pulled into the cooling systeml ,

Posted on May 31, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Replaced radiator in my 2000 VW with 2.0 engine. Water is not flowing


There are two reasons for no water flow.

1. Stuck thermostat
2. Bad water pump

Water will not flow thru the radiator until the engine reaches operating temperature and the thermostat opens. Depending on the vehicle and the ambient temperature, at idle this can take from a few to as many as 10-15 minutes. Just don't let the vehicle overheat as a result of testing.

Nov 20, 2015 | Cars & Trucks

Tip

How to change temperature sender on AUDI 1.9 TDI


The specific location of the sender is on back of cylinder-head near by vacuum-fuel double pump. There is an assurance clip and a rubber sealing O-ring. Heed of antifreeze solution temperature!!!
Before you try to change the sender you must be sure that the sender is out of order. First you must check the thermostat operating. Thermostat checking:
1. Cold engine. Start up the engine and watch of the water temp indicator. After first value 60 Celsius Degree you still warm up the engine until the lifter (pointer) reach 80 C deg. (second mark after 60 C deg.). At this time you let engine running at idle speed and check with your hand the thermostat plastic housing and hose temperature in bottom left side of the engine. Heed of alternator driving belt and ventilator fan !!!
2. If the thermostat is good the hose must be cold until the water temp indicator reach almost 90 C deg.
3. The thermostat opening temperature is 87 C deg.
4. If the hose is already warm the thermostat is out of order.
5. If the thermostat and the temp sender are OK the last piece out of order will be the instrument cluster.

on Dec 19, 2009 | Audi A4 Cars & Trucks

Tip

How to change thermostat on AUDI 1.9 TDI


Heed of antifreeze solution temperature!!!
You must check the thermostat operating. The thermostat location is on back of alternator at the bottom side of the bracket. IMPORTANT: It is NOT necessary to replace the alternator if you want to change the thermostat !!!
Thermostat checking:
1. Cold engine. Start up the engine and watch of the water temp indicator. After first value 60 Celsius Degree you still warm up the engine until the lifter (pointer) reach 80 C deg. (second mark after 60 C deg.). At this time you let engine running at idle speed and check with your hand the thermostat plastic housing and hose temperature in bottom left side of the engine. Heed of alternator driving belt and ventilator fan !!!
2. If the thermostat is good the hose must be cold until the water temp indicator reach almost 90 C deg.
3. The thermostat opening temperature is 87 C deg.
4. If the hose is already warm the thermostat is out of order.
5. If the thermostat and the temp sender are OK the last piece out of order will be the instrument cluster.

on Dec 19, 2009 | Audi A4 Cars & Trucks

1 Answer

1999 chevy vortec running hot


Change the coolant sending unit for the gauge. Usually this is different than the Coolant Temp. Sensor which is for the pcm. Maybe the sending unit is no longer functioning correctly after overheating. Of course, a scanner could show the temperature as recorded by the CTS, or you could use a hand held infrared temperature device to get a better idea of the true temperature.

Jun 09, 2017 | 1999 GMC Sierra

1 Answer

Audi a4 1.9 tdi thermostat diagramm


First time you might check the thermostat operating.

Heed of antifreeze coolant temperature!!!


The thermostat location for a 2000 Audi A4 1.9 TDI is on back of the alternator at the bottom side of the bracket.

IMPORTANT NOTE: It is NOT necessary to replace the alternator if you want to change the thermostat !!!

Thermostat checking:
1. Cold engine. Start up the engine and watch of the water temp indicator. After first value 60 Celsius Degree you still warm up the engine until the lifter (pointer) reach 80 C deg. (second mark after 60 C deg.). At this time you let engine running at idle speed and check with your hand the thermostat plastic housing and hose temperature in bottom left side of the engine. Heed of alternator driving belt and ventilator fan !!!
2. If the thermostat is good the hose must be cold until the water temp indicator reach almost 90 C deg.
3. The thermostat opening temperature is 87 C deg.
4. If the hose is already warm the thermostat is out of order.

Thermostat location, Part number: 044121113, in german - "Kuehlregle" (Price around $25):
tdisline_211.jpg


Important note: Always replace the thermostat round seal, position 7 in the above picture.

Jul 06, 2011 | 2000 Audi A4

1 Answer

Where is the thermostat located on golf v1 1999 1.6,car been standing 6 months worked fine now water not circulating!!!!!!


Heed of antifreeze coolant temperature!!!
First time you might check the thermostat operating.
The thermostat location for VW Golf 1.6 is inside of coolant thermostat housing placed on back side of the cylinder head. See pictures below.
Thermostat checking:
1. Cold engine. Start up the engine and watch of the water temp indicator. After first value 60 Celsius Degree you still warm up the engine until the lifter (pointer) reach 80 C deg. (second mark after 60 C deg.). At this time you let engine running at idle speed and check with your hand the thermostat plastic housing and hose temperature in bottom left side of the engine. Heed of alternator driving belt and ventilator fan !!!
2. If the thermostat is good the hose must be cold until the water temp indicator reach almost 90 C deg.
3. The thermostat opening temperature is 87 C deg.
4. If the hose is already warm the thermostat is out of order.

Thermostat location, Part number: 032121110B, in german - "Kuehlregle" (Price around $20):

tdisline_193.jpg


tdisline_194.jpg
Important note: Always replace the thermostat round seal, position 6 in the above picture.


Please do rate my response. Thanks!


Jan 29, 2011 | 2001 Volkswagen Golf

1 Answer

Where is my thermostat in 2000 jetta 1.9 liter


Heed of antifreeze coolant temperature!!!
First time you might check the thermostat operating.
The thermostat location for VW Jetta 1.9 TDI - AJM engine, is on back of the alternator at the bottom side of the bracket.
IMPORTANT: It is NOT necessary to replace the alternator if you want to change the thermostat !!!
Thermostat checking:
1. Cold engine. Start up the engine and watch of the water temp indicator. After first value 60 Celsius Degree you still warm up the engine until the lifter (pointer) reach 80 C deg. (second mark after 60 C deg.). At this time you let engine running at idle speed and check with your hand the thermostat plastic housing and hose temperature in bottom left side of the engine. Heed of alternator driving belt and ventilator fan !!!
2. If the thermostat is good the hose must be cold until the water temp indicator reach almost 90 C deg.
3. The thermostat opening temperature is 87 C deg.
4. If the hose is already warm the thermostat is out of order.

Thermostat location, Part number: 044121113, in german - "Kuehlregle" (Price around $25):

tdisline_179.jpg


Important note: Always replace the thermostat seal, position 7 in the above picture.

Please do rate my response. Thanks!

Jan 23, 2011 | 2000 Volkswagen Jetta TDI

1 Answer

WHERE IS THERMOSTAT LOCATED ON 2000 VW PASSAT AJM ENGINE


Heed of antifreeze coolant temperature!!!
First time you might check the thermostat operating.
The thermostat location for VW Passat 4Motion 1.9 TDI - AJM engine, is on back of the alternator at the bottom side of the bracket.
IMPORTANT: It is NOT necessary to replace the alternator if you want to change the thermostat !!!
Thermostat checking:
1. Cold engine. Start up the engine and watch of the water temp indicator. After first value 60 Celsius Degree you still warm up the engine until the lifter (pointer) reach 80 C deg. (second mark after 60 C deg.). At this time you let engine running at idle speed and check with your hand the thermostat plastic housing and hose temperature in bottom left side of the engine. Heed of alternator driving belt and ventilator fan !!!
2. If the thermostat is good the hose must be cold until the water temp indicator reach almost 90 C deg.
3. The thermostat opening temperature is 87 C deg.
4. If the hose is already warm the thermostat is out of order.

Thermostat location, Part number: 044121113, in german - "Kuehlregle" (Price around $25):

tdisline_142.jpg
Important note: Always replace the thermostat seal, position 7 in the above picture.

Please do rate my response. Thanks!

Jan 05, 2011 | 2000 Volkswagen Passat 4Motion

1 Answer

Where is the thermostat on an Audi A4 diesel, 1998


Heed of antifreeze solution temperature!!!
You must check the thermostat operating. The thermostat location is on back of alternator at the bottom side of the bracket. IMPORTANT: It is NOT necessary to replace the alternator if you want to change the thermostat !!!
Thermostat checking:
1. Cold engine. Start up the engine and watch of the water temp indicator. After first value 60 Celsius Degree you still warm up the engine until the lifter (pointer) reach 80 C deg. (second mark after 60 C deg.). At this time you let engine running at idle speed and check with your hand the thermostat plastic housing and hose temperature in bottom left side of the engine. Heed of alternator driving belt and ventilator fan !!!
2. If the thermostat is good the hose must be cold until the water temp indicator reach almost 90 C deg.
3. The thermostat opening temperature is 87 C deg.
4. If the hose is already warm the thermostat is out of order.

Feb 22, 2010 | 1999 Audi A4

1 Answer

Water temparature gauge


The specific location of the sender is on back of cylinder-head near by vacuum-fuel double pump. There is an assurance clip and a rubber sealing O-ring. Heed of antifreeze solution temperature!!!
Before you try to change the sender you must be sure that the sender is out of order. First you must check the thermostat operating. The thermostat location is on back of alternator at the bottom side of the bracket. IMPORTANT: It is NOT necessary to replace the alternator if you want to change the thermostat !!!
Thermostat checking:
1. Cold engine. Start up the engine and watch of the water temp indicator. After first value 60 Celsius Degree you still warm up the engine until the lifter (pointer) reach 80 C deg. (second mark after 60 C deg.). At this time you let engine running at idle speed and check with your hand the thermostat plastic housing and hose temperature in bottom left side of the engine. Heed of alternator driving belt and ventilator fan !!!
2. If the thermostat is good the hose must be cold until the water temp indicator reach almost 90 C deg.
3. The thermostat opening temperature is 87 C deg.
4. If the hose is already warm the thermostat is out of order.
5. If the thermostat and the temp sender are OK the last piece out of order will be the instrument cluster.



Oct 10, 2008 | 2000 Audi A4

Not finding what you are looking for?
1996 Chevrolet K1500 Logo

Related Topics:

42 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76070 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8266 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...