Question about 1994 Isuzu Rodeo

1 Answer

Where is the fuse for the blinkers located in a 1994 rodeo

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

  • Expert
  • 41 Answers

Generally the fuse panel will be located under the drivers side dash or a side panel access drivers side of the dash. Open the door of the vehicle and the end of the dash may or may not have an access. If those two locations are not the source of the fuse panel, the passenger side near the floor under the dash is most likely. There is a cover there (not part of the dash itself) but rather just in front of the door opening. Check these areas for the fuse blinkers. Fuse block for engine and such will only be in engine compartment.

Hope this helps!
Chip

Posted on May 31, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do I locate the power window circuit breaker on 1994 Isuzu Rodeo


its in the fuse box under the left side of the steering wheel .open the little door of the fuse box and its on the bottom left side its about 1" long with a little red button in the middle

Oct 17, 2014 | 1994 Isuzu Rodeo

1 Answer

Flasher repair


First, check your bulbs by starting up the vehicle and turning on the blinkers, then go around to check them. Also check to see if your emergency flasher work.
The fuses are either behind the glove box or under the dash on the driver's side.
Look on fixya, someone had the same problem back in April and several ideas were posted.
Good luck!

Jul 01, 2014 | 1995 Isuzu Rodeo

2 Answers

Blinker do not work 1994 Ford Explorer, can it be a fuse, where is the fuse for the blinker


About your 1994 Ford Explorer 4.0L MFI 6cyl. the Flasher is located: Front seating area, driver side, driver side of steering column, behind access panel, mounted on fuse panel (for Turn signal).

Hope this helps.

Oct 05, 2011 | 1994 Ford Explorer Limited

1 Answer

Blinkers


It should either be in your fuse box inside your car but most likely it will be inside the engine compartment in a black box and labeled.

May 27, 2010 | 1997 Isuzu Rodeo

2 Answers

1993 rodeo not running no power to fuel pump


if there is no power to the fuel pump check relays and fuses....UNDERHOOD FUSE & RELAY PANEL IDENTIFICATION Fig. 2: Underhood Fuse & Relay Panel Identification Courtesy of ISUZU MOTOR CO. Fusible Link Identification ? A - 80 Amp (1991-92 3.1L) ? A - 60 Amp Main-1 ? B - 30 Amp Main-2 ? C - 30 Amp (1993-94) ECM (3.2L) ? D - 30 Amp Condenser Fan (A/T Models) Relay Identification ? 1 - Headlight Relay ? 2 - A/C - Heater Relay ? 3 - Starter Relay ? 4 - A/C Compressor Relay ? 5 - Charge Relay ? 6 - Fuel Pump Relay ? 7 - ECM Relay ? 8 - Wiper Relay Fuse & Circuit Breaker Identification ? 1 - 15 Amp (1991) ECM, Fuel Injection System ? 1 - 15 Amp (1992-94 2.6L) ECM, Fuel Injection System ? 1 - 10 Amp (1992-94 3.1 & 3.2L) Heated Oxygen Sensor, Fuel Injection System ? 2 - 20 Amp (1991-92) Fuel Pump ? 2 - 20 Amp (1993-94 2.6L) Fuel Pump ? 2 - 15 Amp (1993-94 3.2L) Fuel Pump ? 3 - 10 Amp (1991) ? 3 - 15 Amp (1992-94) Turn Signal Lights, Hazard Warning Flasher Lights ? 4 - 10 Amp Horn, Door Locks ? 5 - Not Used (1991 3.1L) ? 5 - 10 Amp Charging System, Charge Warning Light WARNING: Always disconnect battery ground cable before servicing "high- current fuses. It is recommended that "high-current" fuses be replaced by a qualified technician. Page 1 of 2 FUSES & CIRCUIT BREAKERS -1994 Isuzu Rodeo LS? 6 - Not Used (1991) (1992-93 2.6L) ? 6 - 10 Amp (1992-94 3.1L & 3.2L) A/T Interlock System ? 6 - 10 Amp (1994 2.6L) Heated Oxygen Sensor, Fuel Injection System ? 7 - 20 Amp Heater/Air Conditioning Blower Controls ? 8 - 10 Amp Air Conditioner Compressor Controls ? 9 - 10 Amp Right Headlight ? 10 - 10 Amp Left Headlight © 2008 Mitchell Repair Information Co., LLC.
62217_isuzfuse_1.jpg
Underhood fuse block swap out relay #7 thats the ECM relay.
Ground Circuits Using a DVOM, touch negative voltmeter lead to a good ground. Touch positive voltmeter lead to each ground terminal. With vehicle running, voltmeter should indicate less than one volt. If reading is greater than one volt, check for open, corrosion and loose connection on ground lead. See ECM GROUND LOCATION table for ECM ground location.
Page 1 of 1 SYSTEM/COMPONENT TESTS - 2.6L EFI -1994 Isuzu Rodeo

Mar 28, 2010 | 1993 Isuzu Rodeo

1 Answer

Blinkers not working


The buzzing sound is probably your relay. It is in your fuse panel and it is what controls how fast your blinkers flash. It is usually a round plastic thing in the fuse panel. and you replace it just as you would a fuse just pull the old one out and push the new one in

Dec 22, 2008 | 1992 Isuzu Rodeo

Not finding what you are looking for?
1994 Isuzu Rodeo Logo

Related Topics:

117 people viewed this question

Ask a Question

Usually answered in minutes!

Top Isuzu Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14384 Answers

Are you an Isuzu Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...