Question about 1999 Dodge Ram

1 Answer

Power window motor replacement, left front - 1999 Dodge Ram

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Habit-Forming:

    Visited the website for 3 consecutive days.

    Governor:

    An expert whose answer got voted for 20 times.

  • Expert
  • 159 Answers

First off check on e-bay for a replacement,then take door panel off,remove plastic from door sometimes I use a hot air gun or blow dryer to heat the tar so plastic won't rip,but if it does use duct tape to repair,then you have to remove the bolts holding the window regulator to door,remove glass from regulator some have metal clips and some you have to turn at an angle to slide the glass off,the whole window regulator assembly will with some trial and error and turning will come out the big hole in the door,also if you have power windows or mirrors be sure to unhook them before pulling door panel out to far.

Posted on May 31, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do you remove the right front door panel on a 2004 buick le saber


Did you test it or are you guessing just because it won't open or close ? How To Install Remove Front Door Panel Buick Lesabre 00 05 1AAuto com both right an left are the same .
Power Windows System Components
The following components are used to control the power windows:
?€¢
Driver Door Module (DDM)


?€¢
Passenger Front Door Module (PDM)


?€¢
LH Rear Door Module (LRDM)


?€¢
RH Rear Door Module (RRDM)


?€¢
Driver Door Switch Assembly (DDSA)


?€¢
RH Front Power Window Switch


?€¢
LH Rear Power Window Switch


?€¢
RH Rear Power Window Switch


?€¢
LH Front Power Window Motor


?€¢
RH Front Power Window Motor


?€¢
LH Rear Power Window Motor


?€¢
RH Rear Power Window Motor


?€¢
Class 2 serial data circuit


?€¢
Power door serial data circuit


?€¢
PWR WDO 30 Amp Circuit Breaker


?€¢
DRVMDL Fuse (10 amp)


Driver Door Switch Assembly and Driver Door Module logic, Driver Door Module internal driver operation


?€¢
PASS MDL Fuse (10 amp)


Front Passenger Door Module logic and internal driver operation


?€¢
RRDR MDL Fuse (10 amp)


Left Rear Door Module and Right Rear Door Module logic and internal driver operation


Do you know about computer controlled power windows ?
Power Windows Operation
The vehicle is equipped with power windows controlled by the door modules. Each passenger door window can be operated, either from a switch built into the driver door switch assembly (DDSA), or from a switch mounted locally to its associated door. The driver door window can be operated only from the driver door window switch built into the DDSA.
When a window is operated from the DDSA, the DDSA interprets the window switch signal as a specific window switch request and sends the information to the driver door module (DDM) via the power door serial data circuit. The DDM examines the request and checks to see if it has received any class 2 serial data messages from any of the other vehicle modules (i.e. ignition switch position) prohibiting the movement of the window. If the window being operated is the driver door window, and if no prohibitive class 2 messages have been received, the DDM then applies voltage and ground to the driver door window motor to move the window glass as requested. If the window being operated is a passenger door window, and no prohibitive class 2 messages have been received, the DDM sends the request, via the power door serial data circuit, to the appropriate passenger door module. The passenger door module then applies voltage and ground to the passenger door window motor to move the window glass as requested.
When a passenger door window is operated from the power window switch mounted locally to its associated door, the passenger door module first checks to see if the DDM has received any prohibitive class 2 serial data messages. If there are no prohibitive messages, the passenger door module powers the associated passenger door window motor.
Both front door windows have the express down feature. This allows the front door windows to be fully opened by momentarily pulling the appropriate window switch lever to the second detente and then releasing.

Oct 30, 2016 | Buick Cars & Trucks

2 Answers

I have a 2000 chevy s10 2wd. Where is the relay switch to my drivers side window. The window switch is and the motor is good. But cant find the relay switch to check it and see if it's bad.


Sorry but there is no relay switch ! Go to www.bbbind.com free wiring diagrams .Check it out ! Your regulator is probably bad ! Is there B+ voltage at the switch , at the motor ?
Left Front Window Switch Operation
Place the ignition switch in the RUN position in order to supply battery voltage to the left front door lock and side window switch through the POWER WINDOW circuit breaker and the CKT 1001 (DK GRN). Press the left front window UP switch in order to supply battery voltage to the left front side window regulator motor through CKT 164 (DK BLU). The window motor is grounded through CKT 165 (BRN) and the window switch DOWN contact.
The regulator motor runs to drive the window to the UP position. Press the DOWN window switch in order to provide battery voltage to the window regulator motor in the opposite direction through CKT 165 (BRN). The window regulator motor is grounded through the CKT 164 (DK BLU) and the window switch UP contact. The motor runs in order to drive the window down.

Aug 22, 2016 | Cars & Trucks

1 Answer

Location of the power window relay in a 1998 cadillac eldorado


http://www.bbbind.com/free_tsb.html free wiring diagrams !
Left Front Power Window Switch
The battery voltage is applied from the WINDOWS circuit breaker through CKT 42 (RED) to the accessory time delay relay. The accessory time delay relay supplies voltage through CKT 70 (PNK) to the left front power window switch under the following conditions:
?€¢
The ignition is in the RUN position.


?€¢
The retained accessory power (RAP) is active.

When an UP switch on the left front power window switch is operated, the battery voltage is applied to the power window motor. The power window motor is grounded through the DOWN contacts of the left front power window switch to G204. The motor runs in order to drive the power window up. When a DOWN switch in the left front power window switch is operated, the battery voltage is applied to the power window motor in the opposite direction. The power window motor is grounded through the UP contacts in the left front power window switch to G204. The motor runs in order to drive the power window down.
Accessory Time Delay Relay
On the left front of the passenger compartment, taped in the body harness

Jun 18, 2016 | 1998 Chevrolet Cavalier

1 Answer

Fix windows they wont go down any more,, fuses look ok


There can be several reasons. When you say you "fixed" the windows, it makes me wonder what was wrong with them before you started. The part inside the door is usually a window regulator. It has teeth to be moved by the gear on the electric window motor. The position of the regulator teeth is suppose to match the position of the window. If you imagine setting the window 1/2 open, then that is as far as the window will rise when the electric window motor cranks. The electric motor gear will only travel so many turns for each cycle of the motor switch.


Mixing motors on the wrong side of the car is something else that can go wrong if you change W motors. The W motors are not the same from front to front or rear to rear. They are often compatible diagonally (right front to left rear) (left front to right rear).


Finally, you can have a switch box for the auto up/auto down feature inside the door panels. You need to check for power at the W motor and then backtrack.

Oct 23, 2014 | 2001 Ford Ka

1 Answer

No power to the left front window 1996 honda crv


Motor works but window doesn't?

Remove the inner door panel & replace
the broken window regulator

Switch over motor to new one

No voltage to switch?

Some other issue?

Nov 24, 2012 | Cars & Trucks

1 Answer

2002 ford windstar Lx van - left door front window is not working


while attempting to opporate the window... bang a little on the doors interior panel in attempt to shake the power window motors brushes to enguage... This will allow you to at least raise the window to the weather until you replace the window regulator motor...

Sep 24, 2010 | 2002 Ford Windstar Cargo

1 Answer

Does anyone know the part number for 2000 Daewoo leganza driver's window power window motor? I have located new motors but the seller doesn't know which motor fits the driver window? If I can get the...


www.daewoous.com has complete breakdown of Daewoo parts. Prices are competitive and they have most in stock. Their diagrams show the motors for front door, left and right as well as back door left and right. Part numbers are listed also.

Jun 19, 2010 | 2000 Daewoo Leganza

1 Answer

Left front door window sometimes will not go back up! When I use either the left front door, window up/down switch, or the driver side up/down control, for the left front door, I can hear the switch...


USUALLY POWER WINDOW PROBLEMS ARE ONE OF THREE THINGS. 1. SWITCH 2. MOTOR 3. WINDOW REGULATOR. THE MOST COMMON PROBLEM THE LEXUS HAS IS THE MASTER SWITCH IN THE DRIVERS DOOR. IT CAN ALSO AFFECT THE OPERATION OF THE PASSENGER DOOR SWITCH....IF WINDOW REGULATOR IS BAD YOU WILL HEAR SOME CRAZY NOISES COMING OUT OF DOOR PANEL...VERY OBVIOUS.... FOLLOW THIS CLOSELY...STARE AT A LITE DOME LIGHT USUALLY WITH DOOR OPEN...WHEN YOU PRESS WINDOW SWITCH, IF THERE IS ANY DIMING OF DOME LIGHT....MOTOR IS BAD. IF DOME LIGHT STAYS THE SAME BRIGHTNESS... SWITCH IS BAD... EXCEPT IN THE CASE SOME HACKER HAS BEEN IN THE DOOR PANEL BEFORE ...IT DOES TAKE A SPECIAL TALENT TO REMOVE DOOR PANELS WITHOUT BREAKING THINGS AND EVEN MORE TALENT TO REPLACE WINDOW REGULATORS

Aug 21, 2009 | 2003 Lexus RX 300

1 Answer

The power window on the front left side is not


Had to replace the switch cluster on ours. Same problem.

Also had problems with passenger side. Motor worked, but the window didn't move. Turned out to be a broken (rusty) cable in the window regulator.

Mar 22, 2009 | 2000 Lincoln Town Car

1 Answer

How to replace window regulator


you will need to drill out some rivets. Replace with ntus and bolts and washers & lock washers. Make sure they don't hit glass going up and down. Otherwise you will need a heavy duty riveter.
please rate as fixya if this helps.

Motor —Front Door
Special Tool(s) swj~us~en~file=st1132a.gif~gen~ref.gif Heavy Duty Riveter
501-D011 (D80L-23200-A) or equivalent
Removal
NOTE: The window regulator and motor are removed as an assembly.
  1. Remove the front door trim panel. For additional information, refer to Section 501-05 .
  1. Remove the front door radio speaker.
  1. Remove the latch remote control. For additional information, refer to Section 501-14A .
  1. Remove the front door watershield.
  1. swj~us~en~file=ani_caut.gif~gen~ref.gif CAUTION: Support the window glass to avoid damage.
    Raise and support the front door window glass to the full up position.
  1. Disconnect the power window motor electrical connector.
  1. Remove the window glass to regulator nuts.
  1. Remove the motor and window regulator assembly.
    1. Drill out the rivets.
    1. Remove the motor and window regulator assembly.
88565ca.gif
  1. NOTE: Prior to motor removal, make sure the regulator arms are in a fixed position to prevent counterbalance spring unwind.
    Remove the power window motor.
    1. Remove the bolts.
    1. Remove the power window motor.

Mar 21, 2009 | 1998 Ford Expedition

Not finding what you are looking for?
1999 Dodge Ram Logo

178 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8210 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...