Question about 1994 Chevrolet S-10

1 Answer

No Power at Takeoff

Purchased a Used Chevy-S-10 4 X 4 LS automatic Pickup truck and at times starting out it has no power and the RPM's go above 3 doing about 20 mph I already changed the fuel pump and filter does this sound like a transmission problem?

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 10,319 Answers

If the trans runs at 20 mph with a rpm factor of 3000 plus yes the trans is shot

Posted on May 31, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What is the correct power steering fluid type for 95 chevy blazer LS?


you can get any kind of power steering fluid there is no certain one you need

Jan 25, 2010 | 1998 Chevrolet S-10 Pickup

1 Answer

I have a 91 chevy s-10 pickup the truck has a starting


If its an automatic chk. for bad starter switch under dash, if its a standard shift chk. the clutch switch witch is under the dash too.

Aug 17, 2009 | 1991 Chevrolet S-10 Blazer

1 Answer

Keyless entry wont work 2002 chevy s10 LS


try this procedure to reporgram:

1. Close all vehicle doors.

2. Insert the key into the ignition.

3. Hold down the power UNLOCK button on the driver's continue to hold down until instructed
to release in step 9.

4. Perform steps 5 through 8 in fairly rapid succession.

5. Turn the key to the ON position (as far as you can go without starting the engine).

6. Turn the ignition switch to the OFF position.

7. Turn the ignition switch to the ON position.

8. Turn the ignition switch to the OFF position.

9. Release the power unlock button on the door panel. The vehicle will lock and unlock the doors automatically.

10. Hold down the LOCK and UNLOCK buttons on the transmitter simultaneously until the vehicle locks and unlocks.
This step may take up to 30 seconds.

11. Repeat step 10 NOW for each additional transmitter (including any existing transmitters).

12. Turn the ignition switch to the ON position in order to exit the transmitter programming mode

Jun 30, 2009 | 2002 Chevrolet S-10

1 Answer

Fuel issue 1985 pickup


did you change the pump with gauge cluster may have put bad pump in. some gauge clusters have built in pumps

Aug 16, 2017 | 1985 Chevrolet Chevy

1 Answer

All Accessories will quit working while driving 2002 Chevy Z71


Hello;
It sounds as if the main power lead could be loose powering the dash. There are several main power blocks, make sure your connections are clean and tight. I have seen the circuit board for the dash fail but not often. Hope this helps.
Thanks;
Rich
RPM Northwest

Jan 27, 2009 | 2002 Chevrolet Silverado

Not finding what you are looking for?
1994 Chevrolet S-10 Logo

174 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76673 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8531 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...