Question about 1992 Oldsmobile Cutlass Ciera

1 Answer

How do i replace the spark plug wires on my '92 cutlass cierra. The wires don't easily pull off of the plugs. Is there a trick to it?

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Oldsmobile Master
  • 14,036 Answers

USE SPARK PLUG WIRES BOOT PULLER ANY AUTO PARTS STORES CARRY THEM.

Posted on May 31, 2010

Testimonial: "Good answer! Thanks! But how how i get the wires out of the plastic chase wedged between the front of the engine and what looks like a motor mount?"

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 1991 cutlass cierra oldsmobile is not firing. i replaced the fuel filter fuel pump and the crank shaft sensor. After that it did start up now it is doing the same thing as before just turning over but...


Hello,

Pull a spark plug wire and put a screw driver in the boot and lay it next to something steel on the engine, do you have a spark?

If so pull a spark plug and see if it is wet, like water wet. Are you low on coolant or loosing it?

These engines have a intake fail issue, the upper intake will not can, but will leak, when it dose it sends coolant down the intake and wets the spark plugs. Crank the engine over a few times before doing this.


The best way to know for sure is to remove the Throttle Body and look inside the intake with a flashlight.

You may be able to get away with removing the screen from the Throttle body with snap ring pliers and opening the butterfly and looking in, but that mesh is very hard to remove and install.

Good luck

Dec 29, 2010 | 1991 Oldsmobile Cutlass Supreme

1 Answer

Do I need to remove the tensioner to remove the alternator on a '92 cutlass cierra? If so what size is the bolt that attaches it?


No, you just need to loosen the belt and take it off the alternator. Then the two bolts that mount it and unclip the plug and unbolt the other wire.

Aug 07, 2010 | 1992 Oldsmobile Cutlass Ciera

1 Answer

I have a misfire on cylinder 2 for an oldsmobile 6cylinder 96


i had one on # 4 and it was the spark plug wire, pull it out of the coil and if it is dark and rusty and not clean you need new plug wires

Jul 26, 2010 | 1996 Oldsmobile Cutlass Ciera

1 Answer

Removing spark plug wires on 92 cutlass cierra s


Since it is a 1882 the plastic is old and brittle so expect it to break in pieces. Just pry the seams away from one another after the engine is hot. That may keep it from rteaking

May 31, 2010 | 1992 Oldsmobile Cutlass Ciera

2 Answers

1993 cutlass cierra spark plugs get black


That could be a sign of rich burn,have the vacuums checked for leakage,and have the codes read to see if a sensor is bad,,posibilities,are,map sensor,or mass air flow,or a bad pressure regulator.

Feb 25, 2010 | 1993 Oldsmobile Cutlass Ciera

2 Answers

1988 3.8 olds cutlass Ciera stalls, no spark until it cools down


Check the prrimary and secondary resistance on your coil. Also check the resistance of the plug wires and plug gap.

Aug 12, 2009 | 1988 Oldsmobile Cutlass Ciera

1 Answer

How do i install a ignition model into a 92 Cutlass Ciera


On v-6 it is in the front, tight working area. unplug wiring, remove spark plug wires(mark them for proper order for assembly) unbolt from engine coil packs and remove module, install module(with a little diealetric) and reverse for install.

May 22, 2009 | 1992 Oldsmobile Cutlass Ciera

1 Answer

92 olds ciera won't start


Johnny, It's probably the coil pack. If you follow the spark plug wires backwards from the plugs it will lead you to the part(s). There may be more than one. Check with the local autoparts place to see if they can test it for you. If not I would try a Junk yard first, incase that isn't the problem.

Apr 01, 2009 | 1992 Oldsmobile Cutlass Ciera

3 Answers

92olds cutlas cierra, 3.3 liter


how do you check your coils is there a photo that shows you how? or a video, web site




Jun 26, 2008 | 1992 Oldsmobile Cutlass Ciera

Not finding what you are looking for?
1992 Oldsmobile Cutlass Ciera Logo

387 people viewed this question

Ask a Question

Usually answered in minutes!

Top Oldsmobile Experts

yadayada
yadayada

Level 3 Expert

75066 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7754 Answers

Are you an Oldsmobile Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...